M Liu
,
XM Zhang
,
M.Z. Liu
,
X.M. Mengand Y Y Li(Institute of Metal Research
,
Chinese Academy of Sciences
,
Shenyang 110015
,
China)(Metal Material Department
,
Sichuan Union University
,
Chengdu 610065
,
China)
金属学报(英文版)
In this paper by means of TEM and HREM, we found that the presence of r-phase plays the most important role in enabling two way shape memory effect (TWME) to be obtained by the stabilization of stress induced martensite variants (SSIM). This idea is different from the traditional suggestion that strain fields developed by dislocation produced TWME. With prolonged isothermal ageing time, the bainitic tronsforma-tion product α1 precipitated, the amount of γ-phase increased, while the martensite was retained and became less ondered. These factors all reduced TWME. During age-ing, the stacking faults in bainitic product α1 disappeared, which indicated that the bainitic product α1 is a sub-equilibrium phase. The interfaces of α-plates also lost straightness step by step, some plates twisted, bronched and overlapped. Its formation is irreversible in tnorphology and reduces the quantities of martensite. Although the precipitation of r may stabilize some martensite or oppose its growth,α may hinder nucleation of martensite. Thus, it was considered that α-plates were the worst de- stroyed element. These suggestions agreed well with our performance test results in that the transformation temperntures and the amount of TWME changed in the same way with prolonged ageing, firstly increasing and then decreasing after reaching an optimal maximum value.
关键词:
precipitate
,
null
,
null
,
null
M Liu
,
X.M Zhang
,
M.Z. Liuand R.S. Liu(Metal Material Department
,
Sichuan Union University
,
Chengdu 610065
,
China) (Institute of Metal Research
,
Chinese Academy of Sciences
,
Shenyang 110015
,
China)
金属学报(英文版)
In this paper, an in situ metallographic video system was used to study the morphology in Cu-Zn-Al shape memory alloy (SMA) during thermal cycling phase tmnsforma-tion. There are seven different types of martensite morphology in Cu-Zn-Al SMA,i.e. plate, spean bamboo, noose, round-spot, line and dot-like martensites. During transformation and inverse-transformation, the thermoelastic martensites were rising and falling, growing and shrinking, splitting and merping. The growth patterns of thermoelastic martensite were divided into three types: fast growing, very slow ex-pansion and uniform automatic growth. Automatic growth appeared when ageing at a temperature below Ms. The result, for the first time, coofirmed Olson and Cohen,s suggestion that thermoelastic martensite may be automatically grown when ageing be-low Ms. With increasing numbers of thermal cycling, both the memory recovery ratio (% )and memory recoverp degradation (%) degraded logarithmically. The degrada-tion was steep in the initial stage and then became more and more gradual in the middle and the final stages caused by the stabilisation of martensite. In the initial stage, vacancies assumed the controlling role, while dislocations took the major role in other stages. The martensite transformation caused the intedeces to become bent and blurmd, but with increasing cycling numbers, the movements of interface had the same degradation effects as the memory recovery ratio curves. Under these conditions, we also found the martensites on one side of the intedece became reorientated and par-allel to the intedece. It was therefore concluded that the movement degradation of the interface and the appearance of bamboo like martensite induced the degradation of two way shape memory effect (TWMP).
