本文针对不同压力条件下不同换热表面结构的毛细结构蒸发器气（？）液相变传热特性进行了实验研究。选取微槽道结构和烧结丝网结构的换热表面分别在蒸发压力为0.86×10~5 Pa、0.91×10~5 Pa、0 96×10~5 Pa、1.0×10~5 Pa、1.5×10~5 Pa、2.0×10~5 Pa条件下进行了传热特性研究并对其实验结果进行对比,结果表明,压力对换热系数有重要的影响,当压力范围为0.86×10~5～1.0×10~5 Pa时,在过热度相同的条件下,随着压力的增加,换热系数呈上升趋势;在较大压力的条件下,换热系数随着过热度的增加呈先升后降的趋势。
Heat transfer characteristics for the different heat transfer surface structure at the different pressure conditions were investigated.The operational pressures in this study was in the range of 0.86×10~5～2.0×10~5 Pa,and heat transfer characteristics of the micro-channel structure and sintered screen structure were experimentally studied and compared.The experimental results showed that the operational pressure has an significantly effect on heat transfer coefficient.Heat transfer coefficient improved with the increase pressure in the range of 0.86×10~5～1.0×10~5 Pa at the same superheat condition.At the higher operational pressure,heat transfer coefficient first improved with the increase of superheat then dropped after reaching a certain value.
参考文献
| [1] | M. A. Hanlon;H. B. Ma .Evaporation Heat Transfer in Sintered Porous Media[J].Journal of heat transfer: Transactions of the ASME,2003(4):644-652. |
| [2] | Jinliang Wang;Ivan Catton .Enhanced evaporation heat transfer in triangular grooves covered with a thin fine porous layer[J].Applied thermal engineering: Design, processes, equipment, economics,2001(17):1721-1737. |
| [3] | 赵耀华,刘建荣,刁彦华,杨开篇,康晓龙.微槽群相变散热器传热性能的实验研究[J].工程热物理学报,2008(05):825-827. |
- 下载量()
- 访问量()
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%