Four castings with different modulus have been designed to simulate different thickness sections of a turbine blade during casting process. The microstructure has been observed by optical microscopy (OM) and scanning electron microscopy (SEM). The micro-segregation was tested by energy dispersive spectroscopy (EDS) and the macro-segregation was analyzed by using Metalscan 2500 spectrometers. The experimental results show that the microstructure of casting is affected by modulus apparently. The smaller the modulus, the finer the microstructure. The average grain size of castings with modulus of 0.29, 1.57, 3.16 and 5.0 mm is 0.3, 1.5, 2.7 and 4.3 mm, and the volume fraction of eutectic is 0, 0.1%, 0.2% and 1.0%, respectively. The micro/macro segregation is affected by the modulus apparently. The smaller the modulus, the lower the segregation level. When the modulus of casting increases, the content of Al increases, while the content of W, Cr and Mo decreases both in inner grain and near grain boundary. The content of Al and Mo in inner grain is higher than that near grain boundary, while the content of Cr and W in inner grain is lower than that near grain boundary.
参考文献
| [1] | |
| [2] | Y.X. Zhu: Trans. Metal Heat Treat., 1997, 18(3), 16. (in Chinese)[2 ] K.Y. Cheng, C.Y. Jo, D.H. Kim, T. Jin and Z.Q. Hu: Mater. Charact., 2009, 60, 210.[3 ] Y.M. Qiu and Y.X. Zhu: Acta Metall. Sin., 1989, 25(1), 78. (in Chinese)[4 ] E.C. Caldwell, F.J. Fela and G.E. Fuchs: Superalloys 2004, TMS, 2004, 811.[5 ] J.C. Han: Int. J. Rotating Machinery, 2004, 10(6), 443.[6 ] N. Chiyuki, C. Kazuyoshi and M. Shinsuke: IHI Eng. Rev., 2005, 38(2), 63.[7 ] J.C. Han and S. Ekkad: Int. J. Rotating Machinery, 2001, 7(1), 21.[8 ] G. Cerri, A. Giovannelli, L. Battisti and R. Fedrizzi: Appl. Therm. Eng., 2007, 27, 692.[9 ] M. Ni, H.R. Zhu, Y. Qiu, D.C. Xu and S.L. Liu: Gas Turbine Technol., 2005, 18(4), 25. (in Chinese)[10] R.C. Reed: Superalloys, Cambridge University Press, Cambridge, 2006.[11] J. Campbell: Castings, Reed Educational and Professional Publishing, 2000, 180.[12] S.A. Sajjadi, H.R. Elahifar and H. Farhangi: J. Alloy. Compd. 2008, 455, 215.[13] G.F. Tian, C.C. Jia, Y. Wen and B.F. Hu: J. Uni. Sci. Technol. Beijing, 2008, 15(6), 729.[14] G. Lesoult, V. Albert, B. Appolaire, H. Combeau, D. Daloz, A. Joly, C. Stomp, G.U. GrÄ |
- 下载量()
- 访问量()
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%