为了研究孔隙率对织物碳纤维/环氧树脂复合材料层合板静态力学性能的影响规律,分别测量了孔隙率为0.33％至1.50％的CFRP层合板的弯曲强度和层间剪切强度,并进行有限元模拟.在适用于复合材料单向板的改进Hashin失效准则基础上,建立了适用于织物纤维增强复合材料静态力学强度的失效准则.通过引入复合材料基本强度参数预测不同孔隙率CFRP层合板的力学性能,结合刚度突然退化模型,采用ABAQUS软件建立了有限元模型.试验结果表明,随着孔隙率的增加,复合材料层合板的弯曲强度和层间剪切强度均呈下降趋势.有限元模型较为准确地预测了不同孔隙率织物碳纤维/环氧树脂复合材料层合板的弯曲强度和层间剪切强度.
参考文献
| [1] | Calibration of resistance factors for reliability based design of externally-bonded FRP composites[J].Composites, Part B. Engineering,2008(4):p.665-679. |
| [2] | Sofiene Marouani;Laurence Curtil;Patrice Hamelin .Composites realized by hand lay-up process in a civil engineering environment: initial properties and durability[J].Materials and structures,2008(5):831-851. |
| [3] | 李趁趁,高丹盈,黄承逵.碳纤维与玻璃纤维增强聚合物复合材料耐久性[J].哈尔滨工业大学学报,2009(02):150-154. |
| [4] | E. A. Birtand;R. A. Smith .A review of NDE methods for porosity measurement in fibre-reinforced polymer composites[J].Insight: Non-Destructive Testing and Condition Monitoring,2004(11):681-686. |
| [5] | Michelle Leali Costa;Sergio Frascino M. de Almeida;Mirabel Cerqueira Rezende .The influence of porosity on the interlaminar shear strength of carbon/epoxy and carbon/bismaleimide fabric laminates[J].Composites science and technology,2001(14):2101-2108. |
| [6] | A.R. Chambers;J.S. Earl;C.A. Squires .The effect of voids on the flexural fatigue performance of unidirectional carbon fibre composites developed for wind turbine applications[J].International Journal of Fatigue,2006(10):1389-1398. |
| [7] | Mathmood M. Shokrieh;Larry B. Lessard .Progressive fatigue damage modeling of composite materials, Part I: modeling[J].Journal of Composite Materials,2000(13):1056-1080. |
上一张
下一张
上一张
下一张
计量
- 下载量()
- 访问量()
文章评分
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%