Iron alloyed Ni3Al with composition of Ni-18. 8Ab10. 7Fe-0. 5Mn-0. 5Ti-0. 2B in atom percent （NAC alloy） showed attractive tribological properties under unlubrication condition at room temperature. The alloy was prepared by hot isostatic pressing （HIP） process. The wear properties were associated with its intrinsic deformation mechanism. Unfortunately, the single phase NAC-alloy worked inadequately with its counterpart disk, and also showed a poor machinability. In the present work, NAC-alloy matrix composite with 6 % （volume percent） MnS particle addi- tion was studied to improve its wear behaviors and performance on machining. Two metallurgical processes of HIP and vacuum casting were applied to produce the testing materials. Pin-on-disk （POD） measurements were carried out at room temperature. A commercial vermicular graphite cast iron was selected as a reference material. The counter- part disk was made of a grey cast iron as liner material in ship engines. The contact pressures of 2.83 MPa and 5.66 MPa were normally applied in the tests. The investigation indicated that MnS particle addition in the NAC-alloy composites functions as an effective solid lubricant, and improved wear properties and machinability of the materials. Obvi- ously, as-cast NAC-alloy with in-situ formed MnS-phase was working more effectively with the counterpart, compa- ring to the HIPed NAC-alloy composite with MnS particles. At the high contact pressure of 5.66 MPa, the specific wear rate of the as-cast NAC-alloy composite was high. The phenomenon of the negative effect is mostly due to the brittle second NiAl phase as evidenced in the microstructure analysis.
参考文献
| [1] | Marquardt B J;Wert J J .Wear Induced Deformation of Ni3AI,(Fe,Co)aAI and(FeNi)3V[J].Proc Mater Res Soc,1985,39:247. |
| [2] | Blau P J;DeVore C E .Sliding Behaviour of Alumina/Nickel and Alumina/Nickel Aluminide Couple at Room and Elevated Temperature[J].Journal of Tribology,1988,110:646. |
| [3] | Bonda N R;Rigney D A .Unlubricated Sliding Wear of Nickel Aluminides at Room Temperature and 400 ℃[J].Proc Mater Res,1989,133:585. |
| [4] | Blau P J;DeVore C E.Temperature Effects on the Break-in of Nickel Aluminide Alloys[A].[S.1.]:American Society of Mechanical Engineers,1989:305. |
| [5] | Blau P J;DeVore C E.Sliding Friction and Wear Behaviour ofSeveral Nickel Aluminide Alloys Under Dry and Lubricated Condition[J].Tribol Ins,1990(10):226. |
| [6] | Johnson M;Mikkola D E;March P A et al.The Resistance of Nickel and Iron Aluminides to Cavitation Erosion and Abrasive Wear[J].Wear,1990,140:279. |
| [7] | Gong Karin;Luo Heli;Feng Di et al.Wear of Ni3AI-Based Materials and Its Chromium-Carbide Reinforced Composites[J].Wear,2008,265:1751. |
| [8] | Gong Karin;Zhou Zhifeng;Shum P W et al.Tribological Evaluation on Ni3 A1-Based Alloy and Its Composites Under U:lubricated Wear Condition[J].Wear,2011,270:195. |
| [9] | Rigney D A;Chen L H;Naylor M G S et al.Wear Process in Sliding Systems[J].Wear,1984,100:195. |
| [10] | Rigney D A;Naylor M G S;Divakar R et al.Low Energy Dislocation Structures Caused by Sliding and by Particle Im- pact[J].Materials Science and Engineering,1986,81:409. |
| [11] | Rigney D A .Adhesion Processes in Technological Application[J].Materials Science and Engineering,1986,83:189. |
| [12] | LA Pei-qing;XUE Qun-ji;LIU Wei-min .Effects of Boron Doping on Tribological Properties of Ni2A1-CrTC3 Coatings Under Dry Sliding[J].Wear,2001,249:94. |
| [13] | Yavuz Solmaz;M. Halidun Kelegtemur .Wear behavior of boron-doped Ni{sub}3Al material at elevated temperature[J].Wear: an International Journal on the Science and Technology of Friction, Lubrication and Wear,2004(9/10):1015-1021. |
| [14] | Kear B H;Giamei A F;Leverant G R et al.On Intrinsic/Ex- trinsic Stacking Fault Pairs in the LIz Lattice[J].Scripta Metallurgica,1969,3:123. |
| [15] | Kear B H .Dislocation Configuration and Work Hardening in Cu3Au Crystal[J].Acta Metallurgica,1964,12:555. |
| [16] | Chiou Y C;Kato K;Abe H .The Effect of Normal Damping in the Loading System on the Wear of Low Carbon Steel[J].Wear,1987,114:73. |
| [17] | Akagaki T;Rigney D A .Sliding Friction and Wear of Metals Vacuum[J].Wear,1991,149:353. |
| [18] | Jin J H;Stephenson D J .The Sliding Wear Behaviour of Reac- tively Hot Pressed Nickel Aluminides[J].Wear,1998,217:200. |
| [19] | Miracle D B;Darolia R .Metal Matrix Composites--From Sci- ence to Technological Significance[J].Composites Science and Technology,2005,65:2526. |
| [20] | Kennedy F E;Hussaini I S Z .Thermo-Mechanical Anaysis of Dry Sliding Systems[J].Computers & Structures,1987,26:345. |
| [21] | Karin Gong .Tribological Properties of Ni3Al-t3ased Materials[D].Gothenburg:Chalmers University of Technology,Swe- den,2001. |
- 下载量()
- 访问量()
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%