本文采用数值模拟的方法对某低速压气机静叶流道内的流动结构进行了研究。设计工况下,带根部间隙的静叶流道中主要存在三个大尺度旋涡结构,分别为上通道涡、刮削涡和集中脱落涡,这些涡系在生成和发展过程中相互作用,流道内总奇点数先增加后减小,但都严格遵循了流道奇点数拓扑法则。
Numerical investigation of flow structure was done in a low speed axial compressor's stator passage. There are three large vortexes exist in the stator passage with blade hub tip at design condition. They are the passage vortex at up side, the scraping vortex near hub tip and the concentrated shed vortex. These vortexes interact each other at their generation and development proceeding. The total number of singular points increases at first and decreases at last. But it obeys the rule of singular points number in the passage.
参考文献
[1] | 周逊,韩万金.涡轮矩形叶栅中的旋涡模型的进展回顾[J].航空动力学报,2001(03):199-204,198. |
[2] | 陈浮,陆华伟,顾中华,王仲奇.轴向间隙对压气机时序效应影响之一:总性能[J].工程热物理学报,2007(02):232-234. |
上一张
下一张
上一张
下一张
计量
- 下载量()
- 访问量()
文章评分
- 您的评分:
-
10%
-
20%
-
30%
-
40%
-
50%