材料期刊网

Microstructure and properties of joint for stirring brazing of dissimilar Al/Mg alloy during heating processes

Hui-Bin Xu , Hui-Bin Sun , Hui Yang , Lu-Xin Chi , Jun Chen

稀有金属（英文版） doi:10.1007/s12598-014-0391-3

关键词:

Studies of the anion position parameter chi of the ternary semiconductor CuGaS2 by use of Ni+ ion probe

Materials Science and Engineering B-Solid State Materials for Advanced Technology

The anion position parameter chi of NiS4 cluster formed in the ternary semiconductor CuGaS2 by substitution of Ni+ for Cu+ has been determined by studying the optical spectra and EPR data for CuGaS2:Ni+. The result (chi approximate to 0.263(1)) is consistent with the mean value of the X-ray measurement results reported in two groups of references and also with the calculated value obtained from the conservation of tetrahedral bonds (CTB) plus eta = eta(tet) rule (where eta = c/2a). So, we suggest that the anion position parameter chi in pure CuGaS2 crystal is close to the above value obtained by use of Ni+ ion probe. The optical absorption bands and g factors g(parallel to), g(perpendicular to), of CuGaS2: Ni+ are therefore explained reasonably from the anion position parameter. (C) 2003 Elsevier B.V. All rights reserved.

关键词: structural parameter;electron paramagnetic resonance (EPR);optical;spectrum crystal-field theory;CuGaS2;Ni+;chalcopyrite semiconductors;superposition model;crystal

ACRT-B法生长的MnxCd1-xIn2Te4晶体的溶质分凝特性

常永勤 , 介万奇 , 郭喜平 , 陈福义 , 安卫军

功能材料

研究了ACRT-B法生长的Mn0.1Cd0.9In2Te4晶体中界面的形状和各组元沿轴向的分布规律及其分凝因数.发现结晶界面为椭球形;采用理想配比生长MnxCd1-xIn2Te4晶体,其4种组元并不按(Mn,Cd):In:Te=1:2:4比例结晶,而是要重新分布;通过数学方法处理实验数据得到Mn,Cd和In的分凝因数在α相区分别为1.286、1.9257和0.7294,在β相区则分别为1.12、1.055和0.985.

关键词: ACRT-B法 , MnxCd1-x In2Te4 , 界面 , 分凝因数

Bridgman法生长的Mn_xCd_1-xIn₂Te₄晶体相形成规律和物理性能研究

常永勤 , 安卫军 , 郭喜平 , 介万奇

无机材料学报

采用Bridgman法生长了x为0.1,0.22和0.4的四元稀磁半导体化合物Mn_xCd_1-xIn₂Te₄晶体.研究了三根晶体中相的形貌、结构、成分和Mn_0.1Cd_0.9In₂Te₄晶体中各组元沿轴向和径向的成分分布.晶体生长初始端的组织为α+β+β₁,随着生长的进行,形成β相的单相区.在晶锭末端,形成In₂Te₃类面心立方结构化合物.组分x增大后,Mn_xCd_1-xIn₂Te₄晶体的吸收边向短波方向移动,禁带宽度则线性增大.磁化率测量结果表明:晶体在高温区的x^-1-T曲线服从居里-外斯定律,在低温区(<50K)则表现出顺磁增强现象.

关键词: Mn_xCd_1-xIn₂T_e4 , compositional distribution , infrared transmission spectra , mag- netic susceptibility

Bridgman法生长的MnxCd1-xIn2Te4晶体相形成规律和物理性能研究

常永勤 , 安卫军 , 郭喜平 , 介万奇

无机材料学报 doi:10.3321/j.issn:1000-324X.2003.02.004

采用Bridgman法生长了x为0.1,0.22和0.4的四元稀磁半导体化合物MnxCd1-xIn2Te4晶体.研究了三根晶体中相的形貌、结构、成分和Mno.1Cd0.9In2Te4晶体中各组元沿轴向和径向的成分分布.晶体生长初始端的组织为α+β+β1,随着生长的进行,形成β相的单相区.在晶锭末端,形成In2Te3类面心立方结构化合物.组分x增大后,MnxCd1-xIn2Te4晶体的吸收边向短波方向移动,禁带宽度则线性增大.磁化率测量结果表明:晶体在高温区的x-1-T曲线服从居里一外斯定律,在低温区(＜50K)则表现出顺磁增强现象.

关键词: MnxCd1-xIn2Te4 , 成分偏析 , 红外透射光谱 , 磁化率

Lu-Si-O体系在高温水蒸气环境中的腐蚀行为

洪智亮 , 成来飞 , 鲁琳静 , 张立同 , 王一光

无机材料学报 doi:10.3724/SP.J.1077.2010.00186

采用溶胶-凝胶法制得三种镥硅酸盐体系粉体材料. 以氧化物的摩尔比来表示此三种粉体, 分别为：Lu₂O₃·SiO₂、Lu₂O₃·2SiO₂和Lu₂O₃·2.26SiO₂. 在1400℃、50%H₂O-50%O₂静态常压气氛下, 研究了它们的耐水蒸气腐蚀性能.以单位面积重量变化率表征材料的耐水蒸气腐蚀性能, 结合X射线衍射（XRD）、傅里叶红外光谱（FTIR）和扫描电镜能谱分析（SEMEDS）等分析手段, 揭示了镥硅酸盐体系在高温水蒸气环境中的腐蚀机制和反应机理. 结果表明：三种原始粉体主要物相依次为：Lu₂SiO₅+Lu₂Si₂O₇、 Lu₂Si₂O₇+SiO₂和Lu₂Si₂O₇+SiO₂. 在水蒸气作用下, Lu₂SiO₅相与Al₂O₃反应生成新相Lu₃Al₅O₁₂, 而Lu₂Si₂O₇相并未受到水蒸气的作用而发生任何反应, 表现出优异的化学稳定性.

