Based on the deformation characteristics of Y-type mill, this paper proposes a finite element model for dynamically simulating the formation process of shaped steel tube for driving shaft. The distributions of stress and strain were obtained from the simulation. The outer diameter and transverse wall thickness were also analyzed quantitatively. Experiment was done on Y-type mill. A comparison between simulation results and experiment results shows that the simulating results of shaped steel tube are in good agreement with the on-site data. The model could provide the basis for theoretical research and engineering applications of shaped steel tube rolling process.
参考文献
上一张
下一张
上一张
下一张
计量
- 下载量()
- 访问量()
文章评分
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%