本文提出在离心叶轮轮盖与叶片之间开缝,使得叶片压力面侧的高压气体射流到吸力面侧的低速尾迹区,从而直接给叶轮内的低速流体提供能量,减弱了叶轮内由于二次流所导致的射流-尾迹结构,并可用于消除或解决部分负荷时常发生的离心叶轮积灰问题.对某离心风机整机的数值模拟表明,在设计流量和小流量情况下,叶轮开缝后使叶片表面分离区域减小,整个流道速度分布更为均匀,改善了叶轮内部流场的流动状况,提高了离心叶轮性能和整机性能.研究表明,本方法对于提高离心式流体机械性能是有效的.
A new kind of centrifugal impeller with slots cut along the blade ends close to shroud is proposed. Due to the pressurized air flows from pressure sides to suction sides of the blades and the additional energy supplys to the flow with low velocity inside the passages in the impeller, the jet-wake flow at exit of the impeller caused by secondary flows is weakened and the problems of dust or ash accumulated on the blades often encountered with partial loads are expected to be solved to some extend. The numerical investigations of flow fields in a centrifugal fan with slots along the blade ends reveal that, at design and low flow rates, the flow separation zones in flow passages become smaller and the exit velocity fields become more uniform, which indicates that the flow fields in the impeller are improved and the performances of both the centrifugal impeller and the fan are enhanced.The research shows that the new approach is useful to improve the characteristics of the centrifugal fluid machinery.
参考文献
[1] | ECKARDTD .Instantaneous Measurements in the JetWake Discharge Flow of a Centrifugal Compressor Impeller[J].Journal of Engineering for Power,Transactions of the ASME,1975,97(03):337-346. |
[2] | ECKARDTD .Detailed Flow Investigations with in a High-Speed Centrifugal Compressor Impeller[J].Journal of Fluids Engineering,Transactions of the ASME,1976,98:390-402. |
[3] | 李景银,梁亚勋,田华.不同型线离心风机叶轮的性能对比研究[J].工程热物理学报,2008(06):963-966. |
[4] | 李景银,田华,梁亚勋.轮盖开孔的离心风机流场研究[J].西安交通大学学报,2008(09):1117-1121. |
[5] | 周敏,王如根,曹朝辉,张相毅.开槽处理技术对叶片尾缘气流流动特性的影响[J].航空动力学报,2007(07):1100-1105. |
[6] | Douglas A. Roberts;Suresh C. Kacker .Numerical Investigation of Tandem-Impeller Designs for a Gas Turbine Compressor[J].Journal of turbomachinery,2002(1):36-44. |
[7] | 黄东涛,边晓东,唐旭东,卢钰.长短叶片开缝技术在离心风机设计中的应用[J].清华大学学报(自然科学版),1999(04):6-9. |
[8] | 续魁昌.风机手册[M].北京:机械工业出版社,2001 |
- 下载量()
- 访问量()
- 您的评分:
-
10%
-
20%
-
30%
-
40%
-
50%