The numerical simulation technique was applied to the casting process of a valvetype part. The moldfilling and solidification stages of the casting were numerically analyzed. The filling behavior, solidification sequence, and thermal stress distribution were reproduced and the possible defects, such as cold shut and shrinkage, were predicted. Based on the simulation result, the doublegating system was replaced by a singlegating system. Meanwhile, the chills were used to regulate the solidification sequence of casting. To eliminate the cracks in the casting, the sand core was converted into a canulate one. By modifying the original process, the defects were eliminated and the casting with good quality was obtained.
参考文献
上一张
下一张
上一张
下一张
计量
- 下载量()
- 访问量()
文章评分
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%