HAN Enhou HAN KYumei ZHENG Yuli KE Wei Corrosion Science Laboratory
,
Institute of Corrosion and Protection of Metals
,
Academia Sinica
,
Shenyang
,
China postdoctoral
,
Institute of Corrosion and Protection of Metals
,
Academia Sinica
,
Shenyang 110015
,
China
金属学报(英文版)
Based on theoretical analysis about local strain,strain rate and dissolving rate at crack tip, the corrosion fatigue crack growth rate of steels ZG20SiMn and SM50B-Zc in fresh water and 3.5% NaCl solution were measured experimentally,and the PH and electrode potential within crack were also measured continuously along with crack propagating.It showed that the increase of crack growth rate,caused by both decreasing frequency and raising stress ratio,was mainly accelerated by hydrogen embrittlement.
关键词:
corrosion fatigue
,
null
,
null
,
null
,
null
,
null
Corrosion Science
The early stages of the evolution of atmospheric corrosion of carbon steels exposed in both a laboratory simulated and a natural atmosphere environment in Shenyang have been observed by in situ scanning electron microscopy. In the case of laboratory cyclic wet-dry tests, even though the chloride content level is very low, filiform corrosion is initiated in the early stage. The filiform corrosion grows in random directions, forming a network of ridges. White nodules nucleate and grow on the ridges during continued corrosion and eventually connect with each other to form the initial corrosion scale. Pits were also found on the surface beneath corrosion products. In the case of a natural atmospheric environment, both filiform corrosion and other localized corrosion, such as pitting and inter-granular attack take place in the initial stage. It is obvious that there is variety of localized corrosion in the initial stage of atmospheric corrosion. (C) 2007 Elsevier Ltd. All rights reserved.
关键词:
steel;atmospheric corrosion;initial stage;localized corrosion;in-situ;iron;electrolyte;thickness
郑桂丽
,
姜丽
,
张志东
液晶与显示
doi:10.3969/j.issn.1007-2780.2010.06.001
根据Erickson-Leslie流体动力学理论,研究了混合排列向列相-共面转换液晶盒的引流效应.在强锚定边界条件下,经过理论推导,得出液晶指向矢与流速的关系方程,进一步通过数值计算得出指向矢分布与时间的关系.发现引流效应加快了指向矢达到平衡态的速度,而且破坏了指向矢分布的瞬态对称性,特别在加电压的初始几毫秒这种现象非常明显.
关键词:
混合排列向列相
,
共面转换
,
引流效应
,
指向矢分布
Materials Chemistry and Physics
The corrosion behaviour of CortenA weathering steel has been investigated using a laboratory accelerated test that involved cyclic wet/dry conditions in Qinghai salt lake water diluted 30 times The characteristics of the rust layers on tested samples were observed by SEM and EPMA analyzed by IRS and XRD and studied by polarization and EIS measurements The weight loss was almost linear indicating that the rust layer had no retarding effect on the corrosion process The crystalline components of the rust layers consisted primarily of beta-FeOOH magnetite (Fe(3)O(4)) and gamma-FeOOH As the corrosion proceeded the amount of beta-FeOOH decreased while that of magnetite and gamma-FeOOH increased XRD EDAX and EPMA indicated that the complex corrosion products magnesioferrite (MgFe(2)O(4)) and iowaite (Mg(4)Fe(OH)(8)OCl 4H(2)O) probably existed in the rust layer in which case they will have had an important Influence on the protectiveness of the rust layer The results of electrochemical measurements showed that the rust layer exhibited high reduction reactivity which facilitated the corrosion of weathering steel in the wetting process The large rust capacitance and small rust resistance indicated that the rust layer had a loose and porous structure which provided poor protection (c) 2010 Elsevier B V All rights reserved
关键词:
Elements;Corrosion test;Electrochemical techniques;Electron probe;low-alloy steels;atmospheric corrosion;carbon-steel;electrochemical;impedance;room-temperature;rust layers;iron;mechanism;products;environment
Surface & Coatings Technology
Using a halide-activated pack-cementation method but at a temperature (600 degrees C) noticeably lower than normal, an eta-Fe(2)Al(5) coating and two delta-Ni(2)Al(3) coatings with and without dispersions of CeO(2) nanoparticles were developed respectively on a low-carbon steel and the steel pretreated with an electrodeposited film of Ni or Ni-CeO(2). The erosion-corrosion (E-C) performance of the three aluminide coatings during 100 h exposure at similar to 600 degrees C in a coal-firing laboratory-scale fluidized-bed combustor (FBC) was investigated, by mounting the aluminized samples onto a rig which maintained rotation for accelerating the relative impacting speed of flying solid particles (mainly SiO(2) bed materials). The eta-Fe(2)Al(5) and the CeO(2)-free delta-Ni(2)Al(3) coatings experienced an unacceptable recession rate. Compared to the two CeO(2)-free aluminide coatings, the CeO(2)-dispersed delta-Ni(2)Al(3) coating offered profoundly improved E-C resistance, because the latter coating was not only strengthened by the CeO(2) dispersion and grain refinement, it also could grow a more adherent alumina scale. (C) 2011 Elsevier B.V. All rights reserved.
关键词:
Erosion-corrosion;CeO(2)-dispersion-strengthening;Aluminizing coating;Grain refinement;Hardening;Reactive element effect;oxidation resistance;reactive elements;alloy-steels;water-vapor;power-plant;nickel;combustion;mechanisms;additions;behavior
QIAO Lijie LIU Rui XIAO Jimei University of Science and Technology Beijing
,
Beijing
,
China
金属学报(英文版)
The effects of stress components on nucleation sites and propagation directions of stress cor- rosion cracks in brass were investigated with specimens under mode Ⅱ and mode Ⅲ loadings. The results indicated that under mode Ⅱ loading,stress corrosion cracks nucleated on the site with maximum normal stress component and propagated along the plane perpendieular to the maximum normal stress,under mode Ⅲ loading,the stress corrosion crack was not evident on the 45°plane due to the general corrosion in aqueous solution with high NH_4OH concentra- tion,while stress corroded in aqueous solution with low NH_4OH concentration, numerous cracks with spacings of 10—150μm were found on the 45°plane with maximum normal stress and no stress corrosion cracks was observed on the plane with maximum shear stress.
关键词:
stress corrosion cracking
,
null
,
null
,
null
戢景文
,
魏全金
,
张国福
,
赖祖涵
,
陈廷国
金属学报
研究了F? P—N合金加?对Snoek—Ke-Koster(SKK)峰的影响,发现与合金含La,P的原子浓度比(C_(La)/C_p)有关:对于C_(La)/C_p较大(例如4.56和2.6)的合金,La有明显增强SKK阻?效应:对于C_(La)/C_p=0.27的P过饱和合金,La对SKK峰无明显影响。
关键词:
内耗
,
Snoek-Ke-Koster peak
,
Fe-P-La-N alloy
