欢迎登录材料期刊网

材料期刊网

高级检索

以经过聚乙烯吡咯烷酮(PVP)进行表面修饰的聚苯乙烯(PS)微球为内核,在碱性条件下采用溶胶?凝胶法在PS微球直接包覆SiO 2,制备有机/无机PS/SiO 2复合微球,通过控制反应体系中正硅酸乙酯(TOES)的浓度来控制复合微球中氧化硅的质量分数,并借助原子力显微镜(AFM)考察了PS/SiO 2复合磨料对硅热氧化片的抛光特性,初步分析有机/无机复合磨料的非刚性力学特性对抛光质量的影响。透射电镜(TEM)结果显示:复合微球具有草莓状核壳包覆结构,其氧化硅壳层是由SiO 2纳米颗粒所组成;热失重分析(TGA)表明:样品中氧化硅含量为12%~69%(质量分数)。AFM测试结果表明:复合磨料中氧化硅的含量对抛光后晶片的微观形貌、粗糙度及表面轮廓具有明显的影响。

The polyvinylpyrrolidone (PVP) modified polystyrene (PS) microspheres were first synthesized by soap-free emulsion polymerization method, and the SiO2 nanoparticles were subsequently coated on the surfaces of the PS cores by sol-gel method in alkaline NH4OH/ethanol solutions. The silica content of composite microspheres can be controlled by adjusting the concentration of tetraethoxysilane (TEOS) in the reaction system. The oxide chemical mechanical polishing (CMP) behavior of as-prepared PS/SiO 2 composite abrasives was investigated by atomic force microscopy (AFM). The effect of non-rigid mechanical property of organic/inorganic composite abrasives on the CMP behavior was also discussed. TEM results show that the composite microspheres exhibits core/shell structure with strawberry-like morphology, and the silica shell is composed by SiO2 nanoparticles. Thermogravimetric analysis (TGA) results indicate that the silica contents in the composite microspheres range from 12%to 69%(mass fraction). AFM tests results indicate that there is obvious effect of the silica content of the composite abrasives on the roughness values, topographies and profilograms of the polished wafer surfaces.

