T. Imai
,
L. Geng
,
J. F. Mao and I. Tochigi 1) National Industrial Research Institute of Nagoya
,
1-1 Hirate-cho
,
Kita-ku
,
Nagoya
,
462-8510
,
Japan 2) School of Materials Science & Engineering
,
Harbin Institute of Technology
,
Harbin 15001
,
China 3) Kanagawa High-Technology Foundation
,
Kanagawa Science Park
,
3-2-1
,
Sakado
,
Takatsu-ku
,
Kawasaki
,
Kanagawa 213
,
Japan
金属学报(英文版)
β-Si3N4 whisker reinforced aluminum composites was fabricated by squeeze casting before extrusion and an effect of content of Mg on the High Strain Rate Superplastic- ity (HSRS) were investigated, The optimum temperature of the composites at which maximum total elongation is obtained decreases according to magnesium content and the β-Si_3N_4w/Al-3Mg exhibits the total elongation of about 200% at the strain rate of 10~(-1) s~(-1) and at 853-858 K, although the β-Si_3N_4w/Al-0Mg composite shows about 100% elongation at the strain rate of about 1×10~(-1) s~(-1) at 903-913 K. Optimum strain rate of the composites fabricated by squeeze casting was about 1×10~(-1) s~(-1) but TEM observation indicates that the β-Si_3N_4w/Al-Mg has a fine grain of about 2- 3μm and that the whisker might no react with Mg at the interfaces, although the β-Si_3N_4 whisker react with aluminum matrix.
关键词:
high strain rate superplasticity
,
null
,
null
王琴梅
,
滕伟
,
张静夏
,
潘仕荣
应用化学
doi:10.3969/j.issn.1000-0518.2006.09.006
以端氨基聚乙二醇(AT-PEG)引发谷氨酸苄酯N-羧酸酐(BLG-NCA)开环聚合得到聚谷氨酸苄酯-聚乙二醇-聚谷氨酸苄酯嵌段共聚物(PBLG-PEG-PBLG,缩写为GEG),用GPC、IR、1H NMR测试技术表征了共聚物的结构;在GEG膜表面培养中国仓鼠肺泡成纤维细胞(CHO),用光学显微镜和扫描电子显微镜观察聚合物表面细胞粘附、生长、繁殖的情况. 结果表明,AT-PEG能引发BLG-NCA开环聚合形成嵌段共聚物,所有的聚合物都没有细胞毒性,细胞在某些共聚物上的生长和繁殖比均聚物好.当PEG的分子量为2 000,且PEG单体单元的摩尔含量占共聚物中总单体含量的59%时,细胞不能贴附在共聚物表面. 通过控制共聚物中PEG嵌段的含量可调节细胞在聚合物表面上的粘附和生长.
关键词:
聚谷氨酸苄酯
,
聚乙二醇
,
嵌段共聚物
,
细胞毒性
Z.M.Yu
金属学报(英文版)
The surface free energy (SFE) of (1× 1)-surfaces of crystals, without reconstructionand adsorption, is calculated using a bond-broken mode. In the mode, the potentialenergy of the crystals is treated as a sum of the energies of the bonds connectingpair-wise atoms (u-bonds). The SFE is calculated based on the bond energy and thearea density of dangling bonds which depends on the structure of the surface. Theresults provide a general expression for the SFE in terms of the bond energy (E)and the bond length (do) of the crystal and Miller indices hkl. The anisotropy ofthe SFE is therefore completely determined with the expression. As the examples,considering the nearest-neighboring bonding, the SFEs of sc, fcc, bcc and cth (cubictetrahedral) crystals are discussed, respectively. Wulff plots of bcc and fcc crystalsare then obtained. The equilibrium forms (EFs) of these crystals ave consequentlygot from their Wulff plots, respectively. It is found that the EFs of bcc and fcc arerespectively the rhombic dodecahedron and the truncated-octahedron that are their firstBrillouin zones, respectively.
关键词:
surface free energy
,
null
,
null
吴崇试
,
潘奕
原子核物理评论
doi:10.3969/j.issn.1007-4627.2002.01.001
系统分析了A≈170区正常形变带[521]1/2-中的ΔI=1颤动现象. 根据旋称伙伴带的跃迁能量提取Δ2 Eγ (I)=[Eγ(I)+Eγ(I-2)]/2-Eγ(I-1)值, 表现出旋称相关的规则上下颤动. 其颤动幅度在低自旋端约为50 keV, 而后随自旋而增大或减小, 大体呈抛物线形. 利用改进的ab公式, 提取了相关的脱耦合系数. 运用Nilsson波函数, 探讨了原子核集体哈密顿量中高阶微扰项的可能形式.
