欢迎登录材料期刊网

材料期刊网

高级检索

研究了碳纤维增强SiCN陶瓷基复合材料(C/SiCN)在真空中的拉伸蠕变行为,通过对比预热处理和未热处理的两类C/SiCN的蠕变激活能,分析了预热处理的稳定化效果,并采用X射线衍射研究了C/SiCN的蠕变相变行为.结果表明,预热处理促进了非晶SiCN基体的结晶,能明显提升C/SiCN的蠕变激活能(Q),未热处理C/SiCN的Q=51kJ/mol,而热处理后试样的Q=72kJ/mol.恒定蠕变应力能明显促进非晶SiCN基体的结晶.

The tensile creep of carbon fiber reinforced SiCN ceramics matrix composite (C/SiCN) under vacuum is studied.The creep activation energy of the as-received and pre-stabilized C/SiCN is computed and compared,respectively,and the effect of pre-stabilization is analyzed.The phase transition of C/SiCN during creep is examined by X-ray diffraction.The results indicate that pre-annealing promotes the crystallization of amorphous SiCN ceramics matrix,and facilitates increment of the activation energy of C/SiCN.The creep stress acted on C/SiCN accelerates the crystallization of amorphous SiCN ceramics by producing stress field within C/SiCN.

参考文献

[1] 夏熠,乔生儒,王强强,张程煜,韩栋,李玫.真空气氛下非晶硅碳氮(SiCN)陶瓷的高温晶化行为[J].无机材料学报,2009(04):827-830.
[2] Jedrzejowski P;Cizek J;Amassian A et al.Mechanical and optical properties of hard SiCN coatings prepared by PECVD[J].Thin Solid Films,2004,447-448:201.
[3] Liew LA.;Liu YP.;Luo RL.;Cross T.;An LN.;Bright VM.;Dunn ML.;Daily JW.;Raj R. .Fabrication of SiCN MEMS by photopolymerization of pre-ceramic polymer?[J].Sensors and Actuators, A. Physical,2002(2/3):120-134.
[4] Liew L A;Zhang W;Bright V M et al.Fabrication of SiCN ceramic MEMS using injectable polymer-precursor technique[J].Sensors and Actuators A:Physical,2001,89(1-2):64.
[5] Doucey B.;Cuniot M.;Moudni R.;Tenegal F.;Bouree JE.;Imhoff D. Rommeluere M.;Dixmier J. .Optical properties and local atomic order in non hydrogenated amorphous silicon carbonitride films[J].Journal of Materials Science,2002(13):2737-2745.
[6] Lee SS.;Staehler JM.;Folsom CA.;Zawada LP. .Mechanical behavior and high-temperature performance of a woven Nicalon (TM)/Si-N-C ceramic-matrix composite[J].Journal of the American Ceramic Society,1998(7):1797-1811.
[7] Sato Kiyoshi;Morozumi Hiroki .Mechanical properties and oxidation resistance of C-B-Si coated silicon nitride fiber reinforced Si-N-C composites with cross-ply structure[J].Composites, Part A. Applied science and manufacturing,1999(4):577-581.
[8] Zheng W W;Chen Z H;Ma Q S et al.Influence of heating rate on the microstructure and mechanical properties of carbon fiber/Si-C-N composites via polysilazane pyrolysis[J].Journal of Materials Science,2004,39:3521.
[9] 乔生儒;卢国锋;钟杰华 等.基体前驱体液气相热解制备碳/碳-碳化硅复合材料的方法[P].中国,ZL 200610043034.4,2008-03-05.
[10] 乔生儒;杨峥;骆蓉 et al.单向碳-碳复合材料的早期蠕变行为[J].西北工业大学学报,1994,12(03):430.
[11] Bahloul D;Pereira M;Goursat P .Preparation of silicon carbonitrides from an organosilicon polymer:Ⅱ.Thermal behavior at high temperatures under argon[J].Journal of the American Ceramic Society,1993,76(05):1163.
[12] Monthioux M;Delverdier Q .Thermal behavior of (organosilicon) polymer-derived ceramics,Ⅴ:Main facts and trends[J].Journal of the European Ceramic Society,1996,16(07):721.
上一张 下一张
上一张 下一张
计量
  • 下载量()
  • 访问量()
文章评分
  • 您的评分:
  • 1
    0%
  • 2
    0%
  • 3
    0%
  • 4
    0%
  • 5
    0%