采用盐水浸泡实验研究了铸态(F)、固溶(T4)和250℃下不同时效时间的Mg-10Gd-3Y-0.4Zr镁合金在5%NaCl溶液中的腐蚀行为.结果表明,时效时间为193小时之前,合金的腐蚀速率随时效时间增加而增加,之后有所降低;T4态合金的耐蚀性最好,F态最差.合金腐蚀速率随热处理状态的变化与其微观组织有关,F态合金中的富RE化合物能与基底α相构成电偶腐蚀而加剧合金腐蚀;峰值时效状态下合金中的β'和β1相不能作为腐蚀阻挡层,而过时效状态下连续分布的β相能在一定程度上起腐蚀阻挡层作用,降低合金腐蚀速率.
参考文献
[1] | Smola B,Stuliikovai I,Buch F,et al.Structural aspects of high performance Mg alloys design[J].Mater.SOi.Eng.A,2002,324(1-2):113. |
[2] | Vostryi P,Smola B,Stuliikovai I,et al.Mierestrueture evolution in isochronally heat treated Mg-Gd alloys[J].Phys.Stat.Sol.A,1999,175(2):491. |
[3] | He S M,Zeng X Q,Peng L M,et al.Precipitation in a Mg-10Gd-3 Y-0.4Zr(wt.%) alloy during isothermal ageing at 250℃[J].J.Alloys Comp,2006,421 (1-2):309. |
[4] | Chang J W,Guo X W,Fu P H,et al.Effect of heat treatment on corrosion and electrochemical behaviour of Mg-3 Nd-O.2Zn-0.4Zr (wt.%)alloy[J].Electrochimica Acta,2007,52(9):3160. |
[5] | Lunder O,Lein J E,Aune T K,et al.The role of Mg17 Al12 phase in the corrosion of Mg alloy Azgl[J].Corrosion,1989,45 (9):741. |
[6] | Ambat R,aung N N,Zhou W.Evaluation of microstructure effects on corrosion behaviour of AZ91D magnesium alloy[J].Corros.Sci,2000,42:1433. |
上一张
下一张
上一张
下一张
计量
- 下载量()
- 访问量()
文章评分
- 您的评分:
-
10%
-
20%
-
30%
-
40%
-
50%