Journal of Materials Research
The morphology of the dark and bright regions observed by transmission electron microscopy for the Zr(64.13)Cu(15.75)Ni(10.12)Al(10) bulk metallic glass strongly depends on the ion beam parameters used for ion milling. This indicates that the ion beam could introduce surface fluctuation to metallic glasses during ion milling.
关键词:
room-temperature
Journal of Applied Physics
Based on the developed multiple-scattering theory [C.-W. Nan and F. S. Jin, Phys. Rev. B 48, 8578 (1993)], an effective-medium theory (EMT) is proposed to treat coupled electromechanical behavior in composite media. The explicit relations for determining effective behavior of piezoelectric composites are derived. To illustrate the technique, numerical results of piezoelectric ceramic/epoxy composites for various particle shapes are presented over the whole range of concentrations. The EMT estimates are shown to be in good agreement with available experimental results. Porous piezoelectric ceramics are also discussed. The EMT predicts a similar critical behavior for heterogeneous piezoelectric materials to recent experiments.
关键词:
electromechanical properties;ceramics
倪永中
,
徐鸿
材料科学与工程学报
本文提出了一种基于粒子群算法和有限元方法的弹塑性本构方程参数的确定方法,并在此基础上开发了参数自动优化系统CMPI(Constitutive Material Parameter Identification).通过使最小二乘形式的目标函数达到极小值,实现参数的动态寻优;模型参数作为粒子群优化模块的输入,采用应变(应力)控制方法,调用材料非线性有限元模块计算特定参数时的应力(应变)响应,并计算与实验数据的误差,从而实现优化过程.CMPI目前适用于A-F类模型(Chaboehe、Ohno-Wang、Jiang-Sehitoglu)的参数优化,以此为基础,不难扩展到其他材料模型.
关键词:
粒子群
,
材料非线性
,
有限元
,
Ohno-Wang 模型
Acta Materialia
In a first report [Jin ZH.. Gumbsch P, Ma E, Albe K, Lu K, Hahn H, et al. Scripta Mater 2006;54:1163], interactions between screw dislocation and coherent twin boundary (CTB) were studied via molecular dynamics simulations for three face-centered cubic (fcc) metals, Cu, Ni and Al. To complement those preliminary results, purely stress-driven interactions between 60 degrees non-screw lattice dislocation and CTB are considered in this paper. Depending on the material and the applied strain, slip has been observed to interact with the boundary in different ways. If a 60 degrees dislocation is forced by an external stress into a CTB, it dissociates into different partial dislocations gliding into the twin as well as along the twin boundary. A sessile dislocation lock may be generated at the CTB if the transited slip is incomplete. The details of the interaction are controlled by the material-dependent energy barriers for the formation of Shockley partial dislocations from the site where the lattice dislocation impinges upon the boundary. (c) 2007 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.
关键词:
dislocation;slip;twinning;twin grain boundary;molecular dynamics;molecular-dynamics simulation;grain-boundaries;nanocrystalline;materials;cross-slip;rate sensitivity;deformation;copper;strength;aluminum;fcc
张剑
,
周储伟
,
雷笑
,
叶见曙
,
卓家寿
复合材料学报
对于混杂CFRP/GFRP筋高性能混凝土(HPC)梁,研究一种新的三维非线性梁壳组合单元,对HPC梁进行了全过程分析.引入实体退化壳单元理论,利用空间梁单元模拟预应力CFRP筋,并根据CFRP筋单元节点线位移和转角位移的协调性,推导CFRP筋单元对梁壳组合单元刚度矩阵的贡献,同时对GFRP筋和HPC梁采用分层壳单元模拟.并运用Jiang屈服准则、Madrid强化准则等描述混凝土的材料非线性,提出一种新的非线性梁壳组合单元,研制相应的三维非线性计算程序.计算结果与试验数据吻合良好,说明本文构造的非线性梁壳组合单元的正确性和研制程序的可靠性,以及混凝土材料非线性描述的合理性;采用组合单元能准确模拟CFRP筋的几何构形,能综合考虑其拉压弯剪性能,利于全面地反映配筋对结构的增强作用.
关键词:
CFRP筋
,
GFRP筋
,
梁壳组合单元
,
HPC梁
,
材料非线性
曹春海
,
杨名
,
张世远
,
杨森祖
,
崔旭高
,
尤立星
,
吉争鸣
,
康琳
,
许伟伟
低温物理学报
doi:10.3969/j.issn.1000-3258.2003.03.002
采用Nd0.7Sr0.3MnO3/SrTiO3/YBa2Cu3O7-δ的异质结构,研究了自旋极化准粒子的注入效应.在56μm宽的YBCO膜条上成功地制备了与超导膜条同样宽度但不同长度的六个注入结区,长度L分别为80μm, 40μm, 20μm, 10μm, 5μm和2μm.80nm厚的YBCO薄膜在16K温度下Jc为2×105A/cm2.Iin=0.5mA的自旋电流注入下,随L从80μm逐渐顺次减小时,注入效率η=ΔJc/ΔJin逐渐增大.而当L≤20μm后,η不再增加,达到几乎相同的值(～6).初步分析认为这与自旋极化准粒子在超导膜内的有效自旋扩散长度有关.异质结构中YBCO薄膜的超导电性以及注入窗口的尺寸对获得大的自旋注入效率十分重要.
关键词:
注入效率
,
自旋准粒子
,
巨磁阻
,
异质材料
