本文提出了基于气液环状流的水平螺旋微肋管内沸腾传热理论预测模型.在模型建立过程中,假设环状流液膜是由基底液膜和叠加扰动波液膜单元组成,将无量纲准则数Fr0=G/[gdeρv(ρl-ρv)]0.5作为汽液两相流环状流理论模型的判据建立的模型理论预测值与已由的四种不同结构的微肋管、三种有机工质下得到的实验数据进行了比较,结果表明,在Fr0＞4.0时,提出的环状流预测值理论值或者和预测值符合得较好,或者大幅度改善了原有分层流模型的预测效果,充分说明了提出的环状流理论模型的合理性.
参考文献
| [1] | 王跃社,白博峰,陈永利,Hiroshi HONDA.水平微肋管内基于分层流流型的沸腾传热理论模型[J].工程热物理学报,2005(02):249-252. |
| [2] | Taitel Y;Dukler A E .A Model for Predicting Flow Regime Transitions in Horizontal and Near Horizontal Gas-Liquid Flow[J].AICHE Journal,1980,22:47-55. |
| [3] | Brauner N;Maron D M;Dukler A M .Modeling of Wavy Flow in Inclined Thin Films in the Presence of Interfacial Share[J].Chemical Engineering Science,1985,40(06):923-937. |
| [4] | Jayanti S;Hewitt G F .Hydrodynamics and Heat Transfer in Wavy Annular Gas-Liquid:A Computational Fluid Dynamics Study[J].International Journal of Heat and Mass Transfer,1997,40(10):2445-2460. |
| [5] | A. Wolf;S. Jayanti;G. F. Hewitt .On the nature of ephemeral waves in vertical annular flow[J].International Journal of Multiphase Flow,1996(2):325-333. |
| [6] | Collier J G;Thome J R.Convective Boiling and Condensation[M].Oxford:Clarendon Press,1994 |
| [7] | J Yu;S Koyama;S Momoki .Experimental Study of Flow Boiling Heat Transfer in A Horizontal Microfin Tube[R].Kyushu University,1995. |
| [8] | D Del Col;R L Webb;R Narayanamurthy .Heat Transfer Mechanisms for Condensation and Vaporization Inside A Microfin Tube[J].Journal of Enhanced Heat Transfer,2002,9:25-37. |
| [9] | A Miyara;Y Otsubo;S Ohtsuka.Evaporation Heat Transfer of R410A in Herrngbone Micro-Fin Tubes[A].Paderborn,Germany,2001:314-319. |
上一张
下一张
上一张
下一张
计量
- 下载量()
- 访问量()
文章评分
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%