Mg-14Li-1Al-0．1Ce合金在卤素溶液（NaX，X=F，C1，Br和I）中腐蚀行为的研究

腐蚀学报（英文）, 2011, 23(6): 467-470.

Mg-14Li-1Al-0．1Ce合金在卤素溶液（NaX，X=F，C1，Br和I）中腐蚀行为的研究

马毅斌 ^1, , 李宁 ^2, , 黎德育 ^3, , 张密林 ^4, , 黄晓梅 ^5,

1.哈尔滨工业大学化工学院,哈尔滨,150000

2.哈尔滨工业大学化工学院,哈尔滨150000／哈尔滨工程大学超轻材料与表面技术教育部重点实验室,哈尔滨150000

3.哈尔滨工业大学化工学院,哈尔滨,150000

4.哈尔滨工程大学超轻材料与表面技术教育部重点实验室,哈尔滨,150000

5.哈尔滨工程大学超轻材料与表面技术教育部重点实验室,哈尔滨,150000

基金项目: 超轻材料与表面技术教育部重点实验室资助项目

关键词：镁锂合金 , 腐蚀 , 卤化钠 , EIS , XRD

Corrosion Behavior of Mg-14-1Al-0.1Ce Alloy in NaX （X=F, Cl, Br and I） Solutions

Keywords： Mg-Li alloy , corrosion , sodium halide , EIS , XRD

用电化学方法研究了Mg-14Li-1Al-0．1Ce合金在卤素溶液（NaX，X=F，C1，Br和I）中的腐蚀行为并用失重法测定其腐蚀速率，用扫描电镜（SEM）观察腐蚀后的表面形貌，利用XRD检定腐蚀产物的相组成．结果表明，合金在卤素溶液中的腐蚀速率由低到高的顺序是：NaF〈NaI〈NaBr〈NaCl．经过48h腐蚀后，合金在NaCl、NaBr和NaI溶液中的腐蚀产物层的组分为Mg（OH）2，Li3Mg7和Li0.92Mg4.08，而在NaF溶液中的腐蚀产物层的组分为Li3Mg7和Li0．92Mg4．08．此外，合金在NaF溶液中的电化学活性非常低，出现了钝化现象．电化学阻抗谱表明合金腐蚀产物层不能起到防止基体腐蚀的作用．

The corrosion behavior of Mg-14Li-lAl-0.1Ce in sodium halide NaX （X=F, Cl, Br and I） solutions was investigated by immersion test and electrochemical methods. Its corrosion rate in various solutions was accessed by mass loss method. The phase constituent, chemical composition and morphologies of corroded surface after 48 h immersed in different solutions were characterized by X-ray diffraction （XRD） and scanning electron microscopy （SEM）. The results revealed that the corrosion resistance of Mg-14Li-lAl-0.1Ce in sodium halide solutions decreased in the order： NaF〉NaI〉NaBr〉NaC1. After immersed in NaI, NaBr, NaC1 solution respectively, the corrosion products consisted of Mg（OH）2, Li3Mg7 and Li0.92Mg4.0s, but for NaF solution, only Li3Mg7 and Li0.92Mg4.0s were found. Mg-Li-Al-Ce alloy showed passivation behavior in NaF solution. EIS results indicated that the corrosion product layer could not prevent the Mg-Li-AI-Ce alloy from further corrosion.

参考文献

[1]	Jiang B, Qiu D, Zhang M X, et al. A new approach to grain refinement of an Mg-Li-A1 cast alloy ~J]. J. Al- loys. Compd., 2010, 492: 95.
[2]	Liu T, Wu S D, Li S X, et al. Microstructure evolution of Mg-14%Li-1%A1 alloy during the process of equal channel angular pressing [J]. Mater. Sci. Eng., 2008, A487: 347.
[3]	黄晓梅,张春红,张密林.纯镁和镁锂合金在中性3.5%NaCl溶液中的腐蚀行为[J].航空材料学报,2008,28(3):71.
[4]	Song Y W, Shan D Y, Chen R S, et al. Corrosion charac- teristic of Mg-8Li alloy in NaC1 solution [J]. Corros. Sci., 2009, 51: 1087.
[5]	Gao L L, Zhang C H, Zhang M L, et M. The corrosion of a novel Mg-llLi-3A1-0.5RE alloy in alkaline NaC1 solution [J]. J. Alloys. Compd., 2009, 468: 285.
[6]	Heakal F E, Fekry A M, Fatayerji M Z. Influence of halides on the dissolution and passivation behavior of AZ91D mag-nesium alloy in aqueous solutions [J]. Electrochim. Acta, 2009, 54: 154.5.
[7]	Zhao M C, Liu M, Song G L, et al. Influence of pH and chloride ion concentration on the corrosion of Mg alloy ZE41 [J]. Corros. Sci., 2008, 50: 3168.
[8]	Guo X W, Chang J W, He S M, et al. Investigation of cor- rosion behaviors of Mg-6Gd-3Y-0.4Zr alloy in NaC1 aque- ous solutions [J]. Electrochim. Acta, 2007, 52: 2570.
[9]	Verdierc S, van der Laak N, Delalande S, et al. The surface reactivity of a magnesium-aluminium alloy in acidic fluo- ride solutions studied by electrochemical techniques and XPS [J]. Appl. Surf. Sci., 2004, 235: 513.

上一张下一张

计量

下载量()
访问量()

作者相关

文章评分

您的评分：
1

0%
2

0%
3

0%
4

0%
5

0%

材料期刊网