针对 ZM6铸造镁合金，为获得综合性能优异的陶瓷膜层，在硅酸钠和氢氧化钠的碱性溶液中，用双向脉冲电源进行微弧氧化处理。采用环境扫描电镜（SEM）、X 射线衍射（XRD）研究陶瓷膜层微观形貌及组成，采用拉伸法、中性盐雾试验、轴向加载疲劳试验等方法研究附着力、耐蚀性及疲劳性能等。结果表明：陶瓷膜层大致由表层疏松层、中间致密层以及内部过渡层组成，表层疏松多孔，过渡层与基体紧密结合。陶瓷层与基体结合好，附着力大于50MPa；微弧氧化处理后，大幅度提高合金耐腐蚀性能，中性盐雾大于336h；陶瓷膜层使基体疲劳性能降低18％。
Micro-arc oxidation (MAO)process on ZM6 Mg alloy was carried out in a dual electrolyte system of sodium silicate and sodium hydroxide alkalescent solution.The microstructure characteris-tics of coatings were investigated by scanning electron microscopy (SEM)and X-ray diffraction (XRD).The performance of adhesion,corrosion resistance and fatigue was evaluated by dynamic stretch training,neutral salt spray test and axial loading fatigue test.The results show that MAO coating consists of three layers,outer layer,medial layer and inner layer.The outer layer is porous and loose,however the inner layer has good bond strength with substrate,which is above 50MPa. The MAO coating can improve corrosion resistance of substrate significantly.The neutral salt spray test is above 336 h.Compared with the sample without MAO coating,the reduction of fatigue is a-bout 18%.
参考文献
| [1] | MORDIKE B L;EBERT T .Magnesium properties applications-potential[J].MATERIALS SCIENCE & ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING,2001,302(02):37-45. |
| [2] | Z.Yaug,J.P.Li,J.X.Zhang,G.W.Lorimer,J.Robson.REVIEW ON RESEARCH AND DEVELOPMENT OF MAGNESIUM ALLOYS[J].金属学报(英文版),2008(05):313-328. |
| [3] | 薛文斌,邓志威,来永春,陈如意,张通和.有色金属表面微弧氧化技术评述[J].金属热处理,2000(01):1-3. |
| [4] | 曾爱平,薛颖,钱宇峰,王志杰,黄元伟,陈英.镁合金的化学表面处理[J].腐蚀与防护,2000(02):55-56,63. |
| [5] | 蒋百灵,张淑芬,吴国建,雷廷权.镁合金微弧氧化陶瓷层显微缺陷与相组成及其耐蚀性[J].中国有色金属学报,2002(03):454-457. |
| [6] | 薛文斌;邓志威;来永春 等.镁合金微等离子体氧化膜的特性[J].材料科学与工艺,1997,5(02):89-92. |
| [7] | 郭洪飞,安茂忠,徐莘,霍慧彬.镁合金微弧氧化工艺条件对陶瓷膜耐蚀性的影响[J].材料工程,2006(03):29-32,36. |
| [8] | 电压对AZ31镁合金微弧氧化涂层微观结构及腐蚀性能的影响[J].中国表面工程,2012(06):21-28. |
| [9] | 杨培霞,郭洪飞,安茂忠,吴丽军.镁合金表面微弧氧化陶瓷膜耐蚀性能评价[J].航空材料学报,2007(03):33-37. |
| [10] | 赵晴,胡勇,杜楠.氧化时间对MB8镁合金微弧氧化膜的影响[J].航空材料学报,2007(06):55-58. |
| [11] | 翟彦博,陈红兵,马秀腾.AZ31B镁合金微弧氧化电解液温度对膜组织与性能的影响[J].材料保护,2013(04):16-18,22. |
| [12] | 蒋百灵,张淑芬,吴国建,雷廷权.镁合金微弧氧化陶瓷层显微缺陷与相组成及其耐蚀性[J].中国有色金属学报,2002(03):454-457. |
| [13] | 夏琦兴,姚忠平,张亚军,李梁梁,姜兆华.镁合金微弧氧化陶瓷膜的组织结构及耐腐蚀性能[J].材料保护,2011(05):14-16. |
| [14] | LONYUK B;APACHITEI I;DUSZCZYK J .The effect of ox-ide coatings on fatigue properties of 7475-T6 aluminium alloy[J].Surface and Coatings Technology,2007,201(21):8688-8694. |
| [15] | 文磊,王亚明,周玉,王长利,郭立新,欧阳家虎.LY12铝合金微弧氧化涂层组织结构对基体疲劳性能的影响[J].稀有金属材料与工程,2009(z2):747-750. |
| [16] | 梁戈,张亚娟,林敏.微弧氧化处理LD10铝合金的疲劳特性[J].材料热处理学报,2010(02):123-127. |
- 下载量()
- 访问量()
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%