TIAN Yong
,
GUO Yanhui
,
WANG Zhaodong
,
WANG Guodong
钢铁研究学报(英文版)
The plane strain asymmetrical rolling was analyzed using slab method. The contact arc was replaced by parabola, and the constant surface friction status was adopted during the analysis. The deformation area was divided into three zones according to the direction of the friction. Then, the three zones were studied, respectively. A rolling force model and a rolling torque model were developed based on the analysis, and they were used to analyze the influence of asymmetrical rolling factors on deformation area and unit pressure if they had good precision which was determined by comparing the calculated results with the measured ones.
关键词:
asymmetrical rolling;slab method;asymmetrical factor;specific pressure distribution
GUO Yanhui
,
WANG Zhaodong
,
ZOU Wenwen
,
LIU Xianghua
,
WANG Guodong
钢铁研究学报(英文版)
The texture evolution in a high strength TiIF steel during the processing of hot rolling, cold rolling, and annealing is studied. For comparison, both ferrite rolling and austenite rolling are employed. It is found that the texture type is the same after ferrite rolling and austenite rolling, but the texture intensity is much higher in the ferrite rolled sample. Furthermore, texture characteristics at the surface are absolutely different from those at the midsection in both ferrite rolled and austenite rolled samples, as well as under the cold rolled and annealed conditions. The shear texture {110}<001> disappears and orientation rotates along {110}<001>→{554}<225>→{111}<112>→{111}<110>→{223}<110> during cold rolling. Compared to the austenite rolled sample, the properties of the cold rolled and annealed sheet which is subjected to ferrite rolling are higher.
关键词:
high strength TiIF steel;ferrite rolling;austenite rolling;texture
WANG Zhaodong
,
GUO Yanhui
,
ZHAO Zhong
,
LIU Xianghua
,
WANG Guodong
钢铁研究学报(英文版)
The processing conditions of the texture formation and deep drawability of a TiIF steel strip hotrolled in ferritic region and subsequently annealed were investigated. The rvalue increases with the decrease of reheating temperature, and finish rolling temperature and the increase of reductions in ferritic region. For lubricated ferritic rolling and annealing, the rvalue is raised up to 175, and elongation rate is over 50% at the finish rolling temperature of 650 ℃, which is suitable for DDQ grade products. However, the rvalue is below 10 in the case of unlubricated rolling. The Xray diffraction was used to analyze the textural characteristic of samples. For samples subjected to lubricated rolling and annealing, the strong {111}∥ND recrystallization texture is distributed homogeneously along the thickness direction, and the intensity of {110} recrystallization texture is very low even in surface. However, for unlubricated samples, the {111} texture is distributed inhomogeneously and is weak along the thickness direction, and {110}∥ND recrystallization texture is strong, which deteriorates the formability.
关键词:
IF steel;ferritic rolling;annealing;deep drawability;texture
WANG Bingxing
,
CHEN Xiaolin
,
TIAN Yong
,
WANG Zhaodong
,
WANG Jun
,
ZHANG Dianhua
钢铁研究学报(英文版)
The healthy and rapid development of the controlled cooling technology was hampered by the uneven cooling phenomenon. During the process of hot plate production, the homogeneous cooling along the length direction of plate was constrained by lots of factors. And because the speed was a flexible control parameter, the calculation method of optimal speed profile was developed based on the measured start cooling temperature and its matrix equation was solved by the Cholesky decomposition method. The optimal speed profile was used in online control system. As a result, the temperature distribution along the plate length direction was relatively uniform, and 95% of measured final cooling temperature difference from the target temperature 700 ℃ was controlled within ±20 ℃.
关键词:
plate
,
controlled cooling
,
homogeneous cooling
,
speed profile
,
Cholesky decomposition method
Journal of Materials Research
The morphology of the dark and bright regions observed by transmission electron microscopy for the Zr(64.13)Cu(15.75)Ni(10.12)Al(10) bulk metallic glass strongly depends on the ion beam parameters used for ion milling. This indicates that the ion beam could introduce surface fluctuation to metallic glasses during ion milling.
关键词:
room-temperature
Physical Review B
In a recent publication [S. Dong et al., Phys. Rev. Lett. 103, 127201 (2009)], two (related) mechanisms were proposed to understand the intrinsic exchange bias present in oxides heterostructures involving G-type antiferromagnetic perovskites. The first mechanism is driven by the Dzyaloshinskii-Moriya interaction, which is a spin-orbit coupling effect. The second is induced by the ferroelectric polarization, and it is only active in heterostructures involving multiferroics. Using the SrRuO(3)/SrMnO(3) superlattice as a model system, density-functional calculations are here performed to verify the two proposals. This proof-of-principle calculation provides convincing evidence that qualitatively supports both proposals.
关键词:
thin-films;weak ferromagnetism;superlattices;anisotropy;bifeo3;srruo3;model
中国腐蚀与防护学报
N。1Atmospheric Corrosivlty for Steels………………………………………………… .LIANG Caideng HO[I i。-tat（6）Caustic Stress Corrosion Cr。king of Alloy 800 Part 2.The Effect of Thiosul执e……………………………………… KONG De-sheng YANG Wu ZHAO Guo-zheng HUANG De.ltL。ZHANG Yu。。he CHEN She。g-bac（13）SERS slid E16CttOCh6iniC81 Stlldy Of Illhibit1Oli M6ch＆tllsth Of ThlollY68 Oil ITOll ID H....
关键词:
Europhysics Letters
Noncollinear magnetic investigations of the ground state in PrFeAsO have been performed by the density-functional theory. We calculated the total energy and made structure optimization, and the electronic density of states of PrFeAsO was analyzed. There are three different magnetic structures in PrFeAsO defined by experiments. Based on these magnetic structures, we studied four collinear and four noncollinear cases. The ground state is found to take the ordering proposed by Zhao, in which the FeAs plane is of stripe antiferromagnetism and Pr spins are perpendicular to Fe spins. The electronic density of states indicates that for PrFeAsO the increase of the electron Coulomb interaction leads to a decrease in conductivity. Copyright (C) EPLA, 2011
关键词:
high-temperature superconductivity;phase-diagram;oxypnictides;instability
材料科学技术（英文）
The effect of interstitial hydrogen on the cohesion of the Al Sigma=11(113) grain boundary (GB) is investigated based on the thermodynamic model of Rice-Wang using the first-principles density function calculation. The results indicate that interstitial H behaves as an embrittler from "strengthening energy" analysis. The reduced GB cohesion due to the presence of H at the GB is attributed to the low affinity between H and Al, and the weakened bonding of Al atomic pairs perpendicular to GB plane.
关键词:
hydrogen;grain boundary;Al-Mg alloys;pseudopotentials;1st-principles
