Ali A. ENSAFI*
,
Hajar BAHRAMI
,
0Hassan KARIMI-MALEH
,
Shadpour MALLAKPOUR
催化学报
doi:10.1016/S1872-2067(11)60465-8
A carbon paste electrode with added multiwall carbon nanotubes chemically modified with N-(3,4-dihydroxyphenethyl)-3,5-dinitrobenzamide was used as the electrochemical sensor for the determination of trace amounts of isoprenaline. The modified electrode showed good electrocatalytic activity for the anodic oxidation of isoprenaline, which was due to a substantial decrease in the anodic overpo-tential. Under the optimum conditions, measurements using square wave voltammetry had a linear range in the range of 0.3 to 125.0μmol/L of isoprenaline and a detection limit of 0.1μmol/L. The diffusion coefficient and kinetic parameters were determined using electrochemical methods. The relative standard deviation for seven successive assays of 1.0 and 20.0μmol/L isoprenaline were 1.9% and 2.4%, respectively. This electrochemical sensor was successfully applied for the determination of isoprenaline in human urine and injection solution samples.
关键词:
isoprenaline
,
carbon nanotube
,
electrode
,
electrocatalytic effect
,
voltammetry
Acta Chimica Sinica
Passive film formed on 304 stainless steel in 2.5 mol/L H2SO4 solution by using alternating voltage (A. V.) passivation have been investigated by measuring capacitance and photoelectrochemical parameters. The investigation of the effect of measure frequency on the slope of Mott-Schottky curve has been carried out. The photoelectrochemical measurements were consistent with the capacitance measurement. Analysis of the experimental results showed that the passive film formed 304 stainless steel by using A. V. passivation exhibits semiconducting properties. Using the simple model of semiconductor rather than the multi-donor level model can explain satisfactorily the semiconducting behavior of the film formed on 304 stainless steel by using A.V. passivation.
关键词:
A. V. passivation;passive film;semiconducting properties;stainless;steel;model;electrodes
Fatigue & Fracture of Engineering Materials & Structures
Fatigue data for welded joints subjected to an explosion treatment (ET) were obtained using rotary bending fatigue specimens. The fatigue fracture surfaces were observed by SEM and the dislocation morphologies by TEM. Mechanical properties have been quantitively studied by considering elastic and plastic shock wave characteristics. The test results indicate that the fatigue strength of welded joints subjected to ET is apparently improved due to the action of elastic or plastic stress waves while the ductility of the welded joints, i.e., reduction in area, is greatly increased.
关键词:
李慧玲
,
阮可青
,
王强
,
陈宇
,
钱朔
,
余勇
,
黄利
,
郑重
,
汪成友
,
曹烈兆
低温物理学报
doi:10.3969/j.issn.1000-3258.2003.04.007
研究了不同Pb含量的Bi2-xPbxSr2Co2Oy单晶的输运行为.用A. F. Ho 和A. J. Schofield提出的公式对ρc的温度依赖关系曲线进行了拟合,得到了较好的结果.我们利用小极化子理论解释了ρc的复杂行为.
关键词:
过渡金属氧化物的电导
,
小极化子
中国有色金属学报(英文版)
doi:10.1016/S1003-6326(16)64373-X
提出了一种从氧化铝中提取原铝的新方法。该方法的原理基于如下化学反应：AlI3+(3/2)Zn=Al+(3/2)ZnI2。首先通过氧化铝的碳热氯化反应得到氯化铝(AlCl3)，然后通过氯化铝和碘化钙的交换反应(AlCl3+CaI2→AlI3+CaCl2)得到碘化铝。在实验室条件下对这些反应进行了研究，同时对一些回收主要化学试剂的反应进行了研究(Cl2, ZnI2→Zn, CaCl2→CaI2)。采用XRD和SEM对反应产物的相组成及形貌进行分析。采用总自由能最小方法对化学反应平衡进行计算。结果表明，采用非电解方法，可以在没有非常高的温度和可消耗的化学试剂的条件下，从氧化铝中有效地提取铝。与当今采用燃煤发电提供电力的铝电解厂相比，本方法所产生的单位碳消耗和 CO2大气排放可以降低一半以上。
关键词:
铝
,
铝合金
,
氯化物
,
碘化物
,
锌
,
碘
,
高速冶金
Journal of Alloys and Compounds
Interdiffusion coefficients within the beta-phase region of the nickel-cobalt-chromium-aluminum (Ni-Co-Cr-Al) quaternary system were estimated by square root diffusivity analysis. The obtained results indicated that the cross interdiffusion coefficients D(ij) (i not equal j, i, j = Al, Cr, Co) other than D(AlCo), were less than the main interdiffusion coefficients Do (i = j), and that the values of D(Ali) were greater than those of D(Cri) and D(Coi). This finding suggests that the addition of chromium decreases the interdiffusion coefficients of aluminum and cobalt, but the addition of cobalt did not cause an obvious change in the interdiffusion coefficients of aluminum and chromium in the beta-phase region. The different effects associated with the additions of chromium and cobalt were qualitatively discussed in light of the relationship between the thermodynamic properties of the system and Wagner's interaction parameter. The results revealed that the different effects could be ascribed to the stronger thermodynamic interactions between aluminum and cobalt compared to that between aluminum and chromium. (C) 2009 Elsevier B.V. All rights reserved.
关键词:
Diffusion;NiAl phase;Electron microprobe;multicomponent diffusion couples;square root diffusivity;transfer-matrix method;zero-flux planes;intermetallic compound;coefficients;ternary;nickel;alloys;fe
陈小庆
,
孙利杰
,
邬小鹏
,
钟泽
,
傅竹西
功能材料
用MOCVD方法在Si基片上生长了Al掺杂的SiC薄膜,发现三甲基铝(TMA)源载气流量与硅烷流量之比的大小,会决定薄膜的导电类型.用XPS方法测试样品后发现,TMA载气流量与硅烷流量比直接影响Al原子在SiC薄膜中的含量.Al含量在1.5%以下,Al原子在SiC薄膜中主要以填隙形式(Ali)存在,薄膜显示出n型;而Al含量在1.5%～3%之间的时候,Al原子主要以替位Si(AlSi)的形式存在,薄膜显示出p型.继续增加掺杂源的流量,所得SiC薄膜结晶质量会变得较差,电阻也变得较高.
关键词:
3C-SiC
,
SiC:Al
,
MOCVD
,
导电类型
徐东
,
巫欣欣
,
程晓农
,
张剑平
,
施利毅
材料导报
采用两步烧结制备了Y_2O_3掺杂ZnO压敏瓷,其电位梯度为863～1330V/mm,非线性系数为27.0～49.7,漏电流为0.55～1.13μA.研究结果表明,当Y_2C_3的掺杂量为1.00%(摩尔分数)时,压敏瓷电性能最好,电位梯度为1330V/mm,非线性系数为49.7,漏电流为0.76μA.
关键词:
压敏瓷
,
两步烧结
,
稀土
,
显微组织
,
电性能
