研究了SUS301L和CN301L奥氏体不锈钢HT(high tensile, 4/4H)和DLT(deadline tensile, 1/4H)两个硬化等级 冷轧板材的变形和应变硬化行为及其应变诱发α'马氏体转变. 所有301L冷轧板拉伸试样近断口处都发生了85 %以上的马氏 体相变, 轧制变形量增加, 室温拉伸应变诱发马氏体转变开始的应变减小, 但未增加马氏体转变饱和值. CN301L中C和N 的含量高于相同硬化等级的SUS301L, 导致它们变形和硬化行为不同. C和N的含量较高, 对γ相和α'相的固溶强化效果 增强, 冷轧奥氏体不锈钢无需发生大量马氏体转变就能达到要求的高屈服强度, 保证冷轧板材具有较好的塑性和一定的成型 能力; 此外, 形成的应变诱发马氏体中, C和N的固溶度大, 硬化效果增强, 流变应力上升快, 抗拉强度高; C和N含量 较高, 还增加奥氏体的稳定性, 将拉伸过程中应变诱发马氏体转变推迟到较高应变发生, 延长应变硬化行为的第二阶段, 增 强相变增塑效应.
Deformation and strain-hardening behaviors and strain induced martensite transformation were investigated for both commercial cold rolled 301L stainless steels, in both HT(high tensile) and LT(low tensile) work hardening grad condition at present work. Plastic strain stretching to failure at room temperature induced over 85% volume percent of martensite at all of tested steels. The higher cold rolled strain of steels, the smaller strain at which martensite transformation onset during stretching, but it didn’t increase the saturate volume fraction of martensite. Different carbon and nitrogen content lead to different deformation and strain-hardening behaviors in the same cold rolling hardened grade 301Ls. Higher carbon and nitrogen content made cold rolled steels obtain required high yield strength but with less α'-martensite, and inhere with better plasticity and plastic processing capability; Cold rolled 301L also got higher strain-hardening rate and flow stress due to α'–martensite with more carbon and nitrogen in solution. α'-Martensite transformation was deferred and elongated to higher tensile strain because of more carbon and nitrogen in austenite, enhanced TRIP of 301L cold rolled steels.
参考文献
| [1] | |
| [2] | |
| [3] | |
| [4] | |
| [5] | |
| [6] | |
| [7] | |
| [8] | |
| [9] | |
| [10] | |
| [11] | |
| [12] |
- 下载量()
- 访问量()
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%