CO2-shielded welding experiments of newly developed, 780 MPa super-high strength heavy-duty truck crossbeam steel were conducted, and the microstructure, microhardness, mechanical properties, and impact tough- hess of the welded joint were studied. The evolution of the microstructure of the welded joint occurred as follows.. welding seam （acicular ferrite＋proeutectoid ferrite）→fusion zone （granular bainite-long strip M/A island）→coarse grain zone （granular bainite-long strip or short bar M/A island）→fine grain zone （ferrite＋ pearlite＋ blocky M/A is- land）→mixed grained zone （ferrite＋granular bainite＋blocky M/A island）→base metal （proeutectoid ferrite＋gran- ular bainite-hlocky or granular M/A island）. Increasing the density of the grain boundaries can effectively improve the impact toughness, and the blocky M/A island hindered crack propagation more effectively than the long strip M/A island. The new hot-rolled 780 MPa super-high strength steel had excellent weldability. The welding technology was applied under the following conditions： welding voltage was 20 to 21 V, welding current was 200 to 210 A, and the gas flow rate was 25 L/rain.
参考文献
| [1] | Nakio NAKATA;Matthias MILITZER .Modeling of Micro- structure Evolution During Hot Rolling of a 780 MPa High Strength Steel[J].ISIJ International,2005,45(01):82. |
| [2] | R D K Misra;H Nathani;J E Hartmann et al.Microstructural Evolution in a New 770 MPa Hot Rolled Nb-Ti Mieroalloyed Steel[J].Materials Science and Engineering,2005,394A |
| [3] | A. Kammouni;W. Saikaly;M. Dumont;C. Marteau;X. Bano;A. Charai .Effect of the bainitic transformation temperature on retained austenite fraction and stability in Ti microalloyed TRIP steels[J].Materials Science & Engineering, A. Structural Materials: Properties, Misrostructure and Processing,2009(1/2):89-96. |
| [4] | Ohya K;Kim J;Yokoyama K .Microstructures Relevant to Brittle Fracture Initiation at the Heat-Affected Zone of Weld- ment of a Low Carbon Steel[J].Metallurgical and Materials Transactions,1996,27A(06):2574. |
| [5] | Lee S;Kim B C;Kwon D .Frature Toughness Analysis ofHeat-Affected Zones in High Strength Low-Alloyed Steel Welds[J].Metallurgical and Materials Transactions,1993,24A(08):2803. |
| [6] | S. Moeinifar;A.H. Kokabi;H.R. Madaah Hosseini .Influence of peak temperature during simulation and real thermal cycles on microstructure and fracture properties of the reheated zones[J].Materials & design,2010(6):2948. |
| [7] | Zhang Y Y;Qu J S;Yang Y .Analysis on Microstructure of Welded Joints oI Domex700MC HSLA Steel[J].Hot Working Technology,2007,36(23):30. |
| [8] | Lu J X .Research and Development of a High Strength Micro Alloyed Steel With Yield Strength of 700 MPa[D].沈阳:东北大学,2004. |
| [9] | Bai D Q;Yue S;Maceagno T M et al.Continuous Cooling Transformation Temperature Determined by Compression Tests in Low Carbon Bainitic Grades[J].Metallurgical and Materials Transactions,1998,29A:989. |
| [10] | J. R. YANG;C. Y. HUANG;C. S. CHIOU .The influence of plastic deformation and cooling rates on the microstructural constituents of an ultra-low carbon bainitic steel[J].ISIJ International,1995(8):1013-1019. |
| [11] | Hwang B C;Lee C G;Lee T H .Correlation of Microstructure and Mechanical Properties of Thermomechanically Processed Low-Carbon Steels Containing Boron and Copper[J].Metal- lurgical and Materials Transactions,2010,41A:85. |
| [12] | Zhong Y;Xiao F R;Zhang J W et al.In Situ TEM Study of the Effect of M/A Films at Grain Boundaries on Crack Propagation in an Ultra-Fine Acicular Ferrite Pipeline Steel[J].Acta Materialia,2006,54:435. |
| [13] | Emonds D V;Cochrane R C .Structure-Property Relation- ships in Bainitic Steels[J].Metallurgical and Materials Transactions,1990,21A:1527. |
| [14] | Ohtani H;Okaguchi S;Fujishiro Y et al.Morphology and Properties of Low-Carbon Bainite[J].Metallurgical and Ma terials Transactions,1990,21A:877. |
| [15] | Han S Y;Shin S Y;Lee S H et al.Effects of Cooling Condi- tions on Tensile and Charpy Impact Properties of API X80 Line Pipe Steels[J].Metallurgical and Materials Transac- tions,2010,41A:329. |
| [16] | Ueda K;Endo S;Ito T .780 MPa Grade Steel Plates With Low Yield Ratio by Microstructural Control of Dual Phase[J].JFE Technical Reports,2007,18:23. |
- 下载量()
- 访问量()
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%