利用金相显微镜、X射线衍射仪和透射电子显微镜对异步轧制及热处理TWIP钢的力学性能与微观组织进行了研究。结果表明,TWIP钢经500℃异步轧制后强度显著提高,而塑性降低,这是位错与孪晶共同作用的结果。轧制后的热处理降低了位错密度以及变形孪晶数量,导致强度降低,伸长率升高。经600℃和700℃退火后,TWIP钢表现出良好的强度和塑性综合性能。因此,异步轧制后热处理是获得具有优良综合力学性能TWIP钢的可行途径。
The mechanical properties and microstructures of the TWIP steels subjected to asymmetric rolling(ASR) and post-annealing processes were investigated by means of optical microscope,X ray diffractometer and transmission electron microscope.The results indicate that the strength of the TWIP steel is greatly increased while the ductility is decreased obviously after asymmetrically rolled at 500 ℃.Such results are ascribed to the combined action of dislocations and twins.The heat treatment after rolling reduces the dislocation density and amount of twins,and consequently leads to the decrease of strength and increase of elongation.After annealing at 600 ℃ and 700 ℃,the TWIP steel have good property combination of both strength and ductility.Therefore,the ASR plus post-annealing process was a feasible approach to achieve excellent combinative mechanical properties in TWIP steels.
参考文献
[1] | Grassel O.;Frommeyer G.;Meyer LW.;Kruger L. .High strength Fe-Mn-(Al, Si) TRIP/TWIP steels development - properties - application[J].International Journal of Plasticity,2000(10/11):1391-1409. |
[2] | Allain S;Chateau J P;Bouaziz O.A Physical Model of the Twinning-Induced Plasticity Effect in a High Manganese Austenitic Steel[J].Materials Science and Engineering A:Structural Materials Properties Microstructure and Processing,2004:387-389,143. |
[3] | Karaman I;Sehitoglu H;Gall K .Deformation of Single Crystal Hadfield Steel by Twinning and Slip[J].Acta Materialia,2000,48:1345. |
[4] | Kibey S;Liu J B;Curtis M J et al.Effect of Nitrogen on Generalized Stacking Fault Energy and Stacking Fault Widths in High Nitrogen Steels[J].Acta Materialia,2006,54:2991. |
[5] | Huang B X;Wang X D;Rong Y H .Mechanical Behavior and Martensitic Transformation of an Fe-Mn-Si-A1-Nb Alloy[J].Materials Science and Engineering A:Structural Materials Properties Microstructure and Processing,2006,438-440:306. |
[6] | Dini, G;Najafizadeh, A;Monir-Vaghefi, SM;Ebnonnasir, A .Predicting of mechanical properties of Fe-Mn-(Al, Si) TRIP/TWIP steels using neural network modeling[J].Computational Materials Science,2009(4):959-965. |
[7] | Dini G;Najafizadeh A;Ueji R .Improved Tensile Properties of Partially Recrystalized Submicron Grained TWIP Steel[J].Materials Letters,2010,64:15. |
[8] | Tsakiris V;Edmonds D V .Martensite and Deformation Twinning in Austenitic Steels[J].Materials Science and Engineering A:Structural Materials Properties Microstructure and Processing,1999,273-275:430. |
[9] | Allain S;Chateau J P;Bouaziz O .Correlations Between the Calculated Stacking Fault Energy and the Plasticity Mechanisms in Fe-Mn-C Alloys[J].Materials Science and Engineering A:Structural Materials Properties Microstructure and Processing,2004,387-389:158. |
