利用ANSYS软件建立冷坩埚连续熔铸过程的数学模型,计算在近矩形冷坩埚连续熔铸过程中冷坩埚内的磁感应强度,分析负载和电流强度变化对钛合金连续熔铸与定向凝固过程冷坩埚内磁感应强度的影响.结果表明:钛合金物料的加入并没有影响轴向磁感应强度的空间分布趋势;轴向磁感应强度在感应线圈与坩埚所包围的区域内聚集分布,且在感应线圈内壁中点处其强度达到最大值,并随着与内壁距离的增加逐渐衰减;磁感应强度随着输入电流的增加线性增大.
A model with a near rectangular cold crucible system was based by applying ANSYS software. The magnetic intensity distributions inside the crucible were simulated during cold crucible continuous melting and directional solidification. The effects of titanium alloys and input current on the magnetic intensity distributions in the crucible were analyzed. It is found that adding titanium alloys doesn't affect the axial magnetic intensity distributions inside the crucible. The distributions of magnetic field are non-uniform across the defined calculation region. The magnetic field mainly acts on the slit area of the crucible, especially the density of electromagnetic force of the area surrounded by the coil and the crucible apparently higher than other positions. After the Ti6Al4V ingots are placed in the cold crucible, the original lines of magnetic force of hollow area in the crucible turns to concentrate on the surface of the ingots and aggregates in the region of ingot's melting and melt hump's electromagnetic confinement shaping. And the increase of input current causes the increase of magnetic intensity.
参考文献
| [1] | ZHOU Y Z;VOLEK A .Effect of grain boundary fraction on castability of a directionally solidified nickel alloy[J].Scripta Materialia,2006,54:2169-2174. |
| [2] | 鲁世强,黄伯云,贺跃辉,唐建成,张俊红.TiAl基合金的超塑性变形机理[J].稀有金属材料与工程,2003(07):481-485. |
| [3] | S. Malinov;W. Sha .Application of artificial neural networks for modelling correlations in titanium alloys[J].Materials Science & Engineering. A, Structural Materials: Properties, Microstructure and Processing,2004(1/2):202-211. |
| [4] | D. Hu .Effect of boron addition on tensile ductility in lamellar TiAl alloys[J].Intermetallics,2002(9):851-858. |
| [5] | 王艳丽,丁宏升,毕维生,郭景杰,傅恒志.钛合金定向凝固用矩形电磁冷坩埚内的磁场分布特性[J].稀有金属材料与工程,2006(10):1597-1601. |
| [6] | 傅恒志.高熔点大比重合金真空电磁约束成形[M].西安:西安工业出版社,2001 |
| [7] | 王艳丽,郭景杰,傅恒志.钛合金冷坩埚定向凝固过程温度场数值模拟[J].哈尔滨工业大学学报,2008(11):1808-1810. |
| [8] | Darning Xu;Yunfeng Bai;Jingjie Guo;Hengzhi Fu .Numerical simulation of heat, mass and momentum transport behaviours in directionally solidifying alloy castings under electromagnetic fields using an extended Direct-SIMPLE scheme[J].International Journal for Numerical Methods in Fluids,2004(7):767-791. |
| [9] | R. BOHN;T. KLASSEN;R. BORMANN .ROOM TEMPERATURE MECHANICAL BEHAVIOR OF SILICON- DOPED TiAl ALLOYS WITH GRAIN SIZES IN THE NANO-- AND SUBMICRON-RANGE[J].Acta materialia,2001(2):299-311. |
- 下载量()
- 访问量()
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%