关键词:
正常形变带
,
旋称伙伴带
,
ΔI = 1颤动
,
脱耦合效应
,
改进的ab拟合
谢慕华
,
丁志福
,
李瑞
材料导报
采用高温固相法合成Li1-xNb1-xW1+xO6 (x=0.1,0,-0.1),通过H+交换制备出相应的固体酸H1-x-Nb1-xW1+xO6.采用XRD和FT-IR技术表征固体酸的物相和层板骨架结构,NH3-TPD方法表征其酸性特征.结果表明,3种酸样品的物相相同,但它们的主晶面(002)面间距略有变化.与HNbWO6中的NbO6和WO6八面体结构单元相比,H0.9Nb0.9 W1.1O6和H1.1 Nb1.1 W0.9 O6中的NbO6和WO6八面体发生变形.3种酸样品均有两种不同强度的酸位,它们的弱酸位强度基本相等,强酸位强度大小顺序为HL1 Nb1.1W0.9O6 ＞H0.9 Nb0.9 W1.1 O6＞ HNbWO6,两种酸位的酸量大小顺序均为H1.1 Nb1.1 W0.9 O6＞ HNbWO6＞ H0.9Nb0.9W1.1O6.
关键词:
层状化合物
,
铌钨酸
,
结构
,
酸性
张昌
,
段远源
,
史琳
,
朱明善
,
韩礼钟
工程热物理学报
析了气相声速与理想气体比定压热容的热力学关系，用超声变程干涉仪测定了1,1,1,2,3,3,3-七氟丙烷(HFC-227ea)的72组气相声速值，温度范围273-333 K，压力范围26-315 kPa，测量不确定度小于0.05%。根据这些实验数据，确定了HFC-227ea的理想气体比定压热容和声速第二维里系数，并分别拟合得到了与温度的函数，理想气体比定压热容的不确定度小于0.5%。使用方阱势能模型导出了HFC-227ea的第二维里系数，并与文献值进行了比较。
关键词:
HFC-227ea
,
声速
,
理想气体比定压热容
,
第二维里系数
赵学国
,
罗民华
人工晶体学报
以SrCO3,Sm12 O3,Al2O3,TiO2为原料,采用固相反应法制备了Sr1+xSm1-xAl1-xTixO4(x=0,0.1,0.2,0.3)陶瓷,研究了SrTiO3掺人量对其显微结构和微波介电性能的影响.结果表明:SrSmAlO4晶相中固溶SrTiO3,晶胞出现了明显的膨胀；SrSmAlO4陶瓷中固溶SrTiO3相,可降低其烧结温度和陶瓷烧结体的密度；SrSmAlO4陶瓷中固溶SrTiO3相后,可提高其介电常数和品质因素,但对其温频系数影响较小.在1420C/2 h烧结条件下,Sr1.2Sm0.8Al08Ti0 2 O4陶瓷微波介电性能达到:εr=28,Q×f=52600 GHz,τf=4 ppm/℃.
关键词:
微波介质陶瓷
,
SrSmAlO4陶瓷
,
烧结温度
,
介电性能
Acta Materialia
This work reveals the formation mechanisms of saturation dislocation patterns in three typical multiple-slip oriented [0 0 1], [0 1 1] and [(1) over bar 1 1] copper single crystals. Compared with the single-slip oriented copper single crystals, the three multiple-slip oriented ones show very different dislocation patterns. It was found that the dislocation patterns in cyclically saturated copper single crystals are the Labyrinth structure for [0 0 1], wall structure for [0 1 1] and cell structure for [(1) over bar 1 1] , respectively. Based on a two-phase structure consisting of persistent slip bands and veins for single-slip orientation, the formation mechanisms of the dislocation patterns in multiple-slip oriented crystals are proposed as follows: the formation of the complex dislocation patterns depends on the activating slip system. The easy operation of the critical secondary slip system will contribute to the formation of the Labyrinth structure. The activation of the coplanar secondary slip system will be beneficial to formation of the cell structure. If no secondary slip system is activated, the wall structure is more prone to appear. Finally, the intrinsic relationship between various dislocation patterns and face centered cubic crystal structure was established. (C) 2010 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.
关键词:
Orientation effect;Cyclic deformation;Copper single crystals;Dislocation patterns;electron channeling contrast;persistent slip bands;stress-strain;response;low-amplitude fatigue;deformation-behavior;grain-boundaries;orientation;surface;localization;arrangements
