分析了常规锻造和特种锻造工艺及不同热处理工艺对TCll钛合金组织和力学性能的影响。结果表明：特种锻造后得到的锻态组织为少量球状α相、细板条α相与β相构成的网篮组织，热处理后的力学性能明显高于常规锻造的；钛合金经特种锻造结合高温均匀化与双重退火处理可得到由12％（体积分数）左右球状初生α相、一定宽长比条状初生α相和β相组成的网篮组织，可使其获得良好的强韧性匹配。
The microstructure and mechanical properties of TCll titanium alloy after general and special forging and different heat treatment processes were analyzed. The results show that basket weave microstructure constituted of a small amount of equiaxed a phase, thin lath a phase and β phase could be got after special forging, and the mechanical properties were obviously superior to that of general forging. Basket weave microstructure which was made up of 12vo1% equiaxed α phase, lath α phase and β phase with a ratio of width and length could be got in TCll titanium alloy by special forging combining with high temperature homogenization and double annealing treatment, and the excellent strength and toughness were got.
参考文献
| [1] | 郭鸿镇,姚泽坤,施祥生.TC11钛合金叶片组织和性能控制[J].航空学报,1997(02):189. |
| [2] | 陈军 .新型两相钛合金Ti700锻件组织性能研究[D].西北工业大学,2005. |
| [3] | 于兰兰,毛小南,张鹏省,赵永庆,袁少冲.热处理工艺对BT22钛合金组织和性能的影响[J].稀有金属快报,2005(03):21-23. |
| [4] | 张蔚,张树启,杨海瑛,李明强.加工及热处理条件对Ti-26合金组织与力学性能的影响[J].稀有金属快报,2002(12):17-18. |
- 下载量()
- 访问量()
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%