Solution Combustion Synthesis of TiO2 and Its Use for Fabrication of Photoelectrode for Dye-sensitized Solar Cell

材料科学技术（英文）, 2012, 28(8): 713-722.

Solution Combustion Synthesis of TiO2 and Its Use for Fabrication of Photoelectrode for Dye-sensitized Solar Cell

^1, , ^2,

1.Department of Chemical Engineering, National Cheng Kung University, Tainan 70101, Taiwan, China／Advanced Optoelectronic Technology Center, National Cheng Kung University, Tainan 70101, Taiwan, China

2.Department of Chemical Engineering, National Cheng Kung University, Tainan 70101, Taiwan, China

基金项目: Acknowledgements Support of this research by the National Science Coun- cil of Taiwan under Grant No. NSC 100-2221-E-006-214 and partial support under Contract No. 101-D0204-6 by the Bureau of Energy, Ministry of Economic Affairs of Tai- wan and the LED Lighting Research Center, NCKU are gratefully acknowledged. The authors also thank Profes- sor Chien-Hsin Yang (National University of Kaohsiung) for his assistance in fabrication of the photoelectrodes and assembling of the DSSC

关键词：染料敏化太阳能电池 , TiO2 , 光电极 , 溶液 , 燃烧法 , 制备 , 纳米粉末 , 燃烧合成

Solution Combustion Synthesis of TiO2 and Its Use for Fabrication of Photoelectrode for Dye-sensitized Solar Cell

Keywords： TiO2 , Combustion synthesis , Dye-sensitized solar cells ,

Three different types of TiO2 nano powders were synthesized by a solution combustion synthesis （SCS） method using three different fuels and for comparison, another type of Ti2 nano powder was synthesized by calcination of titanyl hydroxide. These TiO2 nano powders were used to fabricate photoelectrodes for the dye-sensitized solar cell （DSSC） and their performance was compared to that of the DSSC fabricated with Degussa P25 TiO2. The results showed that the SCS TiO2 could work well as photoelectrode for DSSC. The SCS TiO2 contained impurities of C and/or S, thus exhibiting visible light absorption and reduced band gap. The open circuit voltage and the fill factor both varied little among the various TiO2 and thus both had little effect on the photoelectrical conversion efficiency （η）. However, the variation of r/was seen to be in quite a good agreement with that of the short circuit current （Isc）, suggesting that r/was dominated by Isc. lsc was found to be enhanced by light scattering effect due to the presence of large particles but reduced by high impurity content due to an increase in electron transfer resistance. In addition, the specific surface area of the powders was found to be an important factor affecting the Isc and thus the η.

参考文献

[1]	K.Nagaveni;M.S.Hegde;N.Ravishankar;G.N.Subbanna;Giridhar Madras .Synthesis and Structure of Nanocrystalline TiO_2 with Lower Band Gap Showing High Photocatalytic Activity[J].Langmuir: The ACS Journal of Surfaces and Colloids,2004(7):2900-2907.
[2]	G.Sivalingam;K.Nagaveni;M.S.Hegde;Giridhar Madras .Photocatalytic degradation of various dyes by combustion synthesized nano anatase TiO_2[J].Applied Catalysis, B. Environmental: An International Journal Devoted to Catalytic Science and Its Applications,2003(1):23-38.
[3]	S. Agarwala;M. Kevin;A. S. W. Wong .Mesophase Ordering of TiO2 Film with High Surface Area and Strong Light Harvesting for Dye-Sensitized Solar Cell[J].ACS applied materials & interfaces,2010(7):1844-1850.

上一张下一张

计量

下载量()
访问量()

作者相关

在本站搜索
在百度学术搜索
在万方数据库搜索
在CNKI搜索

文章评分

您的评分：
1

0%
2

0%
3

0%
4

0%
5

0%

材料期刊网

Solution Combustion Synthesis of TiO2 and Its Use for Fabrication of Photoelectrode for Dye-sensitized Solar Cell

Solution Combustion Synthesis of TiO2 and Its Use for Fabrication of Photoelectrode for Dye-sensitized Solar Cell

参考文献