王丽
,
吴希文
,
张晨鼎
,
张通
,
简丽
,
武朝军
,
周涛
稀土
doi:10.3969/j.issn.1004-0277.1999.02.003
采用湿渣法研究了0℃时碘化钇(YI3)-乌洛托品氢碘酸盐(C6H12N4.HI)-水(H2O)的三元体系相平衡,绘制了该体系的等温溶解度相图,相图分析结果表明,该体系中有组成为YI3.C6H12N4.HI.14H2O的配合物生成,对所得配合物进行了化学分析、X-射线粉末衍射、红外光谱、差热-热重分析,测定了其密度、晶体轴性,确定了配合物结构中的配位关系.
关键词:
相平衡
,
碘化钇
,
乌洛托品氢碘酸盐
,
配合物
Nuclear Engineering and Design
Liquid droplet erosion (LDE), which often occurs in bellows made of nickel-based alloys, threatens the security operation of the nuclear power plant. As the candidate materials of the bellows, Inconel 600 and Inconel 625 were both tested for resistance to cavitation erosion (CE) and jet impingement erosion (JIE) through vibratory cavitation equipment and a jet apparatus for erosion-corrosion. Cumulative mass loss vs. exposure time was used to evaluate the erosion rate of the two alloys. The surface and cross-sectional morphologies before and after the erosion tests were observed by scanning electron microscopy (SEM), the inclusions were analyzed by an energy dispersive spectroscopy (EDS), and the surface roughness was also measured by surface roughness tester to illustrate the evolution of erosion process. The results show that the cumulative mass loss of CE of Inconel 625 is about 1/6 that of Inconel 600 and the CE incubation period of the Inconel 625 is 4 times as long as that of the Inconel 600. The micro-morphology evolution of CE process illustrates that the twinning and hardness of the Inconel 625 plays a significant role in CE. In addition, the cumulative mass loss of JIE of Inconel 625 is about 2/3 that of Inconel 600 at impacting angle of 90 degrees, and almost equal to that of the Inconel 600 at impacting angle of 30 degrees. Overall, the resistance to CE and JIE of Inconel 625 is much superior to that of Inconel 600. (C) 2010 Elsevier By. All rights reserved.
关键词:
stress-corrosion cracking;aluminide intermetallic alloys;high-purity;water;mechanical-properties;crevice corrosion;solid particles;wear;behavior;microstructure;deformation;steam
宁远涛
贵金属
评述了合金元素对Au的漂白效果和机制，介绍了白色开金的几种色度参数，如CIE-L a*b*色度参数和颜色盒，CIE-LAB-C-H-L米制色度参数和基于CIE-XYZ色度参数的ASTM D1925黄色指数YI，讨论了某些白色开金的色度参数与冶金学特征。基于金合金的漂白效应与合金成分的密切关系，ASTM D1925黄色指数YI为设计白色开金成分提供了基本的指南。
关键词:
金属材料
,
Au合金
,
白色开金
,
色度参数
,
色度图
徐旸
,
汪艳
,
傅轶
合成材料老化与应用
采用多次挤出的方法和氧化诱导期(OIT)方法考察了抗氧剂对聚丙烯热氧稳定性的影响,测定了各次挤出试样的熔体流动速率(MFR)、黄度指数(YI)、力学性能以及氧化诱导期(OIT).实验结果表明:添加由主抗氧剂1010和辅抗氧剂168组成的复合抗氧剂后聚丙烯的熔体流动速率(MFR)、黄度指数(YI)、拉伸强度和冲击强度、氧化诱导期(OIT)与未添加抗氧剂的聚丙烯相比降低明显减缓,说明抗氧剂可有效抑制聚丙烯的老化,延长其使用寿命.
