通过测试ABS、PA-GF30在不同条件下的泊松比，从纵向引伸计间距、拉伸速率以及取值范围分析比较了ISO 527-1、ASTM D638以及GB/T 1040．1中关于塑料泊松比测试方法的异同。结果表明，对于常规ISO 1 A型拉伸样条，可优先采用在5 mm/min的速率下测试，当应变取值范围在0．3%~0．8%之间，会得到较理想的测试结果。
The different requirement of ISO 527 -1 , ASTM D638 and GB/T 1040. 1 on Poisson’s ratio testing were discussed by testing acrylonirile butadiene styrene and 30% glass-reinforced nylon in different measurement conditions. The result showed that a gauge length of 75mm,and test speed of 5mm/min are preferred for ISO type 1 A test specimen. It is recommended to determine Poisson’s ratio in a strain range of 0. 3% ~0. 8%.
参考文献
| [1] | 何曼君.高分子物理[M].上海:复旦大学出版社,2000:297. |
| [2] | GB/T 1040. 1-2006.塑料拉伸性能的测定第1部分:总则[S].北京:中国标准出版社,2006. |
| [3] | ASTM D638-1910.Standard test method for tensile proper-ties of plastics[S].West Conshohocken:ASTM International,2010. |
| [4] | ISO 527-1:2012.Determination of tensile properties Part 1:General principles[S].Geneva:ISO Cen-tral Secretariat,2012. |
上一张
下一张
上一张
下一张
计量
- 下载量()
- 访问量()
文章评分
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%