研究了Ni50.2Ti49.8合金在5种不同预应变(1.96%,3.96%,5.88%,7.85%,9.96%)下的回复应变和逆相变温度;恒定预应变5.88%下,热机械循环对回复应变和逆相变温度的影响.结果表明:预应变使得逆相变温度升高,预应变越大逆相变温度越高.随着预应变的增加回复应变增加,预应变增加到一定程度时回复应变达到最大值,随后回复应变随预应变增加而减少.恒定预应变下热机械循环,随循环次数增加,逆相变温度下降,回复应变减少,随着循环次数进一步增加,逆相变温度和回复应变逐步达到稳定值.
参考文献
| [1] | Otsuka Kasuhiro;Ben Xiaobing .Recent developments in the research of shape memory alloys[J].INTERMETALLICS,1999,7:511. |
| [2] | 赵连城,郑玉峰.形状记忆与超弹性镍钛合金的发展和应用[J].中国有色金属学报,2004(z1):323-326. |
| [3] | Song G;Ma N;Li H N .Application of shape memory in civil structures[J].Engineering Structures,2006,28:1266. |
| [4] | Z.W. Zhong;S.Y. Chan .Investigation of a gripping device actuated by SMA wire[J].Sensors and Actuators, A. Physical,2007(1):335-340. |
| [5] | Dominiek Reynaerta;Hendrik Van Brussel .Design aspects of shape memory actuators[J].Mecliatronics,1998,8:635. |
| [6] | Millet David A;Lagnudas Dimitris C .Influence of cold work and heat treatment on the shape memory effect and plastic strain development of NiTi[J].Materials Science and Engineering A:Structural Materials Properties Microstructure and Processing,2001,308:161. |
| [7] | Sadmezhaad S K;Mirabolghasemi S H .Optimum temperature for recovery and recrystallization d 52Ni48Ti shape memory alloy[J].Materials & Design,2007,28(06):1945. |
| [8] | 贺志荣.不同热处理态Ti-50.2Ni形状记忆合金的相变特性[J].中国有色金属学报,2007(02):233-238. |
| [9] | Kim J I;Liu Yinong;Miyazaki S .Ageing-induced two-stage Rphase transformation in Ti-50.9% Ni[J].Acta Materialia,2004,52:487. |
| [10] | Piao Min;Otsuka Kasuhiro;Miyazaki Shuichi;Horikawa Hiroshi .Mechanism of the As temperature increase by pre-deformation in thermoelastic alloys[J].Materials Transactions-Japan Institute of Metals,1993,34(10):919. |
上一张
下一张
上一张
下一张
计量
- 下载量()
- 访问量()
文章评分
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%