CUI Juan
,
LIU Yazheng
,
PAN Hui
,
GAO Lifeng
钢铁研究学报(英文版)
The microsturctural transformation of austenite grain, pearlite interlamellar spacing, and lamellar cementite thickness of spring steel 60Si2MnA for railway were studied in the hotrolled and reheated states. Furthermore, the effect of microstructural characterization on its final mechanical properties was discussed. The results showed that as far as 60Si2MnA, the pearlite interlamellar spacing determined the hardness, whereas, the austenite grain determined the toughness. Compared with microstructure and mechanical properties in the hotrolled state, after reheating treatment at 950 ℃, its average grain sizes are apparently fine and the pearlite interlamellar spacing and lamellar cementite thickness coarsen to some extent, but both hardness and impact toughness increase to HRC 48 and 85 J, respectively. In the course of making spring, the optimum reheating austenitizing temperature for the 60Si2MnA steel is 950 ℃.
关键词:
austenitizing temperature;austenite grain;pearlite interlamellar spacing;hardness;toughness
ZHANG Chaolei
,
LIU Yazheng
,
JIANG Chao
,
XIAO Jinfu
钢铁研究学报(英文版)
Influence of vanadium and/or niobium additions on delayed fracture behavior in high strength spring steel was studied by hydrogen permeation method and slow strain rate technique (SSRT), and its mechanism was analyzed. The results show that apparent diffusion coefficient of hydrogen in microalloyed spring steels NbVsteel and Nbsteel is lower than that in nonmicroalloyed steel 60Si2MnA. Percentage of strength reduction in SSRT in air after precharged hydrogen of the microalloyed steels is smaller than that of 60Si2MnA. Addition of the microalloys changes the fracture characteristics. Thence, vanadium and/or niobium additions are a very effective and economy means to improve the hydrogeninduced delayed fracture resistance of high strength spring steel.
关键词:
spring steel
,
microalloy
,
hydrogeninduced delayed fracture
,
slow strain rate technique
,
hydrogen permeation
XU Jinqiao
,
LIU Yazheng
,
ZHOU Shumei
钢铁研究学报(英文版)
With the investigated subject of 82B rod, the interlamellar spacings of pearlite at different isothermal transformation temperatures and different cooling rates during continuous cooling transformation were measured, and the effect of the isothermal transformation temperature and cooling rate on the interlamellar spacing was analyzed quantitatively. Moreover, the relationship models between undercooling and interlamellar spacing were presented by data regression. The experimental results show that the relationship between undercooling and reciprocal interlamellar spacing remains linear when the undercooling is not very large, or else, the interlamellar spacing tends to be constant and the relationship will deviate from linearity.
关键词:
interlamellar spacing;calculation model;highspeed rod;82B
宋育来
,
陈吉清
,
陈邦文
,
刘静
,
刘志勇
,
胡敏
钢铁研究
研究了集装箱用SM490YA钢板的力学性能、工艺性能、微观组织结构等.采用气体保护焊对钢板进行焊接性能试验评价,并对钢的强韧化机理进行初步探讨.结果表明,SM490YA钢板不仅性能稳定,不存在明显的各向异性,易于成型,而且钢板焊接性能优良,是制造集装箱的理想钢板.
关键词:
集装箱钢
,
力学性能
,
工艺性能
,
焊接性能
,
微观组织
林元华
,
张中太
,
张枫
,
唐子龙
,
吕霄
,
郑子山
功能材料
利用SrCO3-A12O3-RE(NO3)3(RE:Eu,Dy)粉体为原料,加入少量酒精,进行预混合、球磨、干燥.将此混合粉体在还原气氛下高温烧成,最终制得不同发光性能的xSrO.yAl2O3:RE(RE:Eu,Dy)光致发光材料,并对其性能进行了研究.发光粉体的发射光谱表明,随着A12O3/SrO(摩尔比x)的增加,其相应粉体发射光谱的主峰位置(λE)逐渐向短波方向移动,符合λE=531.018-23.028X关系式.余辉衰减曲线表明,这些发光材料均具有一定的长余辉特性.从而说明只要控制一定的Al2O3/SrO比例,即可获得发光颜色为紫色到绿色的多种发光材料.对于其长余辉机制,认为是加入的Dy3+起到了陷阱能级的作用,它将部分空穴俘获,并在热扰动下,慢慢将空穴释放出来,并再次与介稳态Eu1+复合发光,从而达到延长余辉的作用.
关键词:
长余辉
,
发光材料
,
发射光谱
,
空穴
胡海龙
,
曾宇平
,
左开慧
,
夏咏锋
,
姚冬旭
无机材料学报
doi:10.15541/jim20140181
分别以Y2O3-Al2O3(YA)和Y2O3-MgO(YM)为烧结助剂，采用气压烧结工艺制备了Si3N4/SiC陶瓷，研究了两种不同的烧结助剂对陶瓷的力学和摩擦性能的影响。研究结果表明：添加不同种类的烧结助剂对制备陶瓷的相对密度、抗弯强度、断裂韧性、硬度、摩擦系数和磨损率影响很大；与添加烧结助剂YM相比较，添加烧结助剂YA的Si3N4/SiC陶瓷在烧结过程中表现出了更好的烧结性能，得到的陶瓷样品最终显示了更好的力学和摩擦性能，尤其是SiC添加量为20wt%的Si3N4/SiC陶瓷。这主要归因于烧结助剂YA的添加使Si3N4/SiC陶瓷呈现出了更高的相对密度，获得的晶粒长径比更小。
关键词:
Si3N4/SiC陶瓷
,
烧结助剂
,
抗弯强度
,
摩擦性能
