欢迎登录材料期刊网

材料期刊网

高级检索

In nuclear plant the protection of the H(2)BO(4) solution seal areas of AISI 316L austenitic steel is accomplished by Stellite 6 plasma cladding layer. Wear defects created in service required the part to be replaced or repaired. No existing repair technologies were practical. Electrospark deposition (ESD) was to repair defects, enabling the parts to be placed back in service. In this paper the authors report the results obtained depositing directly a layer of Stellite 6 alloy onto a 316L austenitic stainless and Stellite 6 plasma cladding layer by using ESD technique. Electrospark deposition can apply metallurgical bonded coatings without the need of post-heat treatment. Structure, hardness, chemical composition and morphology of the ESD coating have been analysed. By electrochemical measurements it is inferred that the corrosion resistance of the ESD coating is comparable to that of the 316L and Stellite 6 plasma cladding layer. The hardness improvement was ascribed to the refine microstructure and the rapid solidification.

参考文献

上一张 下一张
上一张 下一张
计量
  • 下载量()
  • 访问量()
文章评分
  • 您的评分:
  • 1
    0%
  • 2
    0%
  • 3
    0%
  • 4
    0%
  • 5
    0%