耐热镁合金及其相图热力学研究及应用进展

材料导报, 2005, 19(z2): 410-416.

耐热镁合金及其相图热力学研究及应用进展

陈刚 ^1, , 彭晓东 ^2, , 谢卫东 ^3, , 刘相果 ^4, , 魏群义 ^5,

1.重庆科技学院冶金与材料学院,重庆,400042;重庆大学机械工程学院,重庆,400044

2.重庆大学机械工程学院,重庆,400044

3.重庆大学机械工程学院,重庆,400044

4.重庆大学机械工程学院,重庆,400044

5.重庆大学机械工程学院,重庆,400044

基金项目: 新材料领域项目(2003A32X050)

关键词：耐热镁合金 , 高温抗蠕变性 , 相图 , 热力学

Research and Applications of Heat-resistant Magnesium Alloys and Their Phase Diagrams Thermodynamics

镁合金常温力学性能较好,但高温力学性能较差,特别是高温抗蠕变性能较差.综述了国内外耐热镁合金的研究现状,重点分析了Mg-Al、Mg-Zn、Mg-RE等系耐热镁合金高温抗蠕变机制,合金元素对耐热性的影响和耐热镁合金相图热力学的研究进展,最后对耐热镁合金的工业应用现状进行综述,并指出了未来耐热镁合金的研究方向和重点.

参考文献

[1]	Mihriban O et al.[J].Advances in Engineering Materials,2003,5(12):866.
[2]	Bakke P et al.[J].Journal of The Minerals,Metals & Materials Society,2003,55(11):46.
[3]	Regev M et al.[J].Materials Science and Engineering A,2001,302(01):51.
[4]	Yuan G Y et al.[J].Journal of Materials Science Letters,1999,24(18):2055.
[5]	袁广银,刘满平,王渠东,朱燕萍,丁文江.Mg-Al-Zn-Si合金的显微组织细化[J].金属学报,2002(10):1105-1108.
[6]	Yuan G Y et al.[J].Materials Science Forum,2003,419-422(01):425.
[7]	Yuan G Y et al.[J].Materials Science and Engineering A,2003,357(01):314.
[8]	Sklenicka V et al.[J].Materials Science and Engineering A,2001,319-321:741.
[9]	Spigarelli S et al.[J].Materials Science and Engineering A,2000,289(01):172.
[10]	Gutman EM.;Levkovitch M.;Koren Z.;Unigovski Y. .Influence of porosity and casting conditions on creep of die-cast Mg alloy[J].Journal of Materials Science Letters,1998(21):1787-1789.
[11]	Watanabe H et al.[J].Materials Science and Engineering A,2005,52(06):449.
[12]	宋海宁,袁广银,王渠东,朱燕萍,丁文江.耐热Mg-Zn-Si-Ca合金的显微组织和力学性能[J].中国有色金属学报,2002(05):956-960.
[13]	Liu Y Z et al.[J].Materials Science and Engineering A,2001,301(02):255.
[14]	Evangelista E et al.[J].Materials Science and Engineering A,2004,387-389(1-2):41.
[15]	Karel M;Ferdinand D .[J].Journal of Alloys and Compounds,2004,378(1-2):167.
[16]	Terada Y et al.[J].Metallurgical and Materials Transactions A:Physical Metallurgy and Materials Science,2004,35(09):3029.
[17]	Moreno I P et al.[J].Scripta Materialia,2003,48(08):1029.
[18]	Sohn K Y.[A].,2000:271.
[19]	Bakkker P;Westengen H .[J].Advances in Engineering Materials,2003,5(12):879.
[20]	Baril E et al.[J].Journal of The Minerals,Metals & Materials Society,2003,55(11):34.
[21]	Pekguleryuz M.[A].,2003:201.
[22]	Ozturk K et al.[J].Journal of The Minerals,Metals & Materials Society,2003,55(11):40.
[23]	Suzuki A et al.[J].Scripta Materialia,2004,51(10):1005.
[24]	Liu M P et al.[J].Journal of Materials Science Letters,2002,21(16):1281.
[25]	Vogel M et al.[J].Scripta Materialia,2003,48(08):985.
[26]	Zhang Z;Tremblay R;Dube D .Microstructure and mechanical properties of ZA104 (0.3-0.6Ca) die-casting magnesium alloys[J].Materials Science & Engineering, A. Structural Materials: Properties, Misrostructure and Processing,2004(1/2):286-291.
[27]	Anyanwu IA;Gokan Y;Suzuki A;Kamado S;Kojima Y;Takeda S;Ishida T .Effect of substituting cerium-rich mischmetal with lanthanum on high temperature properties of die-cast Mg-Zn-Al-Ca-RE alloys[J].Materials Science & Engineering, A. Structural Materials: Properties, Misrostructure and Processing,2004(1/2):93-99.
[28]	Zhang Z et al.[J].Scripta Materialia,1998,39(01):45.
[29]	Bettles C J et al.[J].Scripta Materialia,2004,51(03):193.
[30]	Jeong-Pil E et al.[J].Materials Science Forum,2003,419-422(01):307.
[31]	Apps P J et al.[J].Scripta Materialia,2003,48(08):1023.
[32]	Smola B.;Stulikova I.;von Buch F.;Mordike BL. .Structural aspects of high performance Mg alloys design[J].Materials Science & Engineering, A. Structural Materials: Properties, Misrostructure and Processing,2002(1-2 Special Issue SI):113-117.
[33]	Mordike B L .[J].Journal of Materials Processing Technology,2001,117(03):391.
[34]	Buch Fvon et al.[J].Materials Science and Engineering A,1999,263(02):1.
[35]	Suzuki M et al.[J].Scripta Materialia,2003,48(08):997.
[36]	Suzuki M et al.[J].Materials Science and Engineering A,2004,387-389(1-2):706.
[37]	Weiss D.;Kaya AA.;Aghion E.;Eliezer D. .Microstructure and creep properties of a cast Mg-1.7%wt rare earth-0.3%wt Mn alloy[J].Journal of Materials Science,2002(24):5371-5379.
[38]	Grobner J et al.[J].Journal of Alloys and Compounds,2001,320(02):296.
[39]	Schmid-Fetzer R et al.[J].Advances in Engineering Materials,2001,3(12):947.
[40]	Aghion E et al.[J].Journal of The Minerals,Metals & Materials Society,2003,55(11):30.

上一张下一张

计量

下载量()
访问量()

作者相关

文章评分

您的评分：
1

0%
2

0%
3

0%
4

0%
5

0%

材料期刊网

耐热镁合金及其相图热力学研究及应用进展

Research and Applications of Heat-resistant Magnesium Alloys and Their Phase Diagrams Thermodynamics

参考文献