ZHANG Xingguo
,
ZHANG Wenxiao
,
JIN Junze
,
J. W. Evans
钢铁研究学报(英文版)
The particle image velocimetry (PIV) technique was used to study the fluid flow phenomena that occurred during continuous casting, using a water model with dimensions of 1 840 mm×280 mm. Two types of solidified shells, ie, the smooth type and the coarse type, were used to characterize the dendrite in order to simulate different liquidsolid interfacial conditions. The influence of the nozzle angle and the immersion depth of nozzle, as well as the casting speed on the flow behavior was investigated quantitatively. The results were as follows: (1) There are two large recirculations above and below the fluid jet in the mold, respectively, under the smooth interface condition. However, in the case of the dendrite solidified shell, it was found that the flow velocity of the fluid decreased and more smaller vortices appeared in the upper region of the mold. (2) The angle and the immersion depth of nozzle are two important factors affecting the flow pattern, and they are also capable of bringing about the change in the flow direction. (3) The higher the casting speed, the higher are the jet stream and the impacting point on the narrow face. However, the high casting speed causes serious fluctuation of the meniscus, and correspondingly leads to various defects.
关键词:
particle image velocimetry;continuous casting;steel;fluid flow
鲁二敬
,
卢峰华
,
许鸿吉
,
谢明
,
钮旭晶
机械工程材料
通过周期浸润腐蚀试验，对比研究了S355．12W耐候钢和Q345R低合金钢在NariSOs溶液中的耐腐蚀性能，并用扫描电镜对腐蚀产物进行了观察和分析。结果表明：在相同试验条件下，S355J2W耐候钢的腐蚀速率低于Q345R钢的；S355J2W耐候钢会在表面形成黑褐色锈层，而Q345R钢表面形成橘红色易剥落的疏松锈层；S355J2W耐候钢腐蚀产物微观形貌为沿放射性方向生长的针状晶体，Q345R钢为颗粒状聚合物堆积而成，形状无规则，颗粒之间有较大的空隙。
关键词:
S355J2W耐候钢
,
周期浸润腐蚀试验
,
耐腐蚀性能
谷晓鹏
,
段珍珍
,
邓钢
,
谷晓燕
材料工程
doi:10.11868/j.issn.1001-4381.2015.02.004
利用激光-MAG复合焊和MAG焊进行了厚板S355J2W+N低碳钢的焊接实验,分析了两种焊接方法接头的微观组织和力学性能.结果表明:复合焊和MAG焊焊缝接头均由焊缝区、过热区、重结晶区和不完全重结晶区构成,复合焊接头截面呈“高脚杯”状特点,焊缝填充量和热影响区宽度较MAG焊明显减小.复合焊由于冷却速率快,过热区魏氏组织略有增多,硬度高于MAG焊,抗拉强度和弯曲性能与MAG焊相比,无显著差异,均能够满足生产标准的要求.
关键词:
S355J2W+N
,
激光
,
MAG
,
复合焊
,
接头组织
,
性能
Journal of Materials Research
The morphology of the dark and bright regions observed by transmission electron microscopy for the Zr(64.13)Cu(15.75)Ni(10.12)Al(10) bulk metallic glass strongly depends on the ion beam parameters used for ion milling. This indicates that the ion beam could introduce surface fluctuation to metallic glasses during ion milling.
关键词:
room-temperature
W.TRUSZKOWSKI
金属学报
<正> If a plastic metal is subjected to permanent deformation, then due to the changesoccurring in crystallographic lattice the metal alters its properties. Experiments carried outby many investigators prove that the ultimate strength, the yield strength and hardness in-crease with the deformation, on the other hand, the elongation decreases, the impact valueand reduction of area also change. Fig. 1 illustrates the effect of cold work by drawingon the mechanical properties of an armco iron according to W. Broniewski and J. Krol.
