冷连轧过程中,轧制力波动对板形的影响很大,需要采用弯辊力进行实时的补偿.针对六辊冷连轧机,分别研究了仅用工作辊弯辊和采用下作辊与中间辊弯辊相结合的板形前馈控制模型.实际控制效果表明,这两种板形前馈控制模型都能有效消除轧制力波动对板形产生的不利影响;采用工作辊弯辊的板形前馈控制模型只能控制由于轧制力波动产生的二次板形,而对四次板形几乎不产生影响;而采用工作辊与中间辊弯辊相结合的板形前馈控制模型则对二次和四次板形均具有很强的控制能力.
Rolling force variation will affect the strip flatness during continuous cold rolling.Therefore,real-time bending force compensation would be in great needs.Two flatness feedforward control models for six high tandem cold rolling mill were investigated.The work roll bending was applied in both kinds of control models,while the intermediate roll bending was employed additionally in the second control model.Control results show that negative effects of the rolling force variation on strip flatness can be reduced efficiently in both control models.Quadratic component of strip flatness which is caused by rolling force variation can be eliminated by employing the work roll bending compensation model.But almost no contribution could be made to the elimination of quartic component.However,for work roll and intermediate roll bending compensation model both quadratic and quartic components of strip flatness can be controlled effectively.
参考文献
| [1] | 丁修堃.轧制过程自动化[M].北京:冶金工业出版社,2005:213. |
| [2] | Paul Kern;Frank Mehlich;Jorg Schumacher .Model-supported flatness control systems for cold rolling mills[J].Iron & Steel Review,1999(8):38-45. |
| [3] | Egan S.J.; .Flatness modeling and control for a continuous tandem cold mill[J].Iron and Steel Engineer,1996(3):38-41. |
| [4] | 孙一康.带钢冷连轧计算机控制[M].北京:冶金工业出版社,2002:166. |
| [5] | 白金兰 .单机架可逆冷轧机板形控制预设定理论研究[D].沈阳:东北大学,2006. |
| [6] | 王国栋.板形控制和板形理论[M].北京:冶金工业出版社,1986:344. |
| [7] | 刘宏民.三维轧制理论及应用[M].北京:科学出版社,1999:4. |
| [8] | 梁勋国 .六辊冷连轧机板形控制模型优化的研究[D].东北大学,2009. |
| [9] | 张秀玲,刘宏民.板形模式识别的GA-BP模型和改进的最小二乘法[J].钢铁,2003(10):29-34. |
- 下载量()
- 访问量()
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%