陶瓷浆料流变性能是注凝成型工艺的关键,注凝成型要求浆料固含量高,粘度低.本文主要研究了固相含量、浆料pH值、分散剂、交联剂、单体等在制备低粘度高固含量氧化锆陶瓷浆料时,对浆料流变性的影响.实验结果表明:控制浆料的pH值为10左右,加入0.3wt％聚丙烯酸铵作为分散剂、1 wt％ AM作为单体,单体和交联剂比例为20∶1时,可制得粘度为2.12 Pa·s、流动性好适宜于复杂形状制品注模的陶瓷浆料.
参考文献
| [1] | 黄勇;张立明;杨金龙;谢志鹏;汪长安;陈瑞峰.先进陶瓷胶态成型新工艺的研究进展[J].硅酸盐学报,2007(2):129-136. |
| [2] | Bocanegra-Bernal, MH;Matovic, B.Dense and near-net-shape fabrication of Si3N4 ceramics[J].Materials Science and Engineering. A, Structural Materials: Properties, Microstructure and Processing,20091/2(1/2):130-149. |
| [3] | 王金锋;高雅春;谢志鹏;孙加林.pH值对ZrO2超细粉体料浆性能的影响[J].人工晶体学报,2007(1):70-75. |
| [4] | 焦宝祥;丘泰;李纯成;沈春英;徐洁.浆料的固相含量对注凝成型氧化锆增韧氧化铝陶瓷的影响[J].硅酸盐学报,2004(9):1165-1169. |
| [5] | Carolina Tallon;Dariusz Jach;Rodrigo Moreno.Gelcasting of alumina suspensions containing nanoparticles with glycerol monoacrylate[J].Journal of the European Ceramic Society,20095(5):875-880. |
| [6] | H. Akhondi;E. Taheri-Nassaj;A. Taavoni-Gilan.Gelcasting of alumina-zirconia-yttria nanocomposites with Na-alginate system[J].Journal of Alloys and Compounds: An Interdisciplinary Journal of Materials Science and Solid-state Chemistry and Physics,20091/2(1/2):452-457. |
| [7] | 刘昊;沈春英;丘泰.注凝成型工艺的研究进展[J].中国陶瓷,2011(3):1-3,24. |
| [8] | 高雅春;杜蛟;吕秀玲.超细二氧化锆注凝成形料浆流变性研究[J].陶瓷,2007(7):18-20. |
| [9] | 刘晓光;李国军;仝建峰;陈大明.8%Y2O3-ZrO2水基料浆的流变性质研究[J].硅酸盐学报,2003(10):923-927. |
| [10] | Wan, W.;Yang, J.;Zeng, J.;Qiu, T..Gelcasting of fused silica glass using a low-toxicity monomer DMAA[J].Journal of Non-Crystalline Solids: A Journal Devoted to Oxide, Halide, Chalcogenide and Metallic Glasses, Amorphous Semiconductors, Non-Crystalline Films, Glass-Ceramics and Glassy Composites,2013:229-234. |
| [11] | Lewis J.A.;,.Colloidal Processing of Ceramic[J].Journal of the American Ceramic Society,200010(10):2341-2359. |
| [12] | 许海仙;丘泰.氧化锆陶瓷注凝成型工艺的研究进展[J].电子元件与材料,2010(5):71-74. |
| [13] | 郭文利;徐廷献;燕青芝;葛昌纯.N-羟甲基丙烯酰胺聚合体系注凝成型纳米氮化硅陶瓷[J].硅酸盐学报,2006(2):147-151. |
| [14] | Zhang, C.;Qiu, T.;Yang, J.;Guo, J..The effect of solid volume fraction on properties of ZTA composites by gelcasting using DMAA system[J].Materials Science & Engineering, A. Structural Materials: Properties, Misrostructure and Processing,2012:243-249. |
| [15] | 焦宝祥;丘泰;沈春英;徐洁.ZTA陶瓷注凝成型浆料流变性能的研究[J].材料工程,2004(1):25-28. |
| [16] | 王永刚;孙琦;马峻峰;陶建涛;朱志斌;鄢伟哲;王娜.氧化锆陶瓷的凝胶注模成型研究[J].硅酸盐通报,2006(1):6-9. |
上一张
下一张
上一张
下一张
计量
- 下载量()
- 访问量()
文章评分
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%