关键词: Lu₂SiO₅ , Lu₂Si₂O₇ , environmental barrier coating (EBC) , water vapor corrosion

Lu-Si-O体系在高温水蒸气环境中的腐蚀行为

洪智亮 , 成来飞 , 鲁琳静 , 张立同 , 王一光

无机材料学报 doi:10.3724/SP.J.1077.2010.00186

采用溶胶-凝胶法制得三种镥硅酸盐体系粉体材料.以氧化物的摩尔比来表示此三种粉体,分别为:Lu_2O_3·SiO_2、Lu_2O_3·2SiO_2和Lu_2O_3·2.26SiO_2.在1400℃、50%H_2O-50%O_2静态常压气氛下,研究了它们的耐水蒸气腐蚀性能.以单位面积重量变化率表征材料的耐水蒸气腐蚀性能,结合X射线衍射(XRD)、傅里叶红外光谱(FTIR)和扫描电镜能谱分析(SEM-EDS)等分析手段,揭示了镥硅酸盐体系在高温水蒸气环境中的腐蚀机制和反应机理.结果表明:三种原始粉体主要物相依次为:Lu_2SiO_5+Lu_2Si_2O_7、Lu_2Si_2O_7+SiO_2和Lu_2Si_2o_7+SiO_2.在水蒸气作用下,Lu_2SiO_5相与Al_2O_3反应生成新相Lu_3Al_5O_(12)而Lu_2Si_2O_7相并未受到水蒸气的作用而发生任何反应,表现出优异的化学稳定性.

关键词: Lu_2SiO_5 , Lu_2Si_2O_7 , 环境障碍涂层 , 水蒸气腐蚀

Lu2O3和Lu2O3∶Eu3+单分散球形粉体合成及其荧光性能研究

马畅 , 李晓东 , 董宇 , 刘绍宏 , 朱琦 , 李继光 , 霍地 , 孙旭东

中国稀土学报 doi:10.11785/S1000-4343.20130411

以Lu(NO3)3和尿素为原料,采用均相沉淀法合成镥盐前驱体,研究Lu3+浓度、尿素/Lu3+摩尔比R对前驱体形貌的影响.结果表明,在反应温度为95℃时,低Lu3+浓度有利于单分散球形粉体的合成,并且适当的调整R值可将单分散球形颗粒尺寸控制在180 ～ 270 nm之间.在此基础之上,研究Eu3+掺杂Lu2O3单分散球形荧光粉体的合成,探讨了Eu3+的掺杂量(1％,3％,5％,7％,9％(原子分数))及煅烧温度(600～ 1200℃)对颗粒形貌及其荧光性能的影响.结果表明,Eu3+的掺杂使所得(Lu,Eu)盐前驱体颗粒尺寸远小于单纯的Lu盐前驱体,且Eu含量对荧光粉的荧光强度有着显著的影响,荧光淬灭浓度为5％.在考察的煅烧温度范围内,荧光粉的荧光强度随煅烧温度的提升而增强.

关键词: Lu2O3 , Eu3+ , 均相沉淀 , 单分散球形 , 前驱体 , 荧光性能 , 稀土

TEMPERATURE-DEPENDENCE OF THE MAGNETIC-PROPERTIES OF THE RARE-EARTH TRANSITION-METAL INTERMETALLIC LU2FE14C

Journal of Magnetism and Magnetic Materials

Magnetization curves of the ternary tetragonal compound Lu2Fe14C were measured in an extracting-sample magnetometer in the temperature range from 1.5 to 300 K. The temperature dependence of the magnetic properties of Lu2Fe14C is discussed.

关键词: anisotropy

Effects of Phase Composition on Microstructure and Mechanical Properties of Lu₂O₃-doped Porous Silicon Nitride Ceramics

Quan Li

材料科学技术（英文）

Porous silicon nitride ceramics (Si₃N₄) were fabricated by pressureless sintering using different particle size of silicon nitride powder. Lu₂O₃ was used as sintering additive. According to phase relationships in the ternary system Si₃N₄-SiO₂-Lu₂O₃, porous Si₃N₄ ceramics with different phase composition were designed through the change of the content of SiO₂ which was formed by the oxidation at 800°C in air. Porous Si₃N₄ with different phase compositions was obtained after sintering at 1800°C in N₂ atmosphere. A small content of SiO₂ favored the formation of secondary phase Lu₄Si₂O₇N₂, while large content of SiO₂ favored the formation of secondary phase Lu₂Si₂O₇ and Si₂N₂O. Porous Si3N4 ceramics with secondary phase Lu₄Si₂O₇N₂ had a flexural strength of 207 MPa, while that with secondary phase Si₂N₂O and Lu₂Si₂O₇ had lower flexural strength.

关键词: Porous silicon nitride ceramics