参考文献

[1] Feng XD;Sayle DC;Wang ZL;Paras MS;Santora B;Sutorik AC;Sayle TXT;Yang Y;Ding Y;Wang XD .Converting ceria polyhedral nanoparticles into single-crystal nanospheres[J].Science,2006(5779):1504-1508.
[2] Mahadevaiyer Krishnan;Jakub W. Nalaskowski;Lee M. Cook .Chemical Mechanical Planarization: Slurry Chemistry, Materials, and Mechanisms[J].Chemical Reviews,2010(1):178-204.
[3] Veera Dandu, P.R.;Penta, N.K.;Babu, S.V. .Novel α-amine-functionalized silica-based dispersions for selectively polishing polysilicon and Si(100) over silicon dioxide, silicon nitride or copper during chemical mechanical polishing[J].Colloids and Surfaces, A. Physicochemical and Engineering Aspects,2010(1/3):131-136.
[4] Veera Dandu, P.R.;Penta, N.K.;Peethala, B.C.;Babu, S.V. .Novel phosphate-functionalized silica-based dispersions for selectively polishing silicon nitride over silicon dioxide and polysilicon films[J].Journal of Colloid and Interface Science,2010(1):114-118.
[5] Hong Lei;Xin Wu;Ruling Chen .Preparation of porous alumina abrasives and their chemical mechanical polishing behavior[J].Thin Solid Films: An International Journal on the Science and Technology of Thin and Thick Films,2012(7):2868-2872.
[6] Hu Li;Hong Lei;Ruling Chen .Preparation of porous Fe_2O_3/SiO_2 nanocomposite abrasives and their chemical mechanical polishing behaviors on hard disk substrates[J].Thin Solid Films: An International Journal on the Science and Technology of Thin and Thick Films,2012(19):6174-6178.
[7] Hong Lei;Lei Jiang;Ruling Chen.Preparation of copper-incorporated mesoporous alumina abrasive and its CMP behavior on hard disk substrate[J].Powder Technology: An International Journal on the Science and Technology of Wet and Dry Particulate Systems,2012:99-104.
[8] Yan Li;Mcnglian Gong;Karpagavalli Ramji .Role of Cu-Benzotriazole Nanoparticles in Passivation Film Formation[J].The journal of physical chemistry, C. Nanomaterials and interfaces,2009(42):18003-18013.
[9] Armini S;Whelan CM;Maex K;Hernandez JL;Moinpour M .Composite polymer-core silica-shell abrasive particles during oxide CMP[J].Journal of the Electrochemical Society,2007(8):H667-H671.
[10] ARMINI S;WHELAN C M;MOINPOUR M;MAEX K .Copper CMP composite polymer core-silica shell abrasives:A defectivity study[J].Journal of the Electrochemical Society,2009,156(01):18-26.
[11] Lei Zhang;Haibo Wang;Zefang Zhang;Fei Qin;Weili Liu;Zhitang Song .Preparation of monodisperse polystyrene/silica core-shell nano-composite abrasive with controllable size and its chemical mechanical polishing performance on copper[J].Applied Surface Science,2011(3):1217-1224.
[12] Weibin Mu;Meng Fu .Synthesis of non-rigid core-shell structured PS/SiO_2 composite abrasives and their oxide CMP performance[J].Microelectronic engineering,2012(Aug.):51-55.
[13] Ioannis A. Kartsonakis;Penelope Liatsi;Ioannis Daniilidis .Synthesis, Characterization, and Antibacterial Action of Hollow Ceria Nanospheres with/without a Conductive Polymer Coating[J].Journal of the American Ceramic Society,2008(2):372-378.
[14] A.Yu.Menshikova;T.G.Evseeva;Yu.O.Skurkis .Monodisperse carboxylated polystyrene particles:synthesis,electrokinetic and adsorptive properties[J].Polymer: The International Journal for the Science and Technology of Polymers,2005(4):1417-1425.
[15] 刘立柱,马红杰,朱兴松,金镇镐,樊渝江.聚乳酸/纳米二氧化硅原位复合材料的制备和性能[J].北京化工大学学报(自然科学版),2008(01):66-69.
[16] ST?BER W;FINK A .Controlled growth of monodisperse silica spheres in the micron size range[J].Journal of Colloid and Interface Science,1968,26(01):62-69.
[17] Wang, X.-D.;Shen, Z.-X.;Sang, T.;Cheng, X.-B.;Li, M.-F.;Chen, L.-Y.;Wang, Z.-S. .Preparation of spherical silica particles by St?ber process with high concentration of tetra-ethyl-orthosilicate[J].Journal of Colloid and Interface Science,2010(1):23-29.
[18] 邹华,吴石山,沈健.单分散PS/SiO2纳米复合微球的制备与表征[J].高分子学报,2009(03):268-272.
[19] 邹华,吴石山,沈健.单分散空心SiO2纳米微球的合成与表征[J].化学学报,2009(03):266-269.
[20] 陈敏 .聚合物/SiO<,2>有机-无机纳米复合微球的制备与表征[D].复旦大学,2006.
[21] Armini, S;Whelan, CM;Maex, K .Engineering polymer core-silica shell size in the composite abrasives for CMP applications[J].Electrochemical and solid-state letters,2008(10):H280-H284.
[22] 陈杨,穆为彬,陆锦霞.核壳结构PS/CeO2复合微球弹性模量的AFM测定[J].摩擦学学报,2012(01):7-13.
[23] Ellen Wachtel;Igor Lubomirsky .The elastic modulus of pure and doped ceria[J].Scripta materialia,2011(2):112-117.
[24] Armini S;Vakarelski IU;Whelan CM;Maex K;Higashitani K .Nanoscale indentation of polymer and composite polymer-silica core-shell submicrometer particles by atomic force microscopy[J].Langmuir: The ACS Journal of Surfaces and Colloids,2007(4):2007-2014.
[25] 王永光 .基于分子量级的化学机械抛光材料去除机理的理论和试验研究[D].无锡:江南大学,2008.
上一张 下一张
上一张 下一张
计量
  • 下载量()
  • 访问量()
文章评分
  • 您的评分:
  • 1
    0%
  • 2
    0%
  • 3
    0%
  • 4
    0%
  • 5
    0%