采用硬度和电导率测试、光学显微镜和扫描电镜观察等方法研究了固溶态和时效态下铜铬合金的搅拌摩擦焊焊接接头的组织与性能。结果表明：铜铬合金搅拌摩擦焊接接头不同区域的显微组织有明显的差异；固溶态合金接头硬度最高值出现在焊核区，为78HB，距离焊缝中心越远硬度越低，电导率越小；时效态合金接头硬度最低值出现在热影响区，为91HB，电导率由基体到焊核区逐渐减小。
The solid-solution treated and aged Cu-Cr alloy were welded by friction stir welding respectively, and the microstrueture and mechanical properties of welded joints were studied by hard test, electrical conductivity test, optical microscopy and scanning electron microscopy. The results show that the difference of microstructure between different zones in welded joint of friction stir welding for Cu-Cr alloy was distinct. The hardness value of weld nugget zone, 78 HB, in the joint of solid-solution treated alloy was highest, the farther to the welded seam center, the lower of the hardness and the electrical conductivity. The hardness value of HAZ, 91 HB, in the joint of aged alloy was lowest, and the electrical conductivity dropped gradually from matrix to welded nugget zone.
参考文献
| [1] | 辜纯民,邓卫华,杨成刚,柯黎明,黄春平.搅拌摩擦焊工艺参数对LY12铝合金接头组织和力学性能的影响[J].机械工程材料,2008(06):22-24. |
| [2] | 马凤仓,倪锋,杨涤心.铜铬合金制备方法研究现状[J].材料开发与应用,2002(03):35-38. |
| [3] | 宋练鹏,尹志民,李周.Cu-Cr合金时效处理工艺及其强化机制的定量探讨[J].矿冶工程,2005(01):60-61,64. |
| [4] | 刘会杰,匡玲艺,沈俊军,黄永宪,吴宝泉.铜的搅拌摩擦焊研究[J].焊接,2009(01):11-15. |
| [5] | 刘平,黄金亮,曹兴国.快速凝固高强度高导电Cu-Cr合金的组织和性能[J].兵器材料科学与工程,1999(01):12. |
| [6] | 帅歌旺,张萌,黄惠珍.Cu-Cr合金强化机制研究及其对导电性能的影响[J].铸造技术,2007(03):396-398. |
- 下载量()
- 访问量()
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%