采用数值模拟方法研究了水口内钢水流场形态及各种因素对水口沉积速率的影响.模拟结果表明:滑板附近处以及水口底部的沉积比其它地方更为明显;吹氩量对水口内的压力存在较大的影响,压力在滑动水口处存在突降;滑动水口开度为66.45%时,浇铸速度为1.2 m/min的情况下,要防止吸气,最小吹氩量必须大于10 L/min.Al2O3的沉积速率与其浓度成线性增加关系;随着浇铸速度的提高,沉积速率也逐步增大.在吹氩量合适的范围内,吹氩能够降低沉积速率.对于同一拉速,5和30 L/min的吹氩量对降低沉积速率的效果相近.
参考文献
| [1] | Feng X M,Ping Z F,Jiang M X,Ji B K.Refract Mater,2002; 36(2):83(冯秀梅,平增福,蒋明学,姬保坤.耐火材料,2002;36(2):83) |
| [2] | Rob D,Bart B,Partick W.Steel Res,2003; 74:351 |
| [3] | Alavanja M,Gass R T,Kittridge R W,Tsai H T.Steelmaking Conf Proc,1995; 78:415 |
| [4] | Thomas B G,Hua B.Steelmaking Conf Proc,2001; 84:895 |
| [5] | Rackers K G,Thomas B G.Steelmaking Conf Proc,1995;78:723 |
| [6] | Meadowcroft T R,Milbourne R J.J Met,1971; (6):11 |
| [7] | Schmidt M,Russo T J,Bederka D J.Steelmaking Conf Proc,1990; 73:451 |
| [8] | Sasaka I,Harada T,Shikano H,Tanaka I.Steelmaking Conf Proc,1991; 74:349 |
| [9] | Tsai H T,Sammon W J,Hazelton D E.Steelmaking Conf Proc,1990; 73:49 |
| [10] | Burty M.PTD Conf Proc,1995:287 |
| [11] | Launder B E,Spalding D B.Comput Method Appli Mech Eng,1974; 3:269 |
| [12] | Yu H X,Zhu G S,Wang X H,Zhang J M,Wang W J.J Univ Sci Technol Beijing,2005; 12:303 |
| [13] | Castillejos A H,Salcudean M E,Brimacombe J K.Metall Trans,1989; 20B:603 |
| [14] | Zhang X Z.Transmission Theory of Metallurgy.Beijing:Metallurgical Industry Press,1988:427 |
| [15] | Chakraborty S,Sahai Y.Metall Trans,1992; 23B:153 |
| [16] | Bai H,Thomas B G.Steelmaking Conf Proc,2000; 83:183 |
上一张
下一张
上一张
下一张
计量
- 下载量()
- 访问量()
文章评分
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%