欢迎登录材料期刊网

材料期刊网

高级检索

采用ANSYS有限元软件计算涂层法制备的SCS-6 SiC/Ti-6Al-4V复合材料内热残余应力,分析了界面性能对热残余应力的影响。结果表明:较高的热膨胀系数(CTE)导致界面层产生高的应力梯度,使环向残余应力由低热膨胀系数时的压应力转变为较高的热膨胀系数时的拉应力;界面层弹性模量的增加,使得纤维和界面层内径向残余压应力明显增加,但对基体中的残余应力影响并不大;界面层厚度的变化对基体中径向残余应力影响不大,但随着界面层厚度增加,基体中残余应力有所减小。

Effect of interracial properties on thermal residual stress in SCS-6 SiC/Ti-6A1-4V composite was analyzed by finite element method. The results indicate that large residual stress gradient in interfacial layer is obtained due to high coefficient thermal expansion (CTE) and the hoop residual compressive stress at low CTE transfers to the tensile stress at high CTE. Radial residual stress in fiber and interfaeial layer increases with increasing elastic modulus of interracial layer, but little influence on the residual stress of matrix is observed. The increasing of interfacial layer thickness gives a little effect on the residual stress in matrix, but makes the residual stress slightly decrease.

参考文献

[1] 杨延清,罗贤,黄斌,李建康,陈彦.SiCf/Ti-6Al-4V复合材料的断裂韧性[J].材料热处理学报,2010(09):1-4.
[2] 李建康,杨延清,罗贤,原梅妮.连续SiC纤维增强Ti基复合材料中的纵向残余热应力分析[J].金属热处理,2007(11):65-69.
[3] M.N. Yuan;Y.Q. Yang;Z.J. Ma .Analysis of interfacial behavior in titanium matrix composites by using the finite element method (SCS-6/Ti55)[J].Scripta materialia,2007(6):533-536.
[4] Luo X;Yang Y Q;Li J K et al.The effect of fabrication processes on the mechanical and interfacial properties of SiC/Cu matrix composites [J[J].J Composites Part A,2007,38:2102-2108.
[5] Ma Zhijun;Yang Yanqing;Du Jiang .The effect of magnetron sputter parameter on fiber coating character[J].Materials Letters,2004(15):2118-2121.
[6] Ma Zhi-jun;Yang Yan-qing;Lii Xiang-hong .The effect of matrix creep property on the consolidation process of SiC/Ti-6AI-4V composite[J].Materials Science and Engineering A,2006,443(1-2):343-346.
[7] 吕祥鸿,杨延清,马志军,陈彦.SiC连续纤维增强Ti基复合材料界面反应扩散研究进展[J].稀有金属材料与工程,2006(01):164-168.
[8] Warrier SG;Bourke MAM;Krishnamurthy S;Rangaswamy P .Assessment of the fiber/matrix interface bond strength in SiC /Ti-6Al-4V composites[J].Materials Science & Engineering, A. Structural Materials: Properties, Misrostructure and Processing,1999(2):220-227.
[9] Warrier S G;Gundel D B;Majumdar B S et al.Interface effects on the micromechanical response of a transversely loaded single fiber SCS6/Ti~SAI- 4V composite[J].Metallurgical and Materials Transactions A:Physical Metallurgy and Materials Science,1996,27:2035-2043.
[10] L. L. SHAW;D. B. MIRACLE .EFFECTS OF AN INTERFACIAL REGION ON THE TRANSVERSE BEHAVIOR OF METAL-MATRIX COMPOSITES--A FINITE ELEMENT ANALYSIS[J].Acta materialia,1996(5):2043-2055.
[11] 原梅妮,杨延清.用十字形试样评定钛基复合材料界面法向结合强度[J].稀有金属材料与工程,2008(12):2104-2108.
上一张 下一张
上一张 下一张
计量
  • 下载量()
  • 访问量()
文章评分
  • 您的评分:
  • 1
    0%
  • 2
    0%
  • 3
    0%
  • 4
    0%
  • 5
    0%