关键词:
in situ metallographic video study
,
null
,
null
,
null
刘勤
,
周善佑
材料研究学报
超塑性m-δ关系曲线可以分为m_L=m_(max)和m_L=m_(min)两大类型。均可由下面的C.L.(刘勤)m-σ方程表示:σ(%)=〔cε~(m-m_0)-1〕×100当σ=σ_0=0时,m=m_0≠0,C=C_0=κ_0/κ_0=1。当σ=σ_1(σ_(11),σ_(12),σ_(13),…,)时,m=m_1(m_(11),m_(12),m_(13),…),C=C_1(C_(11),C_(12),C_(13),…)=κ_1(κ_(11),κ_(12),κ_(13),…)/κ_0,当σ=σ_F时,m=m_F,C=C_F=κ_F/κ_0。对C 值进行“规划”,得到的C_1~(σ_O-σ_L)-(m_L=m_(max)),C_2~(σ_F-σ_L)-(m_L=m_(min)),C_3~(m_0-m_L)-(m_L=m_(max)和C_4~(m_F-m_L)-(m_L=m_(min))四种类型的“规划”方程分别对m_L=m_(max)和m_L=m_(min)型m-σ曲线适用。若m-σ曲线属简单的下降式,C 及其“规划”值均可近似地取1。否则,C-σ关系是应加以研究的问题。m 和k 值对σ值的效应可以分为动态(直接)和静态(间接)两种。最后的σ值是两种效应的综合结果。(注:m 和κ值见基本方程σ=κε~m)
关键词:
齐召庆
,
汪宏涛
,
薛明
功能材料
doi:10.3969/j.issn.1001-9731.2016.02.010
采用改进的非接触式混凝土收缩测定仪及标靶,研究了m(M)/m(P)比值(MgO与KH2PO4的质量比)对磷酸镁水泥石自收缩行为的影响,运用八通道微量量热仪、压汞仪、X射线衍射仪、扫描电子显微镜及能谱仪等分析手段,分析了m(M)/m(P)比值对磷酸镁水泥石自收缩的作用机理.结果表明,磷酸镁水泥石的自收缩呈现出3个阶段的特征,即早期的迅速收缩阶段、微膨胀阶段、收缩缓慢发展阶段.随着m(M)/m(P)比值的增大,由于磷酸镁水泥石的水化放热量降低,水泥石内部孔隙率增大,水化产物结晶度降低,水泥石结构疏松,所以,自收缩率减小.
关键词:
磷酸镁水泥
,
自收缩
,
m(M)/m(P)比值
Tesshu Miyahara
材料科学技术（英文）
Magnetic stripe is one of the major applications of magnetic materials. As a key component of the present card technologies magnetic stripes play reliable components for electronic data interchange in worldwide electronic payment systems such as financial cards, transit tickets and phone cards, etc. Magnetic stripes are available in various coercivity materials, widths, lengths, structures and colors with each types of transferable, lamination and pressure sensitive magnetic tapes of Deuton-M. Manufacturing process, structure and characteristics of Deuton-M magnetic tape and sheet are described.
关键词:
卞进田
,
孙晓泉
,
聂劲松
量子电子学报
doi:10.3969/j.issn.1007-5461.2008.02.019
为了得到2.7 μm波段可调谐激光辐射,设计了信号光单谐振荡KTP光参量振荡器(OPO),给出了KTP OPO II(B)类相位匹配方式下的角度调谐曲线、有效非线性系数.KTP晶体切割角为θ=62°,ψ=0°,有效非线性系数为-2.97 pm/V.利用该KTP OPO实现了2.6～2.8 μm波段范围可调谐激光输出,用脉宽为16 ns的基模高斯光束1.064 μm激光泵浦得到了最大能量578 μJ,能量转换效率达1.7%.
关键词:
非线性光学
,
可调谐红外激光
,
单谐振光参量振荡器
,
KTP
,
角度调谐
,
相位匹配
Journal of Physics-Condensed Matter
We investigated the stable (0001) surfaces of M(2)AlC (M = Ti, V and Cr) using the first-principles plane-wave pseudopotential total energy method. Four possible (0001) terminations were considered by breaking the M-Al and M-C bonds. The corresponding surface energies were calculated and compared. The Al-and M(C)-terminated (0001) surfaces demonstrated better stability than the C- and M(Al)-terminated surfaces by their much lower surface energies. In addition, the stability of surfaces was predicted under various chemical environments as a function of chemical potentials. We further investigated the character of surface relaxations. The electronic structures of the stable Al- and M(C)-terminated surfaces were analyzed.
关键词:
ab-initio calculations;ti3sic2 thin-films;electronic-structure;elastic stiffness;al;deposition;cr2alc;simulation;adhesion;solids
