为考察脱胶缺陷对整体化结构在面外拉伸载荷下承载能力的影响,实验研究了脱胶形状、间距、位置和尺寸对L形接头拉脱强度的影响规律,定量评估了脱胶对L形接头拉脱强度的影响程度,提出了脱胶缺陷对L形接头拉脱强度影响的定量表征参数。结果表明,L形接头的拉脱强度对脱胶形状、脱胶间距的变化不敏感,对脱胶位置和脱胶尺寸的变化较为敏感;位于填充区所在胶接面区域的脱胶对L形接头拉脱强度影响最大;随着脱胶尺寸特别是填充区所在胶接面脱胶尺寸的增大,拉脱强度显著降低。
To investigate the influence of debondings on the bearing capacity of integral composite structures under pull-off load condition,the influence of debonding shape,debongding space,debonding location and debonding size on the tensile strength of composite L-joints was researched with a quantitative evaluation.An important characterization parameter about the influence of debonding was proposed.The results indicate that the tensile strength of L-joints shows little sensitive change for debonding shape and debonding space.But an obvious influence of debonding location and debonding size on the tensile strength of L-joints is found,especially debonding close to the stiffener core/skin interface has the most significantly influence on the tensile strength of L-joints.The tensile strength decreases with the debonding size increasing,especially with the debonding size in the stiffener core/skin interface increasing.
参考文献
| [1] | Wang Xueming, Zhang Zuoguang, Xie Fuyuan, Li Min. Correlated rules between complex structure of composite components and manufacturing defects in autoclave molding technology [J]. Journal of Reinforced Plastics and Composites, 2009, 28(22): 2791-2803. |
| [2] | Pavier M J, Chester W T. Compression failure of carbon fibre-reinforced coupons containing central delaminations [J]. Composites, 1990, 21(1): 23-31. |
| [3] | Riccio A, Scaramuzzino F, Perugini P. Embedded delamination growth in composite panels under compressive load [J]. Composites: Part B, 2001, 32: 209-218. |
| [4] | Chen Haoran, Sun Xiannian. Residual compressive strength of laminated plates with delamination [J]. Composite Structures, 1999, 47: 711-717. |
| [5] | Freitas de M, Carvalho de R. Residual strength of a damaged laminated CFRP under compressive fatigue stresses [J]. Composites Science and Technology, 2006, 66: 373-378. |
| [6] | 程小全, 王 进, Ali Al-Mansour, 等. 含矩形边缘分层缺陷层合板的压缩性能 [J]. 复合材料学报, 2007, 24(2): 151-158. |
| [7] | 任浩雷, 刘元镛, 矫桂琼. 含预制分层损伤复合材料层合板在压缩载荷下破坏过程和剩余强度的模拟 [J]. 工程力学, 2002, 19(6): 110-114. |
| [8] | 陈群志, 关志东, 王 进. 分层缺陷对复合材料结构疲劳寿命影响研究 [J]. 机械强度, 2004, 26(S): 121-123. |
| [9] | 陈丽华, 徐元铭, 刘 博. 复合材料分层问题中界面层方面的数值研究 [J]. 复合材料学报, 2010, 27(3): 144-149. |
- 下载量()
- 访问量()
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%