采用光学显微镜(OM)、扫描电子显微镜(SEM)、洛氏硬度计、冲击试验机等观察和分析了7Cr17Mo马氏体不锈钢在980~1110℃不同温度淬火下的组织特征和性能变化.结果表明,淬火组织为残留奥氏体和碳化物分布于隐针马氏体基体上,碳化物以(Fe,Cr)23C6为主.随着淬火温度的升高,残留奥氏体含量增加,马氏体过饱和度增加,针状马氏体组织变粗,1060℃时硬度升高到最大值59 HRC.冲击试验结果表明在980~1080℃淬火时,随淬火温度升高,冲击韧性提高,1080℃时冲击韧性最好,其后下降.SEM断口形貌表明室温下冲击断裂方式为微孔聚集型断裂.
参考文献
[1] | 吴承建;陈国良;强文江.金属材料学[M].北京:冶金工业出版社,2005:78-79. |
[2] | Mesa D H;Toro A;Sinatora A et al.The effect of testing temperature on corrosion-erosion resistance of martensitic stainless steele[J].WEAR,2003,255:i39-145. |
[3] | John D. Verhoeven;Alfred H. Pendray;Howard F. Clark .Wear tests of steel knife blades[J].Wear: an International Journal on the Science and Technology of Friction, Lubrication and Wear,2008(7/8):1093-1099. |
[4] | 王书珍 .4Cr10Si2钢的合金化特点及其性能研究[D].重庆大学,2009. |
[5] | Calliari I;Zanesco M;Dabala M et al.Investigation of micmstructure and properties of a Ni-Mo martensitic stainless steel[J].Materials & Design,2008,29(01):246-250. |
[6] | Rajasekhar;G. Madhusudhan Reddy;T. Mohandas;V.S.R. Murti .Influence Of Austenitizing Temperature On Microstructure And Mechanical Properties Of Aisi 431 Martensitic Stainless Steel Electron Beam Welds[J].Materials & design,2009(5):1612-1624. |
[7] | Rajasekhar, A;Reddy, GM;Mohandas, T;Murti, VSR .Influence of post-weld heat treatments on microstructure and mechanical properties of AISI 431 martensitic stainless steel friction welds[J].Materials Science and Technology,2008(2):201-212. |
[8] | 张帆;周伟敏.材料性能学[M].上海:上海交通大学出版社,2009:96-98. |
[9] | 束德林.工程材料力学性能[M].北京:机械工业出版社,2003:34-36. |
上一张
下一张
上一张
下一张
计量
- 下载量()
- 访问量()
文章评分
- 您的评分:
-
10%
-
20%
-
30%
-
40%
-
50%