关键词:
聚丙烯
,
抗氧剂
,
热稳定性
Nuclear Engineering and Design
A composite coating was deposited on Inconel 600 substrate by cold spray method using pure Ni powder (60 wt.%) blended with alpha-Al(2)O(3) (40 wt.%) as feedstock. It is expected to be applied to repair the bellows eroded by the liquid droplet erosion (LDE). Microstructure of the coating was observed using optical microscope (OM) and scanning electron microscopy (SEM). Microhardness of the coating was determined by Vickers hardness tester. Cavitation erosion (CE) experiments were carried out in the distilled water. Jet impingement erosion (JIE) experiments were performed in slurry containing 1 wt.% quartz particle with the flow velocity of 15 m/s at impingement angles of 30 degrees, 60 degrees and 90 degrees, respectively. Cumulative mass loss vs. testing time was used to evaluate the erosion rate of the coating. The erosion mechanism was analyzed by OM, SEM, X-ray diffraction (XRD) and the microhardness measurement. The results show that the composite coating has compact microstructure and relatively high hardness. The resistance to CE of the coating is not as good as that of Inconel 600 substrate due to the weak bonds of the Al(2)O(3) particles. However, the results of the JIE test indicate that the slurry erosion resistance of the coating is better than that of Inconel 600 at the impact angles of 30 degrees and 60 degrees, but not at the normal impact angle. (C) 2011 Elsevier B.V. All rights reserved.
关键词:
large powder particles;composite coatings;slurry erosion;kinetic;spray;liquid impact;alloy;microstructure;steels;deposition;resistance
陈志钢
,
唐一文
,
张丽莎
,
张新
,
贾志勇
,
余颖
材料科学与工程学报
doi:10.3969/j.issn.1673-2812.2005.04.025
以透明导电玻璃(TCO)、纳米TiO2/TCO、CNTs/TCO、铜片分别为工作电极,用简单铜盐通过阴极还原制备了Gu2O薄膜,并研究了溶液温度和衬底对电化学沉积Gu2O薄膜形貌的影响.结果表明:以TCO和铜片为衬底时,由于表面微粒为微米级,不管溶液温度高低,只能得到微米级的Cu2O薄膜;以纳米TiO2/TCO和CNTs/TCO为衬底,池温高于30℃只能得到微米级的Cu2O薄膜,而池温降到0℃时,都可得到纳米Cu2O.
关键词:
氧化亚铜
,
电沉积
,
溶液温度
,
衬底
李强
,
宣益民
工程热物理学报
建立了测量小通道扁管内纳米流体流动与对流换热性能的实验系统,测量了不同粒子体积份额的水-Gu纳米流体的管内对流换热系数和摩擦阻力系数,实验结果表明,在相同雷诺教条件下,小通道扁管内纳米流体的对流换热系数大于纯液体,且随粒子的体积份额的增加而增大,而纳米流体的阻力系教并未明显增大.
关键词:
纳米流体
,
强化传热
,
小通道扁管
Physical Review B
An elastic Ising model for CoMnO(6) chain is proposed to explain the ferroelectricity induced by collinear magnetic order in Ca(3)CoMnO(6), and then a mean-field theory with interchain spin interactions based on this model is developed. With inclusion of the dynamics of polarization domains at finite temperature, we address the rationality of our theory by the good agreement of the calculated electric polarization and dielectric susceptibility with the reported data on Ca(3)Co(2-x)Mn(x)O(6) (x approximate to 0.96) [Y. J. Choi, H. T. Yi, S. Lee, Q. Huang, V. Kiryukhin, and S.-W. Cheong, Phys. Rev. Lett. 100, 047601 (2008)], a typical diatomic Ising spin chain system, while the predicted magnetic susceptibility shows some difference from experiment, the reason of which is discussed.
关键词:
calcium compounds;cobalt compounds;dielectric polarisation;ferroelectricity;Ising model;magnetic susceptibility;multiferroics;optical susceptibility;one-dimensional oxides;magnetic-properties;multiferroics;ca3co1+xmn1-xo6
余金秋
,
彭鹏
,
刁成鹏
,
吴浩
,
何华强
人工晶体学报
LaBr3 ∶Ce、LuI3 ∶Ce、SrI2 ∶Eu等新型卤化物闪烁晶体因其高光输出、高能量分辨率等优异的闪烁特性而引起人们的广泛关注.高纯无水稀土卤化物是生长上述闪烁晶体所必需的原料,但其制备困难和高昂成本,严重制约了这些晶体的发展和应用.本文报道了无水LaBr3、CeBr3、LaCl3、CeCl3、LuI3、GdI3、YI3、CeI3、EuI2等常用稀土卤化物的制备方法,并对其有效表征手段进行了介绍.
关键词:
闪烁晶体
,
稀土卤化物
,
制备
,
表征
