通过示差扫描量热分析确定了Zr55Al10Ni5Cu30大块非晶合金的过冷温度区域范围,采用应变速率突变压缩实验分析了合金在450℃时的力学性能,研究了合金在不同挤压速度、不同真空度等工艺条件下的挤压成形性能.结果表明:Zr55Al10Ni5Cu30大块非晶合金的玻璃化转变开始温度Tg为422.4℃,晶化开始温度Tx为482.4℃;在450℃、应变速率小于5×10-3s-1的条件下,合金的流动应力小于40 MPa在挤压速度为0.002～0.004mm/s范围内挤压时,合金的最大挤压载荷变化较小;在挤压温度为450℃时,合金的最大挤压力随着真空度(2～2×10-3Pa)的提高而增加;大块非晶合金在超塑性成形时呈现出比一般金属材料更大的摩擦阻力.
参考文献
| [1] | Inoue A .High strength bulk amorphous alloys with low critical cooling rates[J].Materials Transactions,1995,36(10):867-875. |
| [2] | Fecht H J .Thermodynamic properties of amorphous solids-glass formation and glass transition[J].Materials Transactions,1995,36(07):777-793. |
| [3] | 何国;陈国良 .大块非晶合金射流成形方法的研究[J].材料科学与工艺,1998,6(03):105-108. |
| [4] | Akihisa Inoue;Tao Zhang .Stabilization of supercooled liquid and bulk glassy alloys in ferrous and non-ferrous systems[J].Journal of Non-Crystalline Solids: A Journal Devoted to Oxide, Halide, Chalcogenide and Metallic Glasses, Amorphous Semiconductors, Non-Crystalline Films, Glass-Ceramics and Glassy Composites,1999(Pt.2):552-559. |
| [5] | 彭德林,孙剑飞,沈军,陈德民,王刚,陈玉勇.Zr41.2Ti13.8Cu12.5Ni10Be22.5合金凝固过程热力学[J].中国有色金属学报,2003(05):1083-1086. |
| [6] | 黄劲松,刘咏,陈仕奇,刘祖铭,黄伯云.锆基非晶合金的研究进展与应用[J].中国有色金属学报,2003(06):1321-1332. |
| [7] | Mark Telford .THe case for bulk metallic glass[J].Materials Today,2004(3):35-43. |
| [8] | 谢建新,周成,张志豪.非晶合金精细零部件的超塑性成形技术[J].材料导报,2003(02):8-11. |
| [9] | Akihisa Inoue;Yoshihito Kawamura;Tsutomu Shibata;Kenichiro Sasamori .Viscous Flow Deformation in Supercooled Liquid State of Bulk Amorphous Zr_(55)Al_(10)Ni_5Cu_(30) Alloy[J].Materials Transactions, JIM,1996(6):1337-1341. |
| [10] | Y.Kawamura;T.Shibata;A.Inoue .Workability of the supercooled liquid in the Zr_65Al_10Ni_10Cu_15 bulk metallic glass[J].Acta materialia,1998(1):253-263. |
| [11] | 张志豪,刘新华,周成,谢建新.Zr基大块非晶合金的超塑性成形性能[J].中国有色金属学报,2004(07):1073-1077. |
| [12] | ZHANG Zhi-hao;LIU Xin-hua;ZHOU Cheng.Super-plastic formability and fine precision parts die-forging of Zr-based bulk metallic glass[A].哈尔滨:哈尔滨工业大学出版社,2004:689-694. |
| [13] | M. Heilmaier .Deformation behavior of Zr-based metallic glasses[J].Journal of Materials Processing Technology,2001(3):374-380. |
| [14] | T. G. NIEH;J. WADSWORTH;C. T. LIU .PLASTICITY AND STRUCTURAL INSTABILITY IN A BULK METALLIC GLASS DEFORMED IN THE SUPERCOOLED LIQUID REGION[J].Acta materialia,2001(15):2887-2896. |
| [15] | 吴诗悖.挤压理论[M].北京:国防工业出版社,1994 |
| [16] | 谢建新;刘静安.金属挤压理论与技术[M].北京:冶金工业出版社,2001 |
上一张
下一张
上一张
下一张
计量
- 下载量()
- 访问量()
文章评分
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%