采用氧乙炔火焰喷焊技术，在正火态45钢基体表面用镍包WC粉制备WC颗粒增强镍基喷焊涂层，采用SEM、XRD分析了涂层的显微组织和物相组成，讨论了WC含量对镍基喷焊涂层硬度、耐磨性的影响。结果表明：WC增强镍基喷焊涂层组织细小，喷焊涂层与基体形成了良好的冶金结合；喷焊涂层的硬度和耐磨性能随着WC含量增加均先升后降，当WC颗粒质量分数为35％左右时性能最佳，硬度达到1 250 HV，磨损量为0.06 g。
参考文献
| [1] | M. Surender;B. Basu;R. Balasubramaniam .Wear characterization of electrodeposited Ni-WC composite coatings[J].Tribology International,2004(9):743-749. |
| [2] | Jinkwan Jung;Shinhoo Kang .Effect of ultra-fine powders on the microstructure of Ti(CN)–xWC–Ni cermets[J].Acta materialia,2004(6):1379-1386. |
| [3] | P. Wu;H. M. Du;X. L. Chen;Z. Q. Li;H. L. Bai;E. Y. Jiang .Influence of WC particle behavior on the wear resistance properties of Ni-WC composite coatings[J].Wear: an International Journal on the Science and Technology of Friction, Lubrication and Wear,2004(1/2):142-147. |
| [4] | 王振廷,陈华辉.碳化钨颗粒增强金属基复合材料涂层组织及其摩擦磨损性能[J].摩擦学学报,2005(03):203-206. |
| [5] | 李丹,张永胜,周惠娣,陈建敏.MoSi2增强镍基合金复合材料的摩擦磨损性能研究[J].摩擦学学报,2007(04):336-340. |
| [6] | Q. Li;G. M. Song;Y. Z. Zhang;T. C. Lei;W. Z. Chen .Microstructure and dry sliding wear behavior of laser clad Ni-based alloy coating with the addition of SiC[J].Wear: an International Journal on the Science and Technology of Friction, Lubrication and Wear,2003(3/4):222-229. |
| [7] | 陈志刚,苏静.纳米三氧化钨的制备与应用[J].江苏大学学报（自然科学版）,2005(01):57-61. |
上一张
下一张
上一张
下一张
计量
- 下载量()
- 访问量()
文章评分
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%