研究了不同热处理制度下得到的3种具有不同晶粒尺寸的42CrMoVNb高强度钢的超高周疲劳性能.结果表明,超高周疲劳强度和疲劳强度比并不随晶粒尺寸的减小而单调提高,中等晶粒尺寸的试样具有最高的疲劳强度和疲劳强度比.SEM断口观察表明,绝大部分试样的疲劳裂纹起源于夹杂物.随着疲劳断口裂纹源夹杂物处应力强度因子幅△Kinc的减小,疲劳寿命Nf增加;而在夹杂物周围的粗糙粒状区域(GBF)的应力强度因子幅△KGBF并不随Nf变化而变化,基本为一常数,且粗晶粒试样的△KGBF高于细晶粒试样.这表明,细化晶粒对高强度钢的超高周疲劳性能有着复杂的影响,存在一个合理的细化晶粒范围.
For low and medium strength steels,grain size has significant effects on their fatigue properties,whereas non-metallic inclusion has no or little efrect.In previous work.the effects of grain size on high-cycle fatigue fracture behaviors of 42CrMoVNb high strength steel were studied and illustrated that grain refining has a complicated influence on its fatigue properties.In this paper, the ultra-high-cycle fatigue properties of 42CrMoVNb high strength steel with three kinds of prior austenite grain sizes produced by different heat treatment procedures were studied.Experimental results show that both fatigue strength and fatigue strength ratio don't increase monotonically with the decrease of gain size,and fairly better fatigue properties could be obtained at a medium grain size Of 15 μm.SEM observations of fatigue fracture surface reveal that most of fatigue cracks initiated from inelusions and a granular bright facet(GBF)Was found in the vicinity around inclusion at cycles beyond about 1×106.Further investigation shows that the stress intensity factor range at crack initiation site of inclusion △Kinc trends to decrease gradually with increasing the fatigue life Nf,while the stress intensity factor range at GBF boundary △KGBF keeps almost constant with varying Nf.△KGBF of coarse grain size iS higher than that of fine grain size.It could conclude that the effect of grain size on ultra-high-cycle fatigue properties is rather complicated and an appropriate size of prior austenite might be existed.
参考文献
| [1] | Weng Y Q.Ultra-Fine Steel-Strengthening Theory of Mi-erostructure of Steel and Control Technology.Beijing:Metallurgical Industry Press,2003:9(翁宇庆.超细晶钢-钢的组织强化理论与控制技术.北京:冶金工业出版社,2003:9) |
| [2] | Burke J J,Weiss V,translated by Wang Y W,Zhang YC.Ultrafine-Grain Metals.Beijing:National DefeIlse In-dustry Press,1982:214(Burke J J,Weiss V著,王燕文,张勇昌译.超细晶粒金属.北京:国防工业出版社,1982:214) |
| [3] | Kage M,Miller K J,Smith R A.Fatigue Fract Eng Mater Struct,1992;15:763 |
| [4] | Nie Y H,Hui W J,Fu W T,Weng Y Q,Dong H.Acta Metall Sin,2007;43:1031(聂义宏,惠卫军,傅万堂,翁宇庆,董瀚.金属学报,2007;43:1031) |
| [5] | Zhang J M,Li S X,Yang Z G,Li G Y,Hui W J,Weng YQ.Int J of Farigwe,2007;29:765 |
| [6] | Zhang J M,Yang Z G,Li S X,Li G Y,Hui W J,Weng YQ.Acta Metall Sin,2006;42:259(张继明,杨振国,李守新,李广义,惠卫军,翁宇庆.金属学报,2006;42:259) |
| [7] | Abe T,Furuya Y,Matsuoka S.Fatigue Fract Eng Mater Struct,2004;27:159 |
| [8] | Murakami Y,Yokoyama N,Nagata J.Fatigue Fract Eng Mater Struet,2002;25:735 |
| [9] | Wang Q Y,Berard J Y,Duharre A,Baudry G,Rathery S,Bathias C.Fatigue Fkact Eng Mater Struct,1999;22:667 |
| [10] | Wang X S,Liang F,Zeng Y P,XJe X S.Acta Metall Sin,2005;41:1272(王习术,梁锋,曾燕屏,谢锡善.金属学报,2005;41:1272) |
| [11] | Chapetti M D,Miyata H,Tagawa T,Miyata T,Fujioka M.Int J Fatigue,2005;27:235 |
| [12] | Kim H K Choi M Ⅱ,Chung C S,Dong H S.Mater Sci Eng,2003;A340:243 |
| [13] | Nomura I,1wama N.Tetsu Hagane,1998;84:31(野村一卫,岩间直树.铁と钢,1998;84:31) |
| [14] | Masounave J,Bailon J P.Scr Metall,1976;10:165 |
| [15] | Yang Z G,Zhang J M,Li S X,Chu Z M,Hui W J,Weng Y Q.Acta Metall Sin,2004;40:367(杨振国,张继明,李守新,褚作明,惠卫军,翁宇庆.金属学报,2004;40:367) |
| [16] | Hui W J,Dong H,Wang M Q,Chen S L,Weng Y Q.J Met Heat Treat,2002;27(3):14(惠卫军,董瀚,王毛球,陈思联,翁宇庆.金属热处理,2002;27(3):14) |
| [17] | Hui W J,Nie Y H,Dong H,Weng Y Q,Wang C X.JMater Sci Technol,2008;24:787 |
| [18] | Murakami Y,Kodama S,Konuma S.Trans JSME,1988;54A:688(村上敬宜,兄玉昭太郎,小沼静代.日本机械学会论文集,1988;54A:688) |
| [19] | Zhao H M,Hui W J,Nie Y H,Weng Y Q,Dong H.Chin J Mater Res,2008;22:526(赵海民,惠卫军,聂义宏,翁宇庆,董瀚.材料研究学报,2008;22:526) |
| [20] | Ochi Y,Matsurnura T,Masaki K,Yoshida S.Fatigue Fract Eng Mater Btruct,2002;25:823 |
| [21] | Sakai T,Sato Y,Oguma.Fatigue Fract Eng Mater Struct,2002:25:765 |
| [22] | Hong Y S,Fang B.Adv Mech,1993;23:468(洪友士,方飚.力学进展,1993;23:468) |
| [23] | Wang Q Y,Berard J Y,Rathery S,Bathias C.Fatigue Fract Eng Mater Struct,1999;22:673 |
| [24] | Murakami Y,Nomoto T,Ueda T.Fatigue Fbzct Eng Mater Siruct,1999;22:581 |
| [25] | Hui W J,Dong H,Weng Y Q,Shi J,Nie Y H,Chu Z M,Chen Y B.Acta Metall Sin,2004;40:561(惠卫军,董瀚,翁宇庆,时捷,聂义宏,褚作明,陈蕴博.金属学报,2004;40:561) |
| [26] | Yll D G,Tan Y X.Microstructure and Strengtheningof Steel-Relationship of Microstructure and Strength and Toughness.Shanghai:Shanghai Scientific and TechnicalPress,1983:290(俞德刚,谈育煦编著.钢的组织强度学--组织与强韧性.上海:上海科学技术出版社,1983:290) |
| [27] | Kuhlmann-Wilsdorf D,Thomason P F.Acta Metall,1982;30:1243 |
- 下载量()
- 访问量()
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%