Coldrolled thin strip steel of high flatness quality undergoes multistage deformation during tension leveling. Thus, the parameters of setup and manipulating are more difficult. With the aid of FE code MSCMARC, the tension leveling process of thin strip steel was numerically simulated. Concentrating on the influence of the roll intermeshes in 2# anticambering on the distribution and magnitude of residual stresses in leveled strip steel, several experiments were done with the tension leveler based on the results from the simulation. It was found from the simulation that the magnitude of longitudinal residual stresses in the crosssection of the leveled strip steel regularly presents obvious interdependence with the roll intermeshes in 2# anticambering. In addition, there is a steady zone as the longitudinal residual stresses of the surface layers in leveled strip steel vary with the roll intermeshes of 2# anticambering, which is of importance in the manipulation of tension levelers. It was also found that the distribution of strains and stresses across the width of strip steel is uneven during leveling or after removing the tension loaded upon the strip, from which it was found that 3D simulation could not be replaced by 2D analysis because 2D analysis in this case cannot represent the physical behavior of strip steel deformation during tension leveling.
参考文献
- 下载量()
- 访问量()
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%