通过添加不同烧结助剂(Lu2O3、Y2O3和Al2O3)及β-Si3N4粉末含量,采用常压烧结工艺制备出性能优异的多孔氮化硅陶瓷.研究了烧结助剂种类及β-Si3N4添加量对多孔氮化硅陶瓷物相、微观组织和力学性能的影响.结果表明:当Lu2O3添加量为5 wt%、β-Si3N4为3 wt%时,制备了由长柱状β-Si3N4晶粒组成、平均长径比为6.87、直径为0.6μm长度为4.4～10.4 μm的多孔氮化硅陶瓷,其抗弯强度可达330.7 MPa.β-Si3N4添加量至5 wt%时,柱状晶粒发育良好,长径比增加至7以上,气孔率高达48%,但抗弯强度下降.
参考文献
| [1] | 李军奇,周万城,罗发,朱振峰,马建中.制备工艺对多孔Si3N4陶瓷介电性能的影响[J].硅酸盐学报,2009(08):1443-1446. |
| [2] | Akimune Y;Munakata F;Okamoto Y et al.Temperature Dependence of Impact Damage in a Si3 N4 Disk by a Spherical Particle[J].Nippon Seramikkusu Kyokai Gakujutsu Ronbunshi / Journal of the Ceramic Society of Japan,1997,105(01):93-96. |
| [3] | Akimune Y;Hirosaki N;Ogasawara T .Mechanical Properties of SiC-Particle/Sialon Composites[J].Journal of Materials Science Letters,1991,10:223-226. |
| [4] | Wang CM.;Ruhle M.;Riley FL.;Mitomo M.;Pan XQ. .SILICON NITRIDE CRYSTAL STRUCTURE AND OBSERVATIONS OF LATTICE DEFECTS [Review][J].Journal of Materials Science,1996(20):5281-5298. |
| [5] | Ramnesh R;Nestor E;Pomeroy M J et al.Formation of Ln-Si-Al-O-N Glasses and Their Properties[J].Journal of the European Ceramic Society,1997,17:1933-1939. |
| [6] | Hampshire S. .Oxynitride glasses, their properties and crystallisation - a review[J].Journal of Non-Crystalline Solids: A Journal Devoted to Oxide, Halide, Chalcogenide and Metallic Glasses, Amorphous Semiconductors, Non-Crystalline Films, Glass-Ceramics and Glassy Composites,2003(1):64-73. |
| [7] | Li W K;Zhang D Y;Zhuang H R et al.Effect of Rare-Earth Oxide Additives on the Morphology of Combustion Synthesized Rod-Like -Si3 N4 Crystals[J].Materials Letters,2004,58(17-18):2322-2325. |
| [8] | Mitomo M;Yang N;Kishi Y et al.Influence of Powder Chazacteristics on Gas Pressure Sintering of Si3N4[J].Journal of Materials Science,1988,23(09):3413-3419. |
| [9] | Hirozaki N;Akimune Y .Effect of Grain Growth of β-Silicon Nitride on Strength,Weibull Modulus and Fracture Toughness[J].Journal of the American Ceramic Society,1993,76(07):1892-1894. |
| [10] | Emoto H;Mitom M .Control and Characterization of Abnormally Grown Grains in Silicon Nitride Ceramics[J].Journal of the European Ceramic Society,1997,17(06):797-804. |
| [11] | 董文麟.氮化硅陶瓷[M].北京:中国建筑工业出版社,1987:56-57. |
| [12] | 江东亮.精细陶瓷材料[M].北京:中国物资出版社,2000:87. |
| [13] | Hwang C H;Tien T Y;Chen I W;Somiya S,Shimada M,Yashimura M,Watanabe R.Sintering 87[M].Elsevier,Barking,Essex,England,1988:1034-1039. |
| [14] | Heinrich J;Bacher E;Bohmer M .Hot lsesetic Pressing of Si3N4 Powder Compacts and Reaction-Bonded Si3 N4[J].Journal of the American Ceramic Society,1988,71(01):C28-C31. |
| [15] | Coble R L;Kingery W D .Effect of Porosity on Physical Properties of Sintered Alumina[J].Journal of the American Ceramic Society,1956,39:377-385. |
| [16] | 陕绍云,杨建锋,高积强,张文辉,金志浩.用碳热还原法制备多孔氮化硅陶瓷[J].无机材料学报,2006(04):913-918. |
| [17] | Hwang S L;Chen I W .Nucleation and Growth of α-SiA1ON onα-Si3N4[J].Journal of the American Ceramic Society,1994,77(07):1711-1718. |
| [18] | 陆佩文.无机材料科学基础[M].武汉:武汉理工大学出版社,2001:295. |
上一张
下一张
上一张
下一张
计量
- 下载量()
- 访问量()
文章评分
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%