[10] | Lee Y K;Choi C S .Driving Force for γ→ε Martensitic Transformation and Stacking Fault Energy of γ in Fe-Mn Binary System[J].Metallurgical and Materials Transactions A:Physical Metallurgy and Materials Science,2000,31:355. |
[11] | Bouaziz O;Guelton N.Modeling of TWIP Effect on Workhardenging[J].Materials Science and Engineering A:Structural Materials Properties Microstructure and Processing,2001:319. |
[12] | Bouaziz O;Allain S;Scott C .Effect of Grain and Twin Boundaries on the Hardening Mechanisms of Twinning-Induced Plasticity Steels[J].Scripta Materialia,2008,58:484. |
[13] | Sevillano J G .An Alternative Model for the Strain Hardening of FCC Alloys that Twin,Validated for Twinning-Induced Plasticity Steel[J].Scripta Materialia,2009,60:336. |
[14] | Barbier, D;Gey, N;Allain, S;Bozzolo, N;Humbert, M .Analysis of the tensile behavior of a TWIP steel based on the texture and microstructure evolutions[J].Materials Science and Engineering. A, Structural Materials: Properties, Microstructure and Processing,2009(1/2):196-206. |
[15] | Chen L;Kim H;Kim S .Localized Deformation due to Portevin-LeChatelier Effect in 18Mn-0.6C TWIP Austenitic Steel[J].ISIJ International,2007,47:1804. |
[16] | Dini G;Ueji R;Najafizadeh A .Flow Stress Analysis of TWIP Steel via the XRD Measurement of Dislocation Density[J].Materials Science and Engineering A:Structural Materials Properties Microstructure and Processing,2010,527:2759. |
[17] | Ueji R;Tsuchida N;Terada D .Tensile Properties and Twin ning Behavior of High Manganese Austenitic Steel With Fine- Grained Structure[J].Scripta Materialia,2008,59:963. |
[18] | Gutierrz-Urrutia I;Zaefferer S;Raabe D .The Effect of Grain Size and Grain Orientation on Deformation Twinning in a Fe-22wt.% Mn-0.6wt.%C TWIP Steel[J].Materials Science and Engineering A:Structural Materials Properties Microstructure and Processing,2010,527:3552. |
[19] | Jiang J H;Ding Y;Zuo F Q .Mechanical Properties and Microstructures of Ultrafine-Grained Pure Aluminum by Asymmetric Rolling[J].Scripta Materialia,2009,60:905. |
[20] | Ding Y;Jiang J H;Shan A D .Microstructures and Mechani cal Properties of Commercial Purity Iron Processed by Asym metric Rolling[J].Materials Science and Engineering A:Structural Materials Properties Microstructure and Processing,2009,520:80. |
[21] | 严玲,唐荻,米振莉,郭锦.汽车用TWIP钢的力学性能与微观组织[J].北京科技大学学报,2006(08):739-743. |
[22] | 严玲,唐荻,米振莉,郭锦.不同加工工艺对高强高塑性TWIP钢组织与性能的影响[J].热加工工艺,2005(08):15-17. |
[23] | 李卫,唐正友,王玫,丁桦,杨平.高锰奥氏体TRIP/TWIP钢的组织和力学性能[J].钢铁,2007(01):71-75. |
[24] | 米振莉,唐荻,严玲,郭锦.高强度高塑性TWIP钢的开发研究[J].钢铁,2005(01):58-60. |
[25] | 熊荣刚,符仁钰,黎倩,张梅,李麟.TWIP钢的组织与力学性能研究[J].上海金属,2007(04):25-28. |
[26] | Kruger L;Meyer L W;Brux U.Stress-Deformation Behavior of High Manganese(A1,Si)TRIP and TWIP Steels[J].Journal of Physics IV(France),2003:110,189. |
[27] | Z.L. Mi,D. Tang,Y.J. Dai,H.Q. Wang,S.S. Li.INFLUENCE OF COLD ROLLING REDUCTION ON MICROSTRUCTURE AND MECHANICAL PROPERTIES OF TWIP STEEL[J].金属学报(英文版),2007(06):441-447. |
- 下载量()
- 访问量()
- 您的评分:
-
10%
-
20%
-
30%
-
40%
-
50%