利用磁过滤阴极电弧镀在硬质合金上沉积厚度约2~3 μm的TiAlN薄膜，并用MEVVA源离子对TiAlN薄膜注入金属离子V+和Nb+。应用北京同步辐射装置（BSRF）的同步辐射光源，采用掠入射X射线衍射（GIXRD）的方法对TiAlN薄膜表面离子注入层的微观结构进行分析研究。结果表明：未经过离子注入的TiAlN薄膜主要组成相是没有择优取向的Ti3AlN伴有少量AlN，而较小剂量(1×1017 ions/cm2)的离子注入都可以使Ti3AlN产生（111）上的择优取向和细化晶粒，且AlN消失；当离子注入的剂量达到5×1017 ions/cm2时，注入V+的Ti3AlN择优取向变为（210），并产生TiN相；注入Nb+ 的各个衍射峰完全消失，说明TiAlN薄膜表面离子注入层被非晶化，结合透射电镜的研究结果，观察到非晶层的厚度约为80~100 nm。
The synchrotron radiation grazing incident Xray diffraction (GIXRD) method was applied to analyze the microstructure of the TiAlN films, which was implanted with V+ and Nb+ by MEVVA at different dosages after deposited on the cemented carbide (WCCo) by Magnetic Filter Arc Ion Plantation into 2~3 μm. The result shows that: the principal phase in the TiAlN film without implantation is the unpreferred orientation Ti3AlN with a small amount of AlN. Nevertheless, when implanted with minor dosage (1×1017 ions/cm2), the grain would be refined and preferred orientation in crystal face(111) arises, while AlN disappears，when the dosage reaches 5×1017 ions/cm2 ,the preferred orientation turns into (210) implanted with V+ ,and a considerable amount of TiN emerges with Nb+ , all the peaks completely vanish，combining with the TEM result , it is observed that the thickness of amorphous is about 80~100 nm .
参考文献
- 下载量()
- 访问量()
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%