关键词:
Journal of Physics D-Applied Physics
The effect of Co addition combined with W on the microstructure and magnetic properties of nanocomposite magnets with composition of (1 - x wt%)Nd8.55Fe84.49W0.60 B-0.636 + x wt% CO, prepared by mechanical alloying, has been investigated. The addition of W can increase the unit cell volume of soft and hard phases in nanocomposite: magnets, and cause the anisotropy field of the hard phase component to increase. Therefore, the addition of W can improve coercivity. On the other hand, addition of Co leads to a decrease of the grain size of the alpha-Fe soft phase component in nanocomposite magnets annealed at temperatures lower than 670 degrees C. It leads further to a decrease of the optimal annealing temperatures, an increase of the remanence and maximum magnetic energy product, and a slight decrease of the coercivity. With increasing the content of Co, the dependence of remanence J(r) on annealing temperature T-a changes from a convex shape, giving a maximum, to a monotonically decreasing one. These phenomena have been explained in terms of the variation of grain growth and exchange coupling between the grains, due to the addition of Co and W.
关键词:
nd-fe-b;remanence enhancement;alloys;phase;microstructure;nb
Journal of Physics-Condensed Matter
The temperature dependences of the magnetization, internal energy and specific heat in a three-sublattice ferrimagnet or ferromagnet with /J(ab)/ = /J(bc)/ not equal /J(ca)/ are calculated within the framework of the linear spin-wave approximation, by employing retarded Green's functions. For both the ferromagnet and the ferrimagnet, the internal energy and the specific heat decrease with increasing J ' /J and/or the value of the spins. For fixed values of S,, Sb, S, and J ' /J, the internal energy and the specific heat increase, whereas the sublattice magnetization decreases with increasing temperature theta. The three-sublattice ferrimagnet has some particular characteristics which are not shown by the systems with two sublattices. For ferrimagnets, the antiferromagnetism of the system becomes weaker with increasing J ' /J. The sublattice magnetization at low temperatures (also the magnetization M(0) at 0 K) of a ferrimagnet increases with increasing J ' /J for fixed values of S(a), S(b) and S(c). The effects of the spins S(a) (S,) and Sb On the magnetizations of other sublattices differ. The characteristics of the a-sublattice are the same as those of the c-sublattice, due to their similarity as well as the symmetry of the system. The behaviours of the b-sublattice are different from those of the a- and c-sublattices, due to the asymmetry of the three-sublattice system. The spin-value dependences of the spin deviation Deltam per spin land also the energy for the zero-point quantum fluctuation) of the system are different for different sublattices. These differences are ascribed to the asymmetry of the three-sublattice systems, which leads to the new intrinsic properties of the systems.
关键词:
layered heisenberg ferrimagnets;spin-wave theory;elementary;excitations;superlattices;systems;magnetoresistance;antiferromagnet;interfaces
Physical Review B
The Hamiltonian for a four-sublattice Heisenberg ferrimagnet or ferromagnet with different exchange constants (J(ab) = J(cd) not equal J(bc) = J(da)) was established. An extended Bogoliubov transformation was developed by solving an equation group, consisting of 20 equations and 20 unknowns. The procedure for solving the equation group was carried out by introducing a simple way of reducing the numbers of the equations and the unknowns. The spin-wave spectra in the present system have been determined by performing the standard Holstein-Primakoff transformation and the Bogoliubov one. It has been found that the spin-wave spectra of the present system depend on the exchange constants and that the degeneracy of the spin-wave spectra remains. The results for a special case (J(ab) = J(bc)) i.e., an antiferromagnet are discussed briefly. The spin-wave spectra of the four-sublattice Heisenberg antiferromagnet are found to be degenerative also and they are linear in k for small k.
关键词:
model
金属学报
J积分的临界值J_(Ic)(张开型)目前被广泛用作中低强度钢的断裂准则.根据线弹性断裂力学理论和弹塑性断裂力学的实验规律,现提出一个新的J积分和应变能间的关系式:J=2/B(W-α)[U—U_o+(M~2ψ)/(BE′W~2)],其中ψ与跨距S/W和裂纹深度α/W有关·此式对于跨距和裂纹深度没有限制,因而作为弯曲试样的J积分计算公式,具有较为广泛的适用范围·当α/W=0时,J=0,从物理意义上看也比较合理,为了便利计算,并列出ψ值表,可以查找。
关键词:
