材料期刊网

Influence of Inhibitor Concentration on Corrosion Fatigue Crack Initiation and Propagation

Zhengfu WANG , Jin LI , Jianqiu WANG and Wei KE(Corrosion Science Laboratory , Institute of Corrosion and Protection of Metals , Chinese Academy of Sciences , Shenyang , 110015 , China)

材料科学技术（英文）

The paper reports the effect of0.01,0.1 and 1%NaNO2, a passive inhibitor, on corrosion fatigue (CF) crack initiation and propagation for a low strength structural steel A537 in 3.5%NaCl aqueous solution. The experimental results show that inhibitor increases the required cycles of CF crack initiation effectively, and this effect increases with increasing inhibitor concentration.However, there is nearly no effect of NaNO2 on CF crack propagation. The same CF crack propagation rate was found in all kinds of solutions. The results also indicate that the passive time in 1%NaNO2 solution during plastic deformation is much longer than cyclic time. NaNO2 passivates the specimen sudece and repairs passive film damaged by cyclic loading during the crack initiation. while the passsive film is not formed fully due to continuous plastic deformation at the crack tip during the CF crack propagation, which is much different from that in the stress corrosion cracking and general corrosion

关键词:

Effect of Hydrogen on Plastic Deformation near Crack-tip of A537 Steel in 3.5%NaCl Solution

Xuejun WEI , Jin LI , Zhengfu WANG and Wei KE (State Key Lab. of Corrosion and Protection , Institute of Corrosion and Protection of Metals , Chinese Academy of Sciences , Shenyang 110015 , China)(To whom correspondence should be addressed)

材料科学技术（英文）

A computerized digital speckle-intederometry system was set up to study in-situ the influence of cathodic hydrogen charging on the crack opening displacement and on the plastic strain distribution at corrosion fatigue crack tip for the singIe-edge notched plate specimens of structural steel in 3.5%NaCl solution with an applied potential of -1400 mV (SCE). Meanwhile, the mono-directional tension tests with smooth specimens were pedermed in both air and 3.5%NaCl solution under the hydrogen charging conditions. The fracture sudece morphology from corrosion fatigue and tension was examined by SEM. The experimental results show that the existence of hydrogen in crack tip material caused an increase of both yield strength and hardening exponent and a decrease of plastic zone size at the corrosion fatigue crack tip.

关键词:

Interaction of Mechanical and Electrochemical Factors during Corrosion Fatigue of Fe-26Cr-1Mo Stainless Steel in 1M H_2SO_4 Solution

Jianqiu WANG , Jin LI , Ziyong ZHU and Wei KE (Corrosion Science Laboratory , Institute of Corrosion and Protection of Metals Chinese Academy of Sciences , Shenyang , 110015 , China)Qishan ZANG and Zhongguang WANG (State Key Laboratory for Fatigue and Fracture

材料科学技术（英文）

The cyclic plastic straining electrode technique has been used to investigate the transient electrochemical behaviour of Fe-26Cr1Mo stainless steel in 1M H2SO4 solution at a passive potential.The influence of plastic strain amplitude and plastic strain rate on the dissolution current response was analysed. The experimental results showed that the transient current was dependent on the competitive process of the surface film rupture and repassivation of the new surface. The high plastic strain amplitude and the high plastic strain rate caused a change of electrochemical activity of specimen surface. In the condition of low strain amplitude and strain rate, the characteristics of current response was mainly relative tp the process of new surface repassivation.The competition kinetics has been analysed through the comparison of plastic strain rate and repassivating rate

关键词:

ON SPINODAL BOUNDARIES OF Al-Li ALLOYS

WEI Yinghui , WANG Xiaotian (School of Materials Scince and Engineering , Xi'an Jiaotong University , Xi'an 710049 , China Manuscript received 10 Mareh , 1994)

金属学报(英文版)

The spinodal decomposition can occur in Al-Li alloys containing 5.8-14.2 at.% Li at room temperature. The modutated structure wavelength is approximately 3.1 nm for com mercial Al-LI alloys. The limit composition of the miscibility gap is 3.66 -16.06 at.%Li at 298 K. The highest temperature of the miscibility gap is 377 K.

关键词: : Al-Li alloy , null , null

大爆炸核合成相关的8Li(d, p)9Li反应截面测量

李志宏 , 柳卫平 , 白希祥 , 郭冰 , 连钢 , 颜胜权 , 王宝祥 , 陆昀 , 曾晟 , 苏俊

原子核物理评论 doi:10.3969/j.issn.1007-4627.2005.01.006

利用8Li次级束测量了质心系能量7.8 MeV 2H(8Li, 9Li)1H反应的角分布, 导出了8Li(d, p)9Li反应的天体物理S因子及9Li→8Li+n虚衰变的渐近归一化系数.

关键词: 8Li(d,p)9Li反应 , 角分布 , 天体物理S因子 , 渐近归一化系数

CRYSTAL STRUCTURE OF γ-Li_xFe_2O_3 WITH ELECTROCHEMICAL INSERTION OF Li

HUANG Jianshun CHEN Junming Shanghai Institute of Metallurgy , Academia Sinica , Shanghai , China Research Associate , Shanghai Institute of Metallurgy , Academia Sinica , Shanghai 200050 , China

金属学报(英文版)

Crystal structure of γ-Li_xFe_2O_3,inserted Li electrochemically,was studied by Moss- bauer spectroscopy together with X-ray diffraction,XPS and electrochemical method,On the insertion of Li at low current density,the crystal structure is keeping original spinel; while at higher current density or by thermal activation,owing to violent movement of Li~+ ions,part of crystal structure transforms into rock type similar to face-centered cubic structure of ferrous oxide.The transition channels during insertion of Li~+ ions and limitation of Li~+ ions inserted were discussed.

关键词: null , null , null

Al—Li合金的晶界断裂

姚大平 , 张匀 , 胡壮麒 , 李依依

材料研究学报

本文研究了两种晶粒组织的二元Al-Li 合金拉伸性能与断裂行为。结果表明Al-Li 合金力学性能与晶粒尺寸有关,其断裂行为决定于PFZ 内平面滑移或晶界沉淀相与滑移的交互作用。

关键词: Al—Li合金 , intergranular fracture , planar slip

Effect of Li(3)N additive on the hydrogen storage properties of Li-Mg-N-H system

Journal of Materials Research

The effect of Li(3)N additive on the Li-Mg-N-H system was examined with respect to the reversible dehydrogenation performance. Screening Study with varying Li(3)N additions (5, 10, 20, and 30 mol%) demonstrates that all are effective for improving the hydrogen desorption capacity. Optimally, incorporation of 10 mol% Li(3)N improves the practical capacity from 3.9 wt% to approximately 4.7 wt% hydrogen at 200 degrees C, which drives the dehydrogenation reaction toward completion. Moreover, the capacity enhancement persists well over 10 de-/rehydrogenation cycles. Systematic x-ray diffraction examinations indicate that Li(3)N additive transforms into LiNH(2) and LiH phases and remains during hydrogen cycling. Combined structure/property investigations suggest that the LiNH(2) "seeding" should be responsible for the capacity enhancement, which reduces the kinetic barrier associated with the nucleation of intermediate LiNH(2). In addition, the concurrent incorporation of LiH is effective for mitigating the ammonia release.

关键词: complex hydrides;improvement;mixtures;imides;amide;h-2

SUPERPLASTICITY OF A RAPIDLY SOLIDIFIED AI-Li ALLOY

MANG Weishi WANG Guozhi ZHANG Yongchang HU Zhuangqi SHI Changxu Institute of Metal Research , Academia Sinica , Shenyang , China Yongchang Associate Professor , Institute of Metal Research , Academia Sinica , Shenyang 110015 , China

金属学报(英文版)

A rapidly solidified microcrystalline Al-Li-Cu-Mg-Zr alloy and its superplasicity have been investigated.An optimum tensile elongation of 585% was obtained at 540℃ and strain rate 1.67×10~(-2)s~(-1).The superplastic Al-Li alloy is manufaetured using thermomechanical pro- cessing:solution,overaging,warm rolling and recrystallization.Microstructural changes in thermomechanical processing and cavitation occurred during superplastic deformation have been observed.The superplastic failure of alloy may be caused mainly by nucleation and growth of cavities as well as the linkage around grains.

关键词: superplasticity , null , null , null

Al-Li合金强韧化机理及途径

甘卫平 , 周兆锋 , 杨伏良

材料导报

概述了Al-Li合金强韧化的内部机理和外部机理,并在此基础上阐述了提高Al-Li合金强韧性的主要途径.

关键词: Al-Li合金 , 强韧性 , 途径