MA Li-feng
,
WANG Jian-mei
,
HUANG Qing-xue
,
SHUANG Yuan-hua
钢铁研究学报(英文版)
The calculation results show that relative cut-in depth at the moment of maximum shearing force decreases with the increase of steel plate thickness; along with blade clearance increasing, shearing force would increase slightly compared with the slide pressure of blade carrier; shearing force increases significantly with the increasing blunt end radius; shearing force displays a bit decrement with the decreasing platen force, while the pressure on slide plate of blade carrier increases substantially; shearing force increases a bit with the increasing shear velocity and decreases when nip angle increases while the horizontal component force of shearing force along the direction of plate width increases rapidly. The above results have important reference and actual using value for studying calculation of mechanical parameters of rolling shear and its structural design.
关键词:
rolling shear
,
shearing force
,
numerical simulation
,
impact analysis
马乾志
,
郭杨龙
,
王艳芹
,
郭耘
,
张志刚
,
卢冠忠
无机材料学报
doi:10.3321/j.issn:1000-324x.2007.05.033
采用TS-1前驱体作硅源和钛源,以十二胺为模板剂,在中性和室温条件下合成了介孔含钛分子筛Ti-HMS-1.采用XRD、TEM、低温N2吸附、FT-IR和UV-Vis等方法对合成的分子筛进行了表征;以苯乙烯的催化氧化反应为模型反应,考察了合成的Ti-HMS-1的催化氧化性能.结果表明,Ti-HMS-1具有"worm-like"介孔结构,但长程有序度较低,孔壁部分含有MFI的次级结构单元,在373K沸水中水煮50h后,Ti-HMS-1仍能较好地保持原有的介孔结构,表明Ti-HMS-1具有较高的水热稳定性.进入分子筛骨架的钛原子为催化剂的活性中心,对于苯乙烯氧化反应,具有较高的催化活性,对产物的选择性与Ti-HMS接近.
关键词:
Ti-HMS-1分子筛
,
合成
,
表征
,
苯乙烯氧化
刘守平
,
周上祺
,
王佳眉
,
任勤
腐蚀学报（英文）
用金相显微镜、扫描电镜、X射线衍射仪和X射线能谱仪对天然气井油管悬挂器腐蚀失效进行了检测分析，并对天然气井油管悬挂器用35CrMo钢进行了盐雾试验，结果表明，天然气中的水和CO2是引起腐蚀的主要介质，腐蚀产物主要是FeCO3，高速天然气冲刷和钢中的非金属夹杂加剧了腐蚀的速度.
CORROSION FAILURE ANALYSIS OF AN OIL TUBE USED IN NATURAL GAS WELL
LIU Shou-ping,ZHOU Shang-qi,WANG Jia-mei,REN Qin
Chongqing University
A failed oil tube used in natural gas well was examined by optical microscope,scanning electron microscope ,X-ray diffractometer and X-ray spectrometer.Corrosion behavior of 35CrMo steel samples of the oil tube were investigated by means of salt spray tests in the laboratory.The results show that CO2 and H2O are primary factors in the corrosion of oil tube.The corrosion product is FeCO3,non-metallic inclusions in the steel and erosion of natural gas fluid played an important role in accelerating the corrosion.
oil tube;
natural gas well；
35CrMo steel；
failure analysis；
corrosion
关键词:
悬挂器
,
null
,
null
,
null
Journal of Materials Research
The morphology of the dark and bright regions observed by transmission electron microscopy for the Zr(64.13)Cu(15.75)Ni(10.12)Al(10) bulk metallic glass strongly depends on the ion beam parameters used for ion milling. This indicates that the ion beam could introduce surface fluctuation to metallic glasses during ion milling.
关键词:
room-temperature
Journal of Chemical Physics
Based on Mei's embedded atom model [Mei , Phys. Rev. B 43, 4653 (1991)] molecular dynamics simulations have been performed to investigate the rapidly cooling processes of Cu. The atomic transport property, namely the self-diffusion coefficient, is computed in the liquid state, and the results near the melting point of Cu are in good agreement with experimental data and other computational values. The atom diffusion movements during the long period of relaxation have been also studied around the solidification temperature T-c. To describe the complex microstructural evolutions during the rapidly cooling processes and the long relaxation processes, the pair correlation function and the pair analysis technique are used. It is demonstrated that the crystallization of amorphous Cu is caused by the atomic diffusion. (C) 2004 American Institute of Physics.
关键词:
transition-metals;computer-simulation;supercooled-liquid;model;fcc;potentials;diffusion
徐菊良
,
邓博
,
孙涛
,
李劲
,
蒋益明
金属学报
doi:10.3724/SP.J.1037.2009.00598
利用Thermo-Calc软件并结合金相显微镜,定性研究了2205双相不锈钢在800℃下敏化不同时间后的微观组织演变过程.通过研究扫描速率、介质成分、介质温度和试样表面状态优化了双环电化学动电位再活化法(DL-EPR),并用该优化方法研究了2205双相不锈钢晶间腐蚀敏感性.结果表明:DL-EPR法能定量评价σ相对2205双相不锈钢晶间腐蚀敏感性的影响,随敏化时间延长,σ相含量增多,晶jian 腐蚀敏感性也随之增加.腐蚀形貌的观测验证了这一规律,
关键词:
2205双相不锈钢
,
DL-EPR
,
晶间腐蚀敏感性
,
σ相
材料科学技术（英文）
The effect of interstitial hydrogen on the cohesion of the Al Sigma=11(113) grain boundary (GB) is investigated based on the thermodynamic model of Rice-Wang using the first-principles density function calculation. The results indicate that interstitial H behaves as an embrittler from "strengthening energy" analysis. The reduced GB cohesion due to the presence of H at the GB is attributed to the low affinity between H and Al, and the weakened bonding of Al atomic pairs perpendicular to GB plane.
关键词:
hydrogen;grain boundary;Al-Mg alloys;pseudopotentials;1st-principles
Xiaoguang LIU
,
Xiaowei WANG
材料科学技术（英文）
The effect of interstitial hydrogen on the cohesion of the Al ∑=11(113) grain boundary (GB) is investigated based on the thermodynamic model of Rice-Wang using the first-principles density function calculation. The results indicate that interstitial H behaves as an embrittler from "strengthening energy" analysis. The reduced GB cohesion due to the presence of H at the GB is attributed to the low affinity between H and Al, and the weakened bonding of Al atomic pairs perpendicular to GB plane.
关键词:
Hydrogen
,
null
,
null
