采用等离子喷涂技术制备了两种颗粒度的Al2O3-13％ TiO2防滑涂层.采用扫描电镜(SEM)、x射线衍射仪(XRD)等对涂层的组织结构进行了表征,利用FW14往复摩擦试验机测定涂层的防滑性能,通过MMS-1G高速摩擦试验机评价了涂层摩擦学行为.结果表明,涂层致密度较高,两种涂层晶相都以γ-Al2O3为主并含有一定量非晶相;涂层防滑性能良好;两种涂层耐磨性能良好,低速时涂层失效形式以颗粒“拔出”为主,随着速度增加,层间裂纹扩展引起的层片剥落主导了涂层的磨损失效.
参考文献
| [1] | Ko, YK;Yoo, S;Moon, KI;Lee, WB;Kim, SW;You, YZ .Plasma nitrosulfurizing techniques for low friction coefficient with H2S and C3H8 gas addition[J].Surface & Coatings Technology,2008(22/23):5501-5504. |
| [2] | V.Yu. Fominski;R.I. Romanov;A.V. Gusarov;J.-P. Celis .Pulsed laser deposition of antifriction thin-film MoSex coatings at the different vacuum conditions[J].Surface & Coatings Technology,2007(18):7813-7821. |
| [3] | J. F Ferrero;E. Yettou;J. J. Barrau;S. Rivallant .Analysis of a dry friction problem under small displacements: application to a bolted joint[J].Wear: an International Journal on the Science and Technology of Friction, Lubrication and Wear,2004(11/12):1135-1143. |
| [4] | M. Bezzazi;A. Khamlichi;A. Jabbouri .Experimental characterization of frictional behaviour of clutch facings using Pin-on-disk machine[J].Materials & Design,2007(7):2148-2153. |
| [5] | Ch. Affolter;G. Piskoty;R. Koller .Fatigue in the shell of a conveyor drum[J].Engineering failure analysis,2007(6):1038-1052. |
| [6] | 李全 .驱动滚筒仿生表面增摩技术研究[D].山东科技大学,2010. |
| [7] | 宋世红,张学卿.防滑涂料概论[J].中国涂料,2009(07):60-63. |
| [8] | 宋仁国,王超,姜彦,卢果.等离子喷涂Al2O3/TiO2纳米陶瓷复合涂层的微观结构及性能[J].材料热处理学报,2012(z2):145-150. |
| [9] | 王志平,林小娉,贾鹏,丁坤英.等离子喷涂热障涂层热震失效过程及残余应力分析[J].材料热处理学报,2012(04):116-120. |
| [10] | 王桂兰,熊凡,芮道满,张海鸥.固/液相等离子喷涂制备固体氧化物燃料电池复合电极[J].材料工程,2011(07):6-9. |
| [11] | 高亚丽,熊党生.医用镁合金等离子喷涂羟基磷灰石涂层研究[J].材料热处理学报,2011(01):109-113. |
| [12] | C. Wilhelm;G. LaCaille;N. Wright .Mechanical properties and microstructure characterization of coated AM2 Al 6061-T6 mats exposed to simulated thermal blast[J].Engineering failure analysis,2009(1):1-10. |
| [13] | Sulit R A;Call E;Hubert D .Arc sprayed aluminium composite non-skid coating for airfield landing mats[J].SURFACE ENGINEERING,1994,10(01):36-39. |
| [14] | 靳生,刘谦,戴庆荣.电弧喷涂制备Al-Al2O3耐磨防滑涂层工艺优化和摩擦学性能研究[J].中国表面工程,2003(02):10-12,16. |
| [15] | R. Yilmaz;A.O. Kurt;A. Demir .Effects of TiO_2 on the mechanical properties of the Al_2O_3-TiO_2 plasma sprayed coating[J].Journal of the European Ceramic Society,2007(2/3):1319-1323. |
| [16] | 韩耀武 .等离子喷涂复合材料涂层的组织与性能研究[D].吉林:吉林大学,2010. |
| [17] | 朱万章.摩擦与防滑涂料[J].涂料工业,2002(08):34-37. |
上一张
下一张
上一张
下一张
计量
- 下载量()
- 访问量()
